In the design of column readout stage, master and slaver structure has been adapted, where master amplifier converts charge to voltage, and slave amplifier works with standby mode to drive output bus.
列读出级采用新型主从两级放大列读出结构，其中主放大器完成电荷到电压的转换，从放大器驱动输出总线来满足一定的读出速度。
As improved, input buffer circuitry comprises a pull up stage to pull up the voltage of the differential amplifier output slightly higher during an output low condition.
作为改进，输入缓冲电路组成的阶段拉一拉期间的输出低的条件差分放大器的输出电压略高。
In the design of column readout stage, master and slaver structure has been adapted, where master amplifier converts charge to voltage, and slave amplifier works wit.
列读出级采用新型主从两级放大列读出结构，其中主放大器完成电荷到电压的转换，从放大器驱动输出总线来满足一定的读出速度。
When designing output stage, in order to enhance the efficiency, it uses the push-pull common source stage amplifier as the output stage, the output voltage swing basically reached rail-to-rail.
在输出级设计时，为了提高效率，采用了推挽共源级放大器作为输出级，输出电压摆幅基本上达到了轨至轨；
The principle figures of input stage middle gain stage and output stage for a usual two stage low-voltage CMOS operational amplifier and their principal performance are presented in the paper.
给出了一种常用两级低电压CMOS运算放大器的输入级、中间增益级及输出级的原理电路图，并阐述其主要工作特性。
It is composed of an amplifier stage, two stages of source follower and a feedback resistance, and use a single supply voltage.
该光接收机采用单电源供电，由一级放大器、两级源级跟随器和一个反馈电阻组成。
It consists of a variable-gain cell based on a current-steering structure, a novel wide-range exponential voltage generator, and a stage of a fixed-gain amplifier.
该放大器由电流调节型可变增益单元、宽范围指数电压转换电路及固定增益放大器构成。
Based on traditional two-stage amplifier, cross-coupled class AB output stage and cascode compensation were adopted to improve output voltage swing and bandwidth.
在传统两级运放的基础上，采用交叉耦合的AB类输出级和共源共栅补偿，提高了输出摆幅和带宽，并通过数学工具对功耗进行了优化。
Based on traditional two-stage amplifier, cross-coupled class AB output stage and cascode compensation were adopted to improve output voltage swing and bandwidth.
在传统两级运放的基础上，采用交叉耦合的AB类输出级和共源共栅补偿，提高了输出摆幅和带宽，并通过数学工具对功耗进行了优化。
应用推荐