Upon reception of a burst detection start trigger signal, a gain control signal is output to an automatic gain control amplifier (201) so as to perform amplification with a maximum value.
当接收到短脉冲检测开始触发信号时，向自动增益控制放大器(201)输出一个增益控制信号，以便用最大值进行放大。
The constraints due to the decentralized control structure and the casual condition have posed structure constraints on the output feedback gain matrix.
由于分散控制的结构和因果约束的要求，给输出反馈矩阵加上了结构上的约束。
State feedback pole assignment technique is used to gain fast tracking of the output voltage, and a repetitive control is designed to reduce voltage distortion under nonlinear loads.
系统利用状态反馈极点配置获得了电压跟踪控制的快速性，利用重复控制较好地抑制了非线性负载工况下的电压畸变。
Correction parameters corresponding to each individual detector are computed by linear correction algorithm. Then the gain control circuit and the offset compensation circuit adjust the final output.
此方法根据线性校正算法给每个探测单元以相应的校正参数，然后通过增益控制电路和零点补偿电路来调整最终的输出。
The FVR10 features a manual-gain adjustment, while the FVR11 features automatic-gain control to adjust changes in the camera output that might degrade video quality.
其中，FVR10需要手动调节，而FVR11则实现了全自动控制，随时根据摄像机视频输出的变化而进行调整，进一步提高数据质量。
The FVR10 features a manual-gain adjustment, while the FVR11 features automatic-gain control to adjust changes in the camera output that might degrade video quality.
其中，FVR10需要手动调节，而FVR11则实现了全自动控制，随时根据摄像机视频输出的变化而进行调整，进一步提高数据质量。
应用推荐