The phenomenon, affecting factors and retarding methods of Y-TZP low-temperature aging were reviewed.
对YTZP 材料低温老化现象、影响因素及其抑制方法作了综合评述。
The thermostat is used quantitative high-pressure foaming technology, and with the high-pressure high-temperature aging treatment;
采用的是恒温高压定量发泡工艺，并经高压高温熟化技术处理；
The high temperature aging process of computer machine production is an important aspect to improve quality of production and increase competitive ability.
在计算机企业整机制造过程中，整机的高温老化是一个非常重要的环节。通过高温老化能提高计算机产品质量，增加企业的竞争力。
Low temperature aging for die casting al alloy under appropriate technological condition can increase average strength and Brinell hardness more than 10% and 30% respectively.
对压铸铝合金进行低温时效，在最佳工艺条件下，合金的平均拉伸强度提高10 %以上，布氏硬度提高30 %以上。
The mold which is treated by adopting the way delays the emergence of craquelure after low-temperature aging, and by adopting the technical scheme, the service life of the mold is greatly prolonged.
采用上述方式处理的模具经过低温时效后延迟了龟裂纹的出现，采用本发明的技术方案使模具的寿命大为延长。
In the cheese 'cave' at the shop, temperature and humidity are controlled o allow for proper aging of the cheese.
在这间商店的储藏室里，温度和湿度都受到严格的控制。
The effect of temperature on the aging performance of epoxy bonded joint in water was researched, and its failure mechanism was analyzed by SEM and FTIR.
主要研究了环氧胶接接头在不同温度水中的老化行为，并用扫描电镜（SEM）和傅立叶红外光谱仪（ FTIR）分析了其失效的机理。
Structural parameters of the polymeric materials are also time dependent: aging , influence of temperature and strain.
结构参数的高分子材料也有时间依赖性：衰老的影响，温度和应变。
Because the waterproof apron will be affected by temperature gap and accelerating aging and cause water table appeared in water and heat bilges cold shrink, serious will make parts damage.
因为防水胶圈受温度影响会热胀冷缩出现空隙并加速老化从而引起进水和表内出现水凝结物，严重的将使机件损坏。
By adjusting the starch milk concentration, temperature and drum speed to adjust the product capability of resistance to shear stress, the drying process of aging and viscosity.
通过调节淀乳浓度、滚筒温度及转速来调整产品承受剪切力的能力、干燥过程中的老化及粘度等性能。
Affected by temperature, ultraviolet light, minerals in meat, aging of meat.
受温度、紫外线光、肉中的矿物质、肉的时间影响。
The results showed that the aging of epoxy bonded joint in water was accelerated by increasing temperature.
结果表明，提高温度可以加速环氧胶接接头在水中的老化；
Scientists have known of a link between body temperature and aging in cold-blooded animals, but this was the first study to show body temperature changes impact how long warm-blooded animals live.
科学家们已经知道冷血动物的体温和衰老之间的联系，但是这项最初的研究只是表明体温的改变可以影响温血动物的寿命。
Having excellent cold resistance, it enjoys bett tightness in wide temperature range, besides, it has good ozone resistance weather resistance and aging resistance.
耐寒性能优异，在较宽的温度范围内均能发挥良好的密封性能，耐臭氧性能好，耐侯性与耐老化性能优异。
And the expression of aging damage factor against aging time and aging temperature was obtained by experiment.
得到了老化损伤因子与老化温度和老化时间的关系式。
Sauna room temperature is much higher than the normal outdoor temperature, for this moment temperature changes will lead to the quartz watch in the early aging of the waterproof gasket.
桑拿房的温度远远高于室外的正常温度，为此瞬间温差变化将导致石英表内的防水垫圈提前老化。
The effect of preparation temperature and aging time of the precursor on the properties of the resulting MgO was studied.
以不同沉淀剂制备了碱式碳酸镁前驱体，讨论了前驱体制备温度和制备时间对得到的氧化镁的影响。
The effect of aging temperature and aging time to new-type heat-resisting aluminum alloy forging structure and properties are introduced.
通过对新型铝合金时效处理后的组织结构进行分析，研究了不同的时效温度和时间对该铝合金力学性能的影响。
With the increase of aging temperature, the tensile strength decreases. With the increase of elongation.
随着时效温度的升高，合金的拉伸强度降低，而延伸率则不断增加。
However, stepped aging, which relaxes internal macro-stress under lower temperature then ages under higher temperature, can avoid longitudinal cracks effectively.
分级时效处理，低温下先让合金内部的宏观应力松弛，再在较高温度下时效，可有效地避免棒材纵向开裂。
Since the actual SOC of lead acid battery is influenced by many factors, such as temperature, cycle of discharge and aging of battery, it is difficult to obtain ideal results by traditional methods.
由于铅酸蓄电池真实的SOC受许多因素如电池温度、充放电次数、电池老化等因素的影响，传统的SOC预测技术很难达到理想的效果。
The sensibility of strain aging, ductile-brittle transit temperature, weldability, and the coordination between strength and ductility of reinforced steel bars were systematically investigated.
对试验钢筋的应变时效敏感性、韧脆转变温度、可焊性、强度与韧性的配合进行了系统的测试和研究。
The results showed that sequence and way of feeding, reaction temperature, time of aging, stirring speed and drying and calcinations had remarkable influence on the pore structure.
结果表明，加料顺序、加料方式、成胶温度、老化时间、搅拌速率以及干燥焙烧等因素对孔结构均有明显影响。
For the same aging time, higher aging temperature increases fraction of precipitated particles and modified their morphology.
在相同的时效时间下，越高的处理温度可以得到更大的析出相粒子体积分数；
Mechanical properties testing, SEM and TEM was used to study the effects of cold rolled reduction and aging temperature on the cohesion of the weak interface of DISC.
通过力学性能测试、扫描电镜及透射电镜观察，研究了冷轧压下量及时效温度对内生复合钢板弱界面结合强度的影响。
The kinetic curves properties response aging time and temperature were obtained with the coefficient of compression stress relaxation as index of aging property change.
用压缩应力松弛系数作为老化性能变化指标，得出了性能随老化时间和温度变化的动力学曲线。
The effects of the aging temperature and holding time on the microstructure and hardness of the ultra-low-carbon steel bearing copper were investigated.
研究了时效温度和保温时间对时效硬化型超低碳含铜钢的显微组织和硬度的影响。
The effects of the aging temperature and holding time on the microstructure and hardness of the ultra-low-carbon steel bearing copper were investigated.
研究了时效温度和保温时间对时效硬化型超低碳含铜钢的显微组织和硬度的影响。
应用推荐