High molecular weight resin with highest resistance to stress cracking.
高，抗性最高分子量树脂应力开裂。
The thermal stress cracking is initiated without the use of mechanical force.
热应力裂纹的启动没有利用机械力。
As the load increased, the time growth can lead to stress cracking phenomenon.
随着负荷加大、时间增长，可导致应力开裂现象。
The sulfide stress cracking is one of the reasons of gas transmission pipeline failure.
硫化物应力腐蚀是引起输气管道失效的主要原因之一。
The widely used LSZH cable and the affecting factors for its stress cracking are described in detail.
本文对近年来广泛应用的无卤低烟阻燃电缆及其应力开裂的影响因素进行了较详细讨论。
HDPE can cause stress cracking easily with affection of environment, which limits its application in industry.
HDPE易受环境的影响产生应力开裂，这限制了其在工业上的应用。
Shatterproof is intended to replace silicon oxide, which serves a similar purpose but is prone to stress cracking.
碎，目的是取代氧化硅，它相似的目的，但很容易应力开裂。
Excessively high injection speed can cause high surface orientation and increase susceptibility to stress cracking.
过高的注塑速度会引起较高的表面方向性及增加应力破裂的敏感性。
The chemical stress cracking of PET fiber-methylamine system is considered to be a fracture phenomenon of polymers.
PET纤维-甲胺系统的化学应力开裂被归结为一种高聚物断裂破坏现象。
It produces moldings with good surface finish, is resistant to chemicals and stress cracking, and has low shrinkage and warpage.
它生产的模具表面光洁度好，可耐化学品和应力开裂，并具有低收缩和翘曲。
Siloxane was grafted on the low density polyethylene to improve the property of the environmental stress cracking of low density polyethylene.
研究了低密度聚乙烯接枝聚硅氧烷后的环境应力开裂性。
The resistance of nitrided J55 casing to sulfide stress cracking (SSC) was studied by C-ring testing and three-point bending testing under different conditions.
用应力环腐蚀试验和三(四)点弯曲试验研究了某J 55(即石油套管)渗氮套管在不同试验条件下的腐蚀行为，并和未渗氮套管的抗腐蚀性进行了比较。
It showed that a fast cooling after drawing was of benefit to dimensional stability, straightness, environmental stress cracking resistance, and strength of the drawn tubes.
拉伸时的自然冷却会产生不均匀的产品，快速水冷却拉伸工艺能显著改善管的耐环境应力开裂性，成倍提高其强度。
It showed that a fast cooling after drawing was of benefit to dimensional stability, straightness, environmental stress cracking resistance, and strength of the drawn tubes.
数据说明拉伸后的快速冷却有利于管的尺寸稳定和直线度改善。
Delamination and cause of polycarbonate (PC) thin-wall component were studied by comprehensive analysis methods and chemical stress cracking mechanism of PC delamination was found.
应用综合分析方法研究了聚碳酸酯(PC)薄壁件分层开裂及其起因，发现了分层的化学应力开裂机制。
Authors inter-prete all experimental results of the work with the molecular mechanism of fracture behaviour of polymers and propose the mechanism of chemical stress cracking of PET-methylamine system.
作者从高聚物断裂的微观机理解释了所有实验结果并提出PET -甲胺系统化学应力开裂机理。
There are reactor coolant system weld issues, they're used and they're getting primary water stress corrosion cracking.
还有反应堆冷却剂系统焊接问题，它们使用了并且得到原生水,应力腐蚀裂痕。
Stress corrosion cracking problem of concrete beams with crack is studied in this paper.
本文研究了带裂纹混凝土梁的应力腐蚀断裂问题。
Through-thickness cracking also can lead to fatigue or stress corrosion cracking of the base metal beneath the plating.
还会形成穿透型裂纹，造成镀层下本体金属的疲劳或应力腐蚀裂纹。
The pit then grows through the compressive layer, and the change in residual stress state and the pit geometry initiate stress corrosion cracking.
随后斑点穿过压缩层继续扩展，剩余应力发生改变，斑点最终导致应力腐蚀裂纹。
Stress corrosion cracking in which the cracking occurs along grain boundaries.
沿着晶界发生的应力腐蚀开裂。
Cracking due to the combination of tensile stress and corrosion in the presence of water and chlorides.
在存在水和氯化物的情况下及耐压强度和侵蚀的联合作用下发生的开裂。
The paper discusses over the influence exerted by welding residual stress on the static strength, brittle fracture and stress-corrosion cracking of metal structure.
本文介绍了焊接残余应力对金属结构的静强度、脆性断裂以及应力腐蚀开裂的影响。
The role of hydrogen embrittlement in stress corrosion cracking has also been discussed.
文中还对氢脆在应力腐蚀开裂中的作用进行了讨论。
The effect of different deformation-aging treatments on the stress corrosion cracking of LY12 aluminum alloy was studied.
本文研究了不同的形变时效处理对LY 12铝合金应力腐蚀开裂性能的影响。
It has been proved that these cracks are caused by sulfide stress corrosion cracking (SSCC) through failure analysis and service environment survey.
通过失效分析和管道服役环境调查，证明开裂原因是管道服役期间发生硫化物应力腐蚀开裂(SSCC)。
It has been proved that these cracks are caused by sulfide stress corrosion cracking (SSCC) through failure analysis and service environment survey.
通过失效分析和管道服役环境调查，证明开裂原因是管道服役期间发生硫化物应力腐蚀开裂(SSCC)。
应用推荐