T-tube drainage can decrease the bile duct pressure.
管持续引流胆汁可降低胆总管压力。
Cp And delta T is given by the heat, which has to do with how much of the candle burnt, divided by the constant pressure heat capacity.
T等于热量q除以恒定的等压热容，其中热量与，蜡烛燃烧的多少相关。
PA Some partial pressure, p sub A, temperature T.
在温度T下的分压为。
So we're going to start with a mole of gas, V at some pressure, some volume, T temperature and some mole so V, doing it per mole, and we're going to do two paths here.
假设有1摩尔气体，具有一点的压强p，体积，温度，我们将让它，经过两条不同的路径。
T fixed. This is the liquid phase. So suppose I start with some high pressure up here somewhere.
固定温度，这里是液相，从直线以上的某点出发。
Well, that's just the chemical potential of a, in the pure state, at temperature t and pressure pT.
好，这就是A的化学势，在纯态，温度为T，压强为p总时。
Sure, it wasn t ten feet underwater, and the pressure was minimal, but the first test was successful.
当然，这并不是一十○英尺水下，压力是微乎其微的，但第一次试验是成功的。
T rim: trim to relieve control pressure and maintain attitude. DO NOT use the trim to adjust the attitude.
调整片：利用调整片减少杆力并保持姿态。禁止利用调整片直接进行姿态调整。
The pressure of safety value has been settled up well in factory, don t adjust it freely.
安全阀的压力值在出厂时已经调定，使用中不要随意调节。
In addition, the mechanism of the T-TIG arc pressure reduction to make the sound weld formation was analyzed.
此外，在焊接试验的基础上，进一步对双钨极氩弧焊降低电弧压力、减少焊接缺陷的机理进行了分析。
Conclusion During moment of coronary angiography, rised pressure of coronary artery and short_lived myocardial ischemia might lead to abnormal QRS _ wave and change of ST _ t in ECG.
结论冠状动脉造影瞬间冠状动脉压力升高、短暂心肌缺血，可引起心电图QRS波群及ST_T的异常改变。
All Pacific Valves are designed to operate through pressure and temperature range shown in these P-T Charts for a particular ANSI Class Rating and ASTM Material.
所有美国太平洋阀门都适用于这些压力-温度表内某个特定的ANSI压力等级和ASTM材料所显示的压力和温度范围内。
Where and t are the barometric pressure at the engine's air intake and ambient temperature respectively.
和T分别是发动机进气口处的大气压力和环境温度。
Steel welding procedure qualification under the pressure of JB / T 4708-2000 determine the product of welding procedure qualification program, to complete the project welding procedure specification.
根据钢制压力焊接工艺评定JB/T 4708-2000确定产品的焊接工艺评定项目，完成焊接工艺评定项目说明书。
Analysis of products of the main welding materials, combined with steel pressure vessel regulations JB / T 4709-2000 developed products in various welded joints of welding programs.
剖析产物主体资料地焊接性，分离钢制压力容器规程JB/T 4709-2000拟定产物各个焊接接头地焊接计划。
T-shirt may release the pressure of work and make people totally relaxed. It bears good will and spirit of wearing, gradually making up the defects of modern wearing environment.
穿上它，能适当缓解人们的工作压力，更能使人们的心境得到彻底的放松，它承载着人们对穿衣方式的美好愿望和精神寄托，逐渐弥补着现代人穿衣环境中的某些缺憾。
Meantime, the pressure waveform characteristics of fluid pulse signal at various working conditions were analyzed and explained in accordance with t...
并对不同工况下流体脉冲压力信号波形的特点，结合流体系统的要求，给予了分析和说明。
T s fuzzy control model is established. It has gained favorable control effect for the hydraulic pressure set with nonlinear characteristic.
建立了T -S模糊控制模型，对于具有非线性特性的液压执行机构，控制效果良好。
It is shown that the curves ofp-t are consistent with those obtained by experiments. The flow jam at the slope chamber and tall rod is the main factors causing abnormal pressure in the chamber.
并对其进行数值分析，结果表明．弹底和膛底曲线与实验有较好的一致性，被膛和尾杆处的流动壅塞引起了膛内局部压力升高。
Reasonable reservoir pressure level is studied by numerical simulation, and the limit value of correlative parameter is determined, which provides theoretical foundation for improving t...
针对这一现状，利用数值模拟技术，对该油藏合理压力水平进行了研究，并确立了相关参数的界限值，为改善特高含水期油田开发效果提供了理论依据。
Objective: To study effects of different doses of epinephrine on mean blood pressure and serum troponin t level during cardiopulmonary resuscitation in dogs.
目的：探讨不同剂量肾上腺素对犬心脏骤停复苏时平均动脉压、血清肌钙蛋白t含量的影响。
T rim: trim to relieve control pressure and maintain altitude and airspeed.
调整片：减少杆力以保持高度和速度。
The second chapter introduces the history of 400-t high-pressure machine, repair, debugging, pressure calibration and application.
第二章主要介绍400吨四柱双缸液压机的历史、维修、调试、压力标定和样品测量等内容。
The results showed that choosing of proper manners of surface treatment and adhesive coating as well as setting of pressure, thickness of adhesive and curing condition were helpful to improve t...
结果表明，在粘接过程中采用适当的表面处理方法、涂胶方式，确定适当的加压压力、涂胶厚度和固化条件，有利于减小粘接件拉伸强度数据的分散性并提高粘接强度。
The thesis introduces the flow process of traditional technology of "t" type high-pressure blade and the reasons which effect the process period.
分析介绍了“T”型叶根高压动叶传统工艺方法的流程及影响生产加工周期的原因。
Further the earth pressure distribution with RB and rt modes was obtained using the same software, and the results were compared with t mode.
进一步研究了RB、RT模式挡土墙土压力的分布情况，并与T模式情况进行对比。
Further the earth pressure distribution with RB and rt modes was obtained using the same software, and the results were compared with t mode.
进一步研究了RB、RT模式挡土墙土压力的分布情况，并与T模式情况进行对比。
应用推荐