Please do as follows: insert the plug , and switch on the power.
请按如下操作:插上插头,然后开通电源。
This is done as follows: switch on the power, insert the plug, and then press the START button.
按照以下步骤进行:接通电源,插上插头,然后按“开始”键。
For hot drinking water, please use the electric pot. Please make sure there is water before switch on the power button.
需饮用热水时,可使用房内电热水壶,请确认壶中有水再按下电热水壶开关。
Switch on the power supply, power on the compressor, and examine whether the rotation direction of the fans of the evaporator and condenser agrees on that of the arrowhead.
接通电源,点动启动压缩机,检查蒸发器及冷凝器风扇的旋转方向是否与箭头方向一致。
Now I'm not sure if Edison would be proud or rolling in his grave, but one thing's for sure: let's hope no one hits the power switch on the way out of the door on this bulb.
现在我不知道爱迪生是骄傲还是死不瞑目,但是有一点是肯定的:让我们祈祷没人会碰到这个挂在门外的电灯泡的电源开关。
Using an optical switch, this ramp up time can be reduced to less than a tenth of a picosecond, delivering peak laser power to the plasma on a faster time scale.
使用光开关,可以把这种功率的上升过程缩短到小于0.1ps,在更短的时间内激光以峰值功率到达等离子体。
The dispatch order is how grid operators decide which power plants to switch on.
调度指令是指电网运营商如何确定哪些发电厂应该启动。
“Even though the panel will not be large enough to power the entire car, it could provide enough power to switch the engine off and on when the car is stopped at a traffic light, ” he said.
“尽管面板不能提供整辆车的动力,但是当车遇红灯停下时,它足以提供发动机熄火和启动所需的能量了。”他继续说。
The dynamic governors, which I discuss later in this article, can switch between CPU frequencies based on CPU utilization to allow for power savings while not sacrificing performance.
动态调控器(详见下文)可以根据CPU利用率来调整cpu频率,从而有助于节省电能,而不会牺牲性能。
So if a driver's running low on power, say, and doesn't have time to re-charge, he or she can pull into an automated station and switch out the battery.
因此如果汽车电量低,比方说,并且没有时间充电,司机可以让车驶入全自动电池站并更换电池。
On the basis of the switch powers' EMI primary characteristic analysis, conducted rugged technology for power is proposed.
本文在阐述开关电源电磁干扰基本特点的基础上,提出了电源传导加固技术。
Students will power is sent to the control box, press ON / OFF button switch ON keys, operation indicator light, machine.
将电源送至控制箱内,按下ON/OFF按钮开关的ON键,运转指示灯指示,机。
In the design, to produce circuit TL494 as a PWM output control signals, control of the on-switch situation, the half-bridge flyback output on the basis of the power of multi-output.
在设计中,以TL 494作为PWM产生电路输出控制信号,控制开关管的导通状况,在半桥反激式输出的基础上实现了电源的多路输出。
Solution: turn on the power to replace the switch tube, filter capacitor, or directly for power.
解决方法:打开电源更换其开关管,滤波电容,或直接换电源。
Turn on the power switch, power indicator light.
打开电源开关,电源指示灯亮。
Turn on the sub-power supply switch and key of screen displaying.
打开触摸屏下面的电源键,打开显示屏幕。
Turn on the power switch, the power indicator light is lit, which means the power is connected.
开上电源开关,电源指示灯亮表示电源接通。
The power input connector on the switch has two dedicated alarm circuit connections that can be wired to any warning device, such as a PLC or pilot light .
转换器中的功率输入连接器有两个专门的告警电路接线,可以连接任何报警装置,例如PLC或者标灯。
The user can switch the auto power down function on or off, and can also select the time period after which to power down.
用户可以自动关闭电源开关功能或关闭,也可以选择时间段之后断电。
The improved control method can make the two power switches turn on and off all under soft switching conditions and further increase the switch operating frequency and power density.
通过改进控制方式,可以使这两个功率开关的导通和关断都工作在软开关条件下,从而可以进一步提高开关频率,达到增加功率密度的目的。
Check that the power switch and air supplier switch are turned on.
检查电源开关和气源开关是否打开。
The solid state switch device uses power MOSFET as soft switch, so, the spark doesn't appear when the circuit turn on or turn off.
固态开关部件采用电力MOSFET做软开关,使得电路通断时,不会出现打火花的现象。
The structure of fixed contact, return spring and conduction ways are the major factors influencing the power-on of electromagnetic switch.
指出了静触点结构、回位弹簧弹力以及通电方式是影响电磁开关粘连的主要因素;
The generator starts to generate and produce Hydrogen gas when the power is switch on.
该发电机开始并产生氢气生成时电源开关。
Please do not turn on the power switch before adding water, for avoiding burn of the wire of electric heating tube.
在未加水之前,切勿开上电源,以防电热管之热丝烧毁。
Shock sieve machine timer knob to the sieve branch needs time then turn on the power switch, the shock will begin screening machine rotary screen work.
将振筛机上的定时器旋钮拨到筛分所需时间,打开电源开关,振筛机就会开始筛转式工作。
In order to solve the problems, we designed switch controller guarding against forgetting to turn off power supply based on hardware.
为了避免此类现象的发生,开发设计了基于硬件直接控制的防遗忘关断电源开关控制器。
In order to solve the problems, we designed switch controller guarding against forgetting to turn off power supply based on hardware.
为了避免此类现象的发生,开发设计了基于硬件直接控制的防遗忘关断电源开关控制器。
应用推荐