The controller can specify a code block for each type the controller expects.
控制器可以为控制器期望的每个类型指定一个代码块。
The allocation process is again done in a hierarchical zoned way, with each major application requesting a block of addresses from its controller.
具体地址分配的过程也会按照层次化的方式划分，每台主要的电气设备会向其控制器请求一个地址段。
This is a solution where several physical hard disks (two or more) are governed by a unit called RAID controller, which turns them into a single, cohesive data storage block.
这是几个物理硬盘(两个或更多)有一个称为RAID的单元的管理的解决方法，它把他们变成了单一的、结合一体的数据存储块。
If you use a synchronous controller, it will block the thread.
如果你使用一个同步控制器，它会阻塞线程。
The driver's control signals are redefined, the torque control strategy is put forward and realized by standard IEC61131-3 Function Block Diagram (FBD) programming languages in integrative controller.
对驾驶员操纵信号进行了全新定义，并在此基础上提出并在综合控制器中用标准IEC61131-3功能块图程序语言实现了转矩控制策略。
This paper introduces the application of programmable logic controller(PLC)in block making machine. The machines reliability and maintenance are improved greatly by applying PLC to it.
介绍了可编程序控制器（PLC）在砌块成型机中的应用。通过PLC的使用，极大地提高了设备的可靠性和可维护性。
This paper introduces the application of programmable logic controller (PLC) in block making machine.
介绍了可编程序控制器(PLC)在砌块成型机中的应用。
This control device includes a bad block mapping table and a controller.
此控制装置包括坏块映射表以及控制器。
When to access to the data by the block addresses, the controller judges whether the block corresponding to the block addresses is a damage block.
当要根据存取区块地址存取数据时，控制器判断存取区块地址所对应的 区块是否为损坏的区块。
A soft starting controller of the asynchronous mot or based upon PIC microprocessor is proposed and the operational principle of the controller, functional block diagram and flow chart are given.
提出一种以pic单片机为控制核心的三相异步电动机软起动控制器，阐述了该控制器的工作原理、回路结构图和软件程序结构。
The paper introduces a kind of in-system programable controller for circular machine based on P89C668HFA, shows the hardware functional block diagram of it and the implement method of ISP.
介绍了一种基于P 89c 668hfa单片机的可在线编程的圆机控制器，给出了该控制器的硬件原理框图和ISP的具体实现方法。
The voltage margin method for interchange power control was applied to the dc voltage control block (DC-AVR) and the active power control block (APR) in the terminal controller.
容压法电力交换控制已经应用于终端控制器的直流电压控制部分和有功功率控制部分。
The controller receives a data block from an external rewriting device to store it in the first buffer.
该控制器从外部重写装置接收数据块并将其存储在第一个缓冲区。
A memory controller and methods for performing memory block initialization and copy functions with reduced bus traffic are disclosed.
本发明揭示用于在总线业务减少的情况下执行存储器块初始化及复制功能的存储器控制器及方法。
An electric actuator based on single chip computer AT89C2051 is introduced. The hardware selection for controller, criteria of software design and block diagram of program are given.
介绍了一种基于单片机at89 C2 0 5 1的电动执行机构，给出了控制器的硬件选用、软件设计原则和程序框图。
The ECC controller transmits the data to a direct memory access (DMA) buffer for transfer to the host device, and to an ECC block for error detection and correction of the data.
ECC控制器将数据发送给用于将数 据传送到主机装置的直接存储器存取（DMA）缓冲器以及用于对数据进行错误检测和纠错的ECC块。
Next, the controller repeats the above operation until the reserved block corresponding to the access block address is the normal block, and access to data with the access block address.
接下来，控制器重复上述操作直至存取区块地址所对应的备用区块为正常区块后，根据存取区块地址存取数据。
Aiming at the character of TMS320C6713, the paper analyzes and discusses the implement approach of controller, at last points out system composition, and given corresponding principle block diagram.
针对TMS320C 6713的特点，从系统的角度分析并探讨了调节器的实现途径，并给出了相应的原理框图。
The detailed analysis and introduction about the functional block SAA3004 used in the infra -red remote controller of the SABAT51SC32-D2 color TV, is presented in this paper.
本文对SABAT51SC32 - D2型彩色电视接收机红外遥控器所用集成块SAA3004作详细的分析与介绍。
Comparing with other methods indicates this method can design optimal L_1-controller which is low-order, rational and fit for multi-block problem.
通过与其它L_1控制器设计方法的比较，表明该方法能方便、有效地设计出低阶有理的并且适用于多块问题的L_1最优控制器。
The repetitive control algorithm includes scalar gain of the reference input with a lead block in the signal generator. A second-order low-pass filter provides compensation in the controller.
该算法中在输入参考信号处直接增加一个比例增益环节，在信号发生器处串联一个超前的时滞环节，并且用一个二阶低通滤波器作为控制系统的补偿函数。
This paper introduces an advanced traffic signal controller, which can not only implement multi-time block control, but also can be connected with network in order to realize on-line control.
介绍一种技术性能比较先进的交通信号控制机，这种信号机不仅能够自动地进行多时段控制，还可以接入网络实现在线控制；电路设计采用模块式的电路结构，可根据用户的功能需要增减模块电路。
This paper introduces an advanced traffic signal controller, which can not only implement multi-time block control, but also can be connected with network in order to realize on-line control.
介绍一种技术性能比较先进的交通信号控制机，这种信号机不仅能够自动地进行多时段控制，还可以接入网络实现在线控制；电路设计采用模块式的电路结构，可根据用户的功能需要增减模块电路。
应用推荐