We make full use of CAE mold flow analysis techniques, simulation and optimization of mold runner system design, improve part quality and reduce the number of test mode and unnecessary waste.
我们充分利用CAE模流分析技术，模拟和优化模具浇道系统设计，提高零件的质量和减少试模次数及不必要的浪费。
Present the basic similarity simulation principle followed in cold simulation of power plant boiler dynamic field, way of calculating test control parameters and associated measuring techniques.
介绍了电站锅炉空气动力场的冷态模化的基本相似模化原理、试验控制参数的计算方法及相关的测量技术。
At the same time, the substantiating test techniques have been described, especially the analog simulation test technique, sub-critical flutter test, closed-loop test, etc.
同时，还介绍了几种试验验证技术，主要是模拟仿真试验技术、亚临界颤振试验、闭环系统试验等。
Three main methods, site measurement, wind tunnel test and numerical simulation techniques are commonly used for the study of wind-induced interference effects on buildings.
目前研究建筑物风致干扰效应的主要方法有现场实测，风洞模型试验和数值模拟计算三种方法。
By the aid of dimension-less calculation techniques the simulation test is done and the formulae in the paper are checked.
并采用无量纲计算技术，进行了模拟实验，验证了文中各公式。
A real time simulation test-bed for vision-based autonomous landing of Unmanned Combat Aerial Vehicles (UCAVs) was proposed, which can verify key techniques involved in autonomous landing.
论述了无人作战飞机自主着陆研究中所涉及到的关键技术，并设计和建立了“基于视觉的无人作战飞机自主着陆实时仿真验证平台”。
A real time simulation test-bed for vision-based autonomous landing of Unmanned Combat Aerial Vehicles (UCAVs) was proposed, which can verify key techniques involved in autonomous landing.
论述了无人作战飞机自主着陆研究中所涉及到的关键技术，并设计和建立了“基于视觉的无人作战飞机自主着陆实时仿真验证平台”。
应用推荐