Positive temperature coefficient (PTC) thermistor and triple frequency harmonic filter can reduce zero sequence voltage when a nonlinear resistance is used to prevent ferroresonance.
在非线性电阻消谐方式下，正温度系数(PTC)热敏电阻和三次谐波滤波器可以较好地解决零序电压偏高的问题。
Resistance temperature coefficient (RTC) of step function PTC thermistor depends on it's measurement methods, therefor the obtained results are not unique and comparable.
目前突变型PTC元件电阻温度系数的测量方法各种各样，因此测试结果缺乏唯一性和可比性。
When the circuit breaks down and the return circuit current increases, the resistance of restricting overloading protection PTC Thermistor goes up sharply for being warm, until the circuit is cut off.
当电路出现故障使回路电流增大时，过载保护PT C热敏电阻的电阻值因自热温升而出现阻值阶跃，直至把电路切断。
The thermistor element can be selected to meet any resistance-temperature curve and tolerance.
热敏电阻元器件能满足任何电阻-温度曲线和公差。
The Ni thin film thermistor was therefore obtained as temperature sensor with higher resistance-temperature performance by readjusting relevant technological parameters.
通过调整实验的工艺参数，最终得到电阻温度性能较好的镍薄膜温度传感器。
A thermistor of which resistance is changed depending on temperature and a secondary battery to which the thermistor is attached are disclosed.
公开了一种电阻随温度而变化的热敏电阻，以及连接有该热敏电阻的蓄电池。
Generally speaking, to delay the preheating time, we should select the relatively lower resistance, taller TC point and bigger PTC Thermistor.
一般情况下延长预热时间应选用阻值较低、居里点较高、体积较大的PT C热敏电阻器。
The 20J is used in air temperature sensing applications The thermistor element can be selected to meet any resistance-temperature curve and tolerance.
20J应用于空气温度感测。热敏电阻元器件能满足任何电阻-温度曲线和公差。
This effect can be reached by connecting the PTC Thermistor in series in starting assistant loop and cutting off the assistant loop when PTCR enters the state of high resistance.
将PTC热敏电阻串联在启动辅助线圈， 启动后PTC热敏电阻进入高阻态切断辅助线圈，正好可以达到这种效果。
After the clearing of the circuit trouble, the PTC Thermistor begins to cool and come back to the state of low resistance, and then the circuit enters normal working condition.
在电路故障排除后，过载保护PT C热敏电阻冷却并恢复到低阻态，同时电路也进入正常工作状态。
After the clearing of the circuit trouble, the PTC Thermistor begins to cool and come back to the state of low resistance, and then the circuit enters normal working condition.
在电路故障排除后，过载保护PT C热敏电阻冷却并恢复到低阻态，同时电路也进入正常工作状态。
应用推荐