Start the sender channel at the source by issuing this command.
通过发出这条命令，在源系统启动发送器通道。
Start the sender channel at the target by issuing this command
通过发出这条命令，在目标系统启动发送器通道
On the MQSC command line, enter the following command to define the sender channel, where 5578 is the port number of the InboundSecureMQLink transport for the messaging engine
在MQSC命令行，输入以下命令，以定义发送方通道，其中 5578是消息引擎的InboundSecureMQLink 传输链的端口号
Figure 6. Command-line output of sender application.
图6.sender应用程序的命令行输出。
Command-line output of sender application.
sender应用程序的命令行输出。
Run the following command to allow notification to be sent to a remote domain when a meeting request from a sender in the remote domain is forwarded to another recipient.
如果运行以下命令，那么，将某个远程域中的发件人的会议请求转发到另一收件人时，会向该远程域发送通知。
Run the following command to allow notification to be sent to a remote domain when a meeting request from a sender in the remote domain is forwarded to another recipient.
如果运行以下命令，那么，将某个远程域中的发件人的会议请求转发到另一收件人时，会向该远程域发送通知。
应用推荐