The software comes true the double closed loop regulator, therein the velocity loop is the variable-structure control, and the current loop is the classical PI control.
软件实现了调速系统的双闭环调节,其中速度环采用滑模变结构控制,电流环则是经典的PI控制。试验结果说明该调整系统有较好的动态和静态性能。
From the engineering point of view, a design method for single input optimal regulator with preassigned closed-loop pole by inverse problem approach has been derived.
给出了从逆问题指定闭环极点设计最优调节器的方法,试图从工程角度解决单输入线性定常系统最优调节器的极点配置问题。
This paper introduces a control scheme with single loop digital regulator for the boiler drum level control and describes the composition of the system.
本文介绍了用单回路数字调节器实现锅炉汽包水位控制的方案及系统的组成方法。
The system design discussed in the paper can be used in, the development and application of single loop digital regulator.
文中所讨论的系统设计,可作为开发应用单回路数字调节器的一种模式。
The current loop selects and USES PI regulator.
电流调节器选用PI调节器。
Given the structure of position regulator of linear servo system and open-closed loop iterative learning position regulation algorithm with forgetting factor.
给出直线伺服系统位置调节器结构及带有遗忘因子的开闭环迭代学习位置调节算法。
The voltage ratio is derived and the system closed-loop control is realized with PI regulator.
从理论上推导了电压传输比,采用PI调节器实现了系统的闭环控制。
The winch of inner loop and speed regulator are researched by means of classical control theory.
分别利用经典控制理论研究了绞车部分的内环、速度调节器;
To against variety of load inertia, a zero pole placement self tuning regulator basing on inner model is designed in the outer loop.
外环则针对负载转动惯量的变化,设计了基于内模原理和零极点配置的自校正控制器。
The high frequency gain of the regulator is limited to suppress the high frequency oscillation of the control signal while assigning the closed-loop poles.
在配置闭环极点的同时,对调节器的高频增益加以限制,以减弱控制信号的高频振荡。
The current loop, speed loop and position loop of the system were designed with the help of engineering design method of automation system regulator.
按照自动控制系统调节器的工程设计方法,完成了位置环、速度环、电流环的设计。
A genetic optimization method of closed loop feedback stabilizing PID regulator with minimal ISE is proposed.
提出一种满足平方误差积分(ise)最小的闭环反馈稳定PID调节器遗传优化设计方法。
This paper covers the designs of hardware in the Loop Simulation (HILS) testing of minitype turbojet engine digital control regulator, and hardware and software configurations.
介绍了某小型涡喷发动机数控调节器的半实物仿真试验系统的设计,以及软件和硬件的试验配置。
The mathematical model of SVC system was established, the stability conditions of close-loop control system were analyzed, and the parameters of PI regulator were adjusted.
建立了SVC系统的数学模型,分析了闭环控制系统的稳定性条件,整定计算了PI调节器的参数。
Further study of Circuit exchange regulator presents, takes the starting current as feedback signal to complete closed-loop control of soft start control of the three-phase induction motor.
对交流调压电路进行了进一步的研究,利用起动电流信号作为反馈量,对三相感应电动机软起动控制系统进行闭环控制。
Further study of Circuit exchange regulator presents, takes the starting current as feedback signal to complete closed-loop control of soft start control of the three-phase induction motor.
对交流调压电路进行了进一步的研究,利用起动电流信号作为反馈量,对三相感应电动机软起动控制系统进行闭环控制。
应用推荐