The ratio of the transverse plane width to the least axis of pedicle was largest at L5.
在L5椎弓根最小轴的横断面宽度比例最大。
Results. The least axis of pedicle, the longest axis of pedicle and the transverse plane width were largest at L5 in both genders.
结果：不管性别，椎弓根最小轴、最长轴、横断面宽度均在L5最大。
In the condition of the same medium strength, the relative expression between source linear dimension and magnitude is derived in the case of different fault plane width.
在具有同样介质强度条件下，推得不同断层面宽度情况下震源体线性尺度与震级的关系式。
The display period of periodic pseudo-pattern in a virtual 2-D plane is dependent on the pulse number in a modulation period and the display plane width, which is proved in this paper in detail.
分析了周期性对称调制伪模式的显示周期与平面宽度和调制周期内的调制脉冲数之间的关系。
Taking a simplified foundation plane ast he example, this paper derives a recommended formula with less calculation errors, improving the method for calculating the width of strip foundation.
以一个简化的基础平面为例，导出计算误差较小的建议公式，以改进墙下条形基础宽度的计算方法。
The results show a decrease of tensile strength and mean vertical anisotropy and an increase of plane anisotropy with a decreasing of the width of specimen.
结果表明随着试样宽度的减小，抗拉强度、厚向异性系数减小，板平面方向性系数增大；
PMLP type plane series chain plate debris removal unit offers wide selection of transmission speed and working range and is of high working efficiency and has variable debris removal width.
PMLP型系列平面式链板排屑机，切屑输送速度选择范围大，工作效率高，有效排屑宽度多样化，可提供充足的选用范围。
In view of gate design in commonly adopt design method of plane system, the width of miter gate plate which participative working of the grider or beam is analyzed.
针对闸门设计中常用的平面体系计算方法，分析了人字门钢面板参加主(次)梁工作的有效宽度。
Based on the fault zone trapped waves observed in Kunlun Mountain Pass region, the width of the rupture plane is deduced to be about 300 m and is greater than that on the surface.
根据昆仑山口西地震测线断层围陷波的观测结果，可推断该处破裂面宽度为300 m左右，远远大于地表破裂带的宽度。
The principle of collimation is analyzed. The influence of the small wedge Angle of the plane parallel plate and the lateral shearing width upon judging laser collimation are discussed.
分析了准直原理，讨论了平行平面板楔角和横向位错宽度对准直判断的影响。
Wide beam width in horizon plane would be expected in antenna design for IR-UWB through-the-wall detection to cover most area of the room.
在脉冲超宽带穿墙检测与定位当中，要求天线在水平面内具有宽波束以达到对房屋内部区域的有效覆盖；
The contact zone width of crane wheel with track is analyzed by plane stress elastic theory.
采用平面应力弹性理论，对吊车车轮与轨道的接触区尺寸进行理论分析。
The in-plane distortion, transverse shrinkage varying along width direction and longitudinal shrinkage varying along length direction of the plate bended by line heating was proposed.
给出了水火弯板变形中的面内扭曲、沿板宽方向变化的横向收缩及沿板长方向变化的纵向收缩的描述函数。
When the width of the element of patterned films was fixed, the magnitude of in-plane anisotropy increased with the aspect ratio.
在单元宽度一定的条件下，面内各向异性的大小随薄膜中单元的矩形比增加而增加。
When the aspect ratio of element in patterned films was fixed, the magnitude of in-plane anisotropy increased as the width of element decreased.
在单元矩形比保持一定的情况下，面内各向异性的大小随薄膜中单元的宽度减小而增加。
As the size of coal pillar increases, the width of neutral plane area increases. However, the speeding-up of neutral plane area occupying the width of coal pillar decreases and becomes stable.
随煤柱尺寸增加，中性面区域的宽度逐渐增大，但其占煤柱宽度比例增速降低并逐渐趋于稳定。
It goes the same with milling processing for plane surface. It is for horizontal movement processing without limitation on processing width.
平面滚光工具与立铣加工方式相同，横向移动加工，无加工宽度限制，工具须装夹在铣床上使用。
The influence of the small wedge Angle of the plane parallel plate and the lateral shearing width upon judging laser collimation are discussed.
分析了准直原理，讨论了平行平面板楔角和横向位错宽度对准直判断的影响。
The study of plane pure-phase equi-width ring diffractive optical lenses is reported.
报道二维纯位相环带衍射光学透镜的研究。
The edges of the grooves after etching are plane and smooth. The depth and width of the grooves can solve the interference problem induced by the injection current between the adjacent pixels.
腐蚀后的上隔离沟槽边缘平整，其深度和宽度可以解决注入电流在相邻像素之间产生的干扰问题。
Three dimentional beam profiles on thefocal plane are showed. The central peak intensity and width of the beam spot are given.
给出了高斯参数与中心峰值强度及光点直径的定量关系；
Three dimentional beam profiles on thefocal plane are showed. The central peak intensity and width of the beam spot are given.
给出了高斯参数与中心峰值强度及光点直径的定量关系；
应用推荐