JFS2文件系统检查灵活性。
他经安全系统检查后方被准许入内。
He was processed through the security network before being allowed in.
该系统检查新密码的强度。
对小电流切换的交叉点定期进行系统检查。
Periodically perform this system check on only the crosspoints for low current switching.
系统检查完毕，恩下回车以查看系统报告。
您可以在这些脚本中执行同样的系统检查，以验证要启用哪些别名。
You can perform the same system checks here to verify which aliases to enable.
如果系统不能正常工作，请您的丰田经销商检查。
If the system does not work properly, have it checked by your Toyota dealer.
如果遇到问题，请检查系统日志。
然后，系统将通过外部源进行检查，以验证卡信息。
Then, the system begins to check with an outside source for verification of card information.
它应该允许管理员实时的检查和更新系统状态。
It should allow an administrator to check and update the system status in real time.
随后是系统先决条件检查面板(图1)。
Following that is a system prerequisites check panel (Figure 1).
在以上每个场景中，都调用了操作系统来进行安全性检查。
In each scenario, the operating system is called to perform security checks.
检查并确保您拥有用于特定操作系统驱动程序的硬件。
Check to make sure that you have the hardware for a specific operating system driver.
这将强制检查文件系统，而不管它是否正常。
This force checks the file system in spite of it being marked clean.
在WSRR中检查分类系统是否已经同步了。
Check WSRR to see whether the classification system has been synchronized.
检查系统正在处理的所有交易。
在进入以后，他们可以检查文件系统，查看个人信息，比如密码。
Upon entry, they scan your file system for personal information, such as passwords.
首先要检查系统配置。
检查支持系统。
检查被测系统并设计这个测试的步骤。
如果可能的话，一直保留系统状态以待安全专家检查。
If possible, always try to preserve the state of the system for a security expert to review.
当我们的系统运行迟缓时，大多数经验不丰富的管理员通常都会去检查CPU。
When our system is slow, most inexperienced administrators will usually look at CPU.
为以下项目检查故障和恢复之下的系统可靠性。
Check for the system reliability under failures and recovery for.
在每个系统上运行不带任何选项的amqmfsck来检查基本锁定。
Run amqmfsck without any options on each system to check basic locking.
卸载完成后，检查中未在系统中运行的Informix进程。
Once the uninstall completes, check that the informix process in not running on the system.
连续系统健康状况检查。
审核TSD的完整性(系统完整性检查)。
注意，使用hadoop- 0.20命令检查文件系统。
Notice that you're using a command called hadoop-0.20 to inspect the file system.
(可选)检查系统并单击Continue按钮。
Optionally, validate your system, and click the Continue button.
使用lslpp命令检查系统上已安装的软件。
Use the LSLPP command to review the software that has been installed on the system.
应用推荐