This article has designed the dynamic thrust test-bench for low-thrust liquid rocket engine within 100n.
本文设计了100n范围内小推力液体火箭发动机动态推力测试台架。
Thrust test-bench is one of the key technologies for accurate measure of rocket engine thrust. But test-benches that can compromise with both long and short burst measurement are quite few.
推力测试台架是准确测量火箭发动机推力的关键技术之一,但现有的测试台架能够很好兼顾长、短脉冲测试的较少。
This test series demonstrated this engine could go from a thrust range of 104 percent power down to 5.9 percent.
该系列测试演示了发动机能够从104%的功率推力范围减至5.9%。
Others say the blood test could thrust some women into a choice they didn't ask to make.
其他人说这项血液试验有可能会把一些妇女推向一个选择,而她们并没有要求去做这样一个选择。
In this paper, an oil film thickness VXI measuring system of the thrust bearing test has been applied to set up a new kind of optical fiber reflective sensor mod el.
本文建立了一种新型的反射式光纤位移传感器的数学模型,并将其用于推力轴承试验中测量油膜厚度的VXI测试系统中。
The thrust vector control(TVC) performance test of solid rocket motor is presented in this paper.
本文介绍了固体火箭发动机水下推力矢量特性试验。
In this paper, the Micro chemical Thruster's structure was designed and loading method of propellant and test method of thrust were investigated.
该文设计了化学微推力器的结构,研究了微推力器的装药方法和推力的测试方法。
This paper introduces in detail the thrust design and armored joint hydraulic test for PCCP restricted tubulation.
详细介绍了PCCP限制性管段止推设计和铠装接头水压试验的情况。
The article mainly introduces the hot crimping process and its test methods for the vehicle thrust rod.
主要介绍汽车推力杆的热铆接工艺及其试验方法。
The upcoming test campaign will validate the system's rocket motor and thrust vector control.
即将到来的测试活动将验证系统的火箭马达和推力矢量控制。
Test results from an experimental investigation of the effect of nozzle on the thrust of a straight tube pulse detonation engine are presented.
在直管脉冲爆震发动机上安装不同类型的喷管,利用推力传感器测量了不同频率下发动机的瞬态推力和平均推力。
The test result shows that maximum tolerance of the simulated ambient pressure deviation is about 14% under which the engine thrust uncertainty remains less than 1.0%.
试验结果表明,在保证推力不确定度优于1.0%的条件下,拉瓦尔喷管发动机高空模拟试验的模拟偏差容限约为14%。
Experimental results indicate that this test system can capture the characteristics of thrust loading and it is valuable for investigating laser thrusters and pulse detonation engines.
实验结果表明,该系统可以捕获激光推力器脉冲推力加载特征。
A kind of vertical test fixture for firing test of high thrust and short time motor with fore nozzles was designed. Its dynamic characteristics are analyzed and satisfactory results are obtained.
设计了一种适用于前置多喷管大推力短时间特种发动机点火试验的立式试车架,设计中对其动态特性进行了分析,获得了满意结果。
According to the actual application of operating experiment in the thrust bearing test board, the designed oil film thickness VXI measuring system shows better performance.
通过应用于推力轴承试验台的实测中,该油膜厚度VXI检测系统显示了良好的性能。
In comparison with the results of test, the results of numerical computation are reasonable, and the precision of thrust calculated by numerical computation can meet then...
通过与试验结果的比较,证明了在较大的主气源压力范围内计算结果合理,其推力计算的精度可满足火箭弹姿控发动机工程计算的要求。
A new calculation method was proposed for the typical structure of the platelet transpiration flux in the rocket thrust chamber based on the test data of another chamber.
针对典型的层板发汗冷却结构,提出了利用一个推力室的实验数据来计算另一推力室所需发汗流强的方法。
The experiment of transient rotor thrust during transition flight has been carried out on whirling beam test facility, and the experimental results show excellent agreement with theory.
利用旋臂式模型机动飞行试验机进行倾转过渡状态下旋翼瞬态拉力的试验研究,试验与理论计算结果表现出很好的相关性。
In this paper, a simple method for analysis of ground test data of the solid rocket motor with reversal nozzles is presented based on solving the reverse thrust at an altitude from ground test data.
文中介绍了根据地面实验数据分析反喷管在高空提供的反推力,为带反喷管发动机地面实验数据处理提供了简便的分析方法。
All above, the test and the theoretical research formed the basis of practical application for the radical-thrust floating ring hybrid bearing.
以上轴承的试验研究及理论推导为径向—推力联合浮环动静压轴承的进一步研究和工程应用奠定了基础。
The thrust characteristics of axis symmetry nozzle were mainly measured in test. For the nozzle having a vectoring angle, the deflection efficiency was measured too.
对于轴对称喷管模型主要进行了喷管的推力特性测量,对于实施矢量偏转后的喷管模型除了给出了喷管推力特性外,还给出了喷管的偏转效率。
This engine produces around 55lbs of thrust (about the same as a 5.25 "Lockwood engine) and has been built to act as a test-bed for various ideas."
这款发动机产生的推力五五英镑左右(约5.25作为“洛克·伍德发动机相同),并已建成,作为一个试验床的各种想法。”
This plot of the thrust-time curve for the B-200 motor was made using data collected from a static firing on the static Test Rig.
这个阴谋的主旨-时间曲线为b - 2 00型汽车是用收集到的数据从一个静态射击对静态试验台。
This plot of the thrust-time curve for the B-200 motor was made using data collected from a static firing on the static Test Rig.
这个阴谋的主旨-时间曲线为b - 2 00型汽车是用收集到的数据从一个静态射击对静态试验台。
应用推荐