最后通过试验和计算结果的对比，对轮轨蠕滑力计算模型进行验证。
Finally, via comparison between test and the calculated results, the wheel rail creep force calculation model is verified.
从应力系数、极限载荷和柔度系数三个方面对有限元计算结果和试验结果进行对比分析。
Analysis and comparison between the finite element analysis and experiment results for stress intensity factor, limit load, and flexibility factor were performed.
从应力集中系数、极限压力、爆破压力和爆破失效位置四个方面对有限元计算结果和试验结果进行对比分析。
Analysis and comparison between the finite element analysis and experiment results for stress concentration factor, limit load, burst pressure and failure location were performed.
将计算结果和国内外长大列车充气特性的有关试验数据进行对比分析。
The numerical results have been compared with the related test data of heavy haul train brake application of China and foreign countries.
通过与试验结果对比，证明计算结果和所得结论正确。
Comparison between the calculation and the test shows the both results of calculation and the conclusions are correct.
通过高强混凝土剪力墙的试验结果与计算结果的对比分析，表明本文提出的剪力墙截面曲率延性系数计算方法的可靠性和有效性。
The comparison between test results and theoretical results indicated that the calculation method of shear wall section curvature ductility index is reliable and effective.
分别采用线性和非线性的有限元方法，对复合材料加筋壁板盒段结构的扭转稳定性和弯曲稳定性进行了计算，并将计算结果与试验结果进行了对比分析。
Finite element method was adopted to research the buckling problem of the composite box structure, which was composed by lots of different thin-panel members and was simplified.
用离心试验法模拟了填埋体的沉降和边坡土工膜的应力应变状态，并将其与有限元计算结果进行了对比。
The settlement of wastes and the stress and strain status of geomembranes on a landfill slope were simulated by centrifugal experiments, and the results were compared with those of FEM calculation.
建立了平行流冷凝器的数学模型，根据所建模型得到的计算结果和试验结果对比，其误差范围在5%内。
A mathematical model for this kind of condenser was established. The comparison of experimental data with calculation result shows that the errors are within 5%.
本文对某类型飞轮的焊接温度场进行了数值模拟，并将计算结果与试验测试数据进行对比和分析。
In this paper, a temperature field of a flywheel is simulated and analyzed. And then, calculated results are compared with experimental data.
试验结果和模拟的计算结果进行了对比，验证的结果表明了此CFD模型可以用来预测煤气化的反应过程。
The good agreement indicates that CFD modeling can be used in the complex fluidized beds coal gasification processes.
计算结果和试验结果对比表明，在大空间内仍可利用火灾区域模拟方法计算烟气的运动。
The zone model could still be used to simulate the smoke movement in large Spaces. For the pool fire, the calculation model should be selected based on the heat release rate.
对比计算结果与试验实测值，表明该系统可以达到要求的响应速度和精度。
On the grounds of the contrast of calculated results and measured results, the system can meet the expected response speed and accuracy.
通过对比分析，验证了损伤变量的计算结果和试验结果整体吻合较好。
Through comparing and analyzing, the obtained theory results coincide well with the testing results.
并进行了复合材料板拉伸试验，复合材料平板实验计算结果和应变电测法得到的结果进行了对比，实验表明两种测量方法得到的结果相吻合。
The method was also used to measure strain in the tensile test of a composite laminate plate. The results agree fairly well with those obtained by the conventional measurement.
通过渗流流量和压力相关试验测定了滑脱修正系数和渗流指数以及渗流系数，并将该方程的计算结果和现场产量做了对比，证明了该方法的正确性。
Measured coefficient of slippage, seepage index and seepage coefficient by experiment, and compared calculated results with spot results and verified the effectiveness of this method.
计算结果和试验结果对比表明 ，在大空间内仍可利用火灾区域模拟方法计算烟气的运动。
The zone model could still be used to simulate the smoke movement in large spaces.
计算结果和试验结果对比表明，在大空间内仍可利用火灾区域模拟方法计算烟气的运动。
The zone model could still be used to simulate the smoke movement in large Spaces. For the pool fire, the calculation model should be selected based on the heat release...
计算结果和试验结果对比表明，在大空间内仍可利用火灾区域模拟方法计算烟气的运动。
The zone model could still be used to simulate the smoke movement in large Spaces. For the pool fire, the calculation model should be selected based on the heat release...
应用推荐