UG NX2 that this is on the main steam valve in the steam turbine design for specific description.
本篇就UGNX2在汽轮机主汽阀设计中的应用作具体介绍。
This satisfies the requirement of protecting seal spring and also never puts damage to valve on steam turbine.
这样即满足了保护密封圈的要求又不对汽轮机阀体有伤害。
An analysis of why the bleeding check valve of a 600 MW steam turbine-generator set couldn't readily shut during testing is being presented, together with means of improvement.
对进口某型号600MW汽轮发电机组在进行试验时出现抽汽逆止阀关闭不到位现象进行分析，并提出了改进措施。
The paper describes some jamming phenomena at intermediate pressure main stop valve on a 600MW steam turbine, reasons are analyzed and some effective methods are carried out.
描述了某600MW机组中压主汽门的卡涩现象，对各种原因进行了分析，并采取了切实有效的处理方案。
The stability of steam turbine control system could be effected by the governing valve nonlinear position-flow characteristic.
调节阀特性非线性将影响机组的稳定运行，必须通过非线性补偿，使机组的静态特性线性化。
Through dealing with and analyzing the jam phenomenon of steam make-up governing valve of 9e combined-cycle steam turbine, the corresponding resolutions and preventive measures are put forward.
通过对9e联和循环汽轮机补汽调门卡涩现象的处理和分析，提出相应的解决和预防措施。
Unstructured algorithm is employed in this paper to simulate the complex flow field inside high pressure combined valve of a 600MW steam turbine.
采用非结构化四面体网格，对某600MW超超临界汽轮机组高压主汽调节联合阀的额定工况进行了数值模拟。
This paper discusses the use of a pilot valve with overlap, to eliminate load oscillations of a steam turbine that may take place owing to the oscillation of the oil pressure.
本文着重讨论了采用滑阀重叠以消除由于油压波动而引起的汽轮机负荷波动问题。
This paper presents the manufacturing method for inner chamber of HP main steam control valve for 600MW turbine under current conditions.
就在现有条件下解决6 0 0MW汽轮机高压主汽调节阀的内腔加工难关，实现该部件的内部生产制造方案进行介绍。
This paper presents the manufacturing method for inner chamber of HP main steam control valve for 600MW turbine under current conditions.
就在现有条件下解决6 0 0MW汽轮机高压主汽调节阀的内腔加工难关，实现该部件的内部生产制造方案进行介绍。
应用推荐