If you're using Tomcat directly you can take advantage of the compression attribute on the Connector element in your server.xml file.
如果使用的是Tomcat，那么可以直接利用server . xml文件中Connector元素，只要加上以下的属性就可以进行程序文件的压缩了。
Study Design. Three-dimensional C3-C5 and C3-C4 finite element (FE) models were used to analyze biomechanical responses under compression and extension moments.
研究设计：三维c3 - C5和C3 - C4的有限元模型用于分析其在压缩和伸展运动下的生物力学反应。
Using nonlinear finite element method, the compression load deflection of the seal was analyzed and cross sectional shape of the seal was optimized.
利用非线性有限元法分析了密封条的压缩受力变形特性，根据结构力学原理对密封条横截面形状进行了优化。
The geochemical element association shows the features of deep fault shear and compression zone.
具有深部断裂剪切、挤压带地球化学元素组合特征。
Parallel development is a critical element of schedule compression.
并行开发是日程压缩中一个关键的元素。
MRI is a noninvasive technique that can also define vertebral slippage and neural element compression through cross-sectional axial and sagittal imaging.
MRI是一种非侵入性技术，它能通过轴向横截面及失状位成像明确椎体滑移以及神经结构受压情况。
The Finite Element method is used for the complete curve analysis of CFST short columns under compression and torsion in this paper.
本文利用有限元法对钢管混凝土压扭短柱进行了全过程分析。
The compression or tension forces are transmitted via the two threaded pins into the cylindrical casing, which is also the measuring element.
压缩力或张力通过两个螺纹销钉传递到圆筒形测量仪器中。
Using the tension-compression sensor as a measuring element of torque, the measuring, precision of dynamometer was raised.
采用拉压力传感器作为扭矩测量元件，提高了测功器的测量精度。
Based on the 3_d deteriorated girder element, the formulae of FEM for elastic stability of variable cross_section compression bar concerning geometrical nonlinearity have been derived.
在三维退化梁单元的基础上，引入几何非线性，推导出计算任意变截面压杆稳定问题的有限元列式。
In order to solve the problem of door weather strips which compression load are out of their standard, the nonlinear finite element software, MSC.
为了解决某轿车车门密封条压缩负荷超标的问题，采用非线性有限元软件MSC。
A finite element analysis is presented for predicting local buckling stresses in stiffened plates under axial compression.
本文给出了轴压加筋板局部屈曲应力的有限元分析。
In this paper, the rigid plastic finite element method is applied to analyze ring compression and the results are compared with those of the upper-bound method and experiments.
本文采用刚塑性有限元法分析圆环压缩，并与上限法分析和试验结果进行比较。
The compression work or the total pressure ratio of a compressor is determined through the use of cascade element performance data concerning deviation Angle.
压气机的加功量或增压比由其基元叶栅的落后角确定。
Design parameter analysis for the joints is carried out through finite element method so as to find out the influence of diaphragm thickness, extend length, axial compression ratio on joint behavior.
进行了节点参数分析，通过有限元数值计算，掌握了隔板厚度、挑出长度及轴压比对节点性能的影响规律。
This paper presents an axial symmetric finite element analysis of rock cylinder under uniaxial compression and gives the new results which are more reasonable than early ones of other workers.
本文介绍单轴压缩圆柱状岩石试件内应力状态的一种轴对称有限元分析成果。
OBJECTIVE: Through finite element method, to research the stress distribution of artificial and host cartilage repaired by tissue engineering under rolling compression loads.
目的：通过有限元仿真研究组织工程修复膝关节软骨缺损后人工软骨和宿主软骨的力学状态。
The objective function was defined as minimization between strains obtained from finite element method and ones observed from three-axial compression test in laboratory.
以三维有限元模拟的应变值与三轴压缩实验观测应变数据残差平方和最小为参数反演的目标函数。
The editor compiles this paper with the intent of analyzing two sets of HSRC columns of different axial compression ratio or stirrup ratio with the finite element analysis software (ABAQUS).
本文运用有限元分析软件ABAQUS分别对两组不同轴压比和配箍率的型钢高强混凝土柱进行数值模拟分析。
In this paper, a. comparison is made of the performances of several 13 element Barker coded pulse compression sidelobe suppression filters, which have a few distinct tap weights.
本文比较几个抽头加权值个数较少的13位巴克码脉冲压缩旁办抑制滤波器的性能。
The finite element numerical simulation for the triaxial compression tests also had been carried out using the commercial software ANSYS.
并利用ANSYS软件考虑筋、土的相互作用对三轴试验进行了数值模拟计算。
For special-shaped column composed of concrete-filled square steel tubes, research is done by three methods: superposition theory, finite element analysis and axial compression experiment.
并结合方钢管混凝土组合异形柱的推广应用，对梁柱节点和维护墙体作法进行了探讨。
For special-shaped column composed of concrete-filled square steel tubes, research is done by three methods: superposition theory, finite element analysis and axial compression experiment.
并结合方钢管混凝土组合异形柱的推广应用，对梁柱节点和维护墙体作法进行了探讨。
应用推荐