Room temperature deformation can accelerate boronizing dynamic process.
室温形变可使渗硼的动力学过程加速。
On this basis, variation law of AZ31 tensile strength at room temperature was studied after the once deformation and twice deformation.
在此基础上，研究AZ31镁合金在一次变形和二次变形后的常温抗拉强度的变化规律。
The plastic deformation which is changed with time slowly is named room temperature creep.
这个变形是随时间而缓慢变化的，这个缓慢变化的塑性变形就是蠕变变形。
The variation law of AZ31 tensile strength at room temperature was studied after the once deformation and twice deformation.
研究了AZ31镁合金在一次变形和二次变形后的常温抗拉强度的变化规律。
The deformation law of both solid and local upsetting processes for cylinder forging is investigated by moire method at room temperature and numerical simulation in this paper.
本文用常温云纹法与数值模拟法研究了筒体锻件整体镦粗与局部镦粗工艺的变形规律，得到了整体镦粗工艺的坯料尺寸图。
The influence of peak ratchetting stress on ratchetting deformation of this alloy is investigated based on uniaxial ratchetting tests of T225NG titanium alloy at room temperature.
基于T225NG钛合金的单轴常温棘轮试验，本文研究了峰值棘轮应力对T225NG钛合金棘轮应变的影响。
Due to the effect of strain hardening, higher amount of cold deformation resulted in superior room temperature strength and inferior torsion ductility.
由于加工硬化效应的影响，随着冷拔变形量的增加，合金丝材的室温强度增加，扭转塑性下降。
Deformation twinning of cast magnesium alloy AM60 was investigated by compression at room temperature with various deformation degrees from 3.
在电子万能试验机上对铸态am 60镁合金进行室温压缩试验，研究了在变形量分别为3。
The influences of deformation rate on the mechanical properties of 304 austenitic stainless steel were studied by tensile test at room temperature.
采用室温拉伸实验研究了不同变形速度对304奥氏体不锈钢力学性能的影响规律。
The effect of room temperature Pre-deformation on cyanide hardening proces was studied.
本文探讨了室温予变形对氰化过程的影响。
Generally, it is difficult to spin titanium alloy at room temperature, because of its high deformation resistance and yield to tensile ratio.
钛合金的变形抗力和屈强比较大，其壳体室温变薄旋压成形有一定困难。
Any mechanical operation that creates permanent deformation, such as bending, rolling, drawing, etc. performed at room temperature that increases the hardness and strength of the stainless steel.
引起材料永久变形的机械操作，如弯曲、辗制、拔制等。在室温下操作，提高不锈钢的硬度及强度。
Any mechanical operation that creates permanent deformation, such as bending, rolling, drawing, etc. performed at room temperature that increases the hardness and strength of the stainless steel.
引起材料永久变形的机械操作，如弯曲、辗制、拔制等。在室温下操作，提高不锈钢的硬度及强度。
应用推荐