First of all, for strength and stability, mainly a cylinder, cover the wall, the water pressure check and impeller stress test, the axis of strength checking.
首先进行强度和稳定性计算，主要进行了筒体、端盖的壁厚计算、水压试验应力校核以及叶轮、轴的强度校核。
This paper presents an application of MSP430 to test the pressure strength of iron ore pellet.
本文介绍Msp430内部资源以及它在球团矿抗压强度测试中的应用。
The paper describes the measurement method for model surface temperature and model surface illumination strength in wind tunnel optical pressure measurement test by the virtual instruments.
本文介绍了在风洞光学测压试验中应用虚拟仪器技术对模型表面温度和模型表面光照强度的测量方法。
Some behaviors of saturated flyash such as pore water pressure, dynamic strength, and dynamic deformation are studied by the dynamic torsional shear test.
通过动扭剪试验研究饱和粉煤灰的动孔隙水压力特性、动强度特性以及振陷变形特性。
By using reliability design methods, minimal reliability of virgin static strength of flat ribbon-wound pressure vessels at pressure test is quantitative analyzed.
应用可靠性设计方法，对压力试验时扁平绕带式容器初始静强度的可靠度进行定量分析。
The selection and analysis of uniformity of devastating contrastive test sample were introduced and the uniformity of corrugated cardboards marginal pressure strength was analyzed.
对瓦楞纸板边压强度测试进行均匀性分析，介绍了破坏性比对测试样品的选用和均匀性分析方法。
Method Mud invasion process is simulated with conventional three axis rock strength test device under same downhole pressure and temperature.
方法采用常规三轴岩石强度试验装置，进行井下温度压力条件下的泥浆侵入过程模拟试验。
Meanwhile, the law of soft clay strength improvement is drawn from different consolidated pressure and different degree of consolidation by many consolidated-quickly shear test.
再通过大量的固结快剪试验，得到软粘土在不同固结压力、不同固结度下的强度变化规律。
In order to make the calculated burst pressure coincide with actual value, the developed fiber strength value must be determined by the simulation test.
为了使计算的爆破压强与实际结果相符合，纤维发挥强度的选取必须由模拟试验确定。
By using reliability design methods, minimal reliability of virgin static strength of steel thin wall cylinder during pressure test is quantitative analyzed.
应用可靠性设计方法，对压力试验时钢制薄壁内压圆筒形容器初始静强度的最小可靠度进行了定量分析。
Based on the ultimate tensile strength test and extension test under confining pressure, the characteristics of flexible concrete are studied.
通过极限抗拉强度试验和围压作用下的拉伸试验，研究了柔性混凝土的抗拉破坏特性。
The triaxial tensile test of remolded loess indicates that the tensile strength of loess is related to the confining pressure and water content.
重塑黄土的三轴拉伸试验表明，土体的抗拉强度与围压和含水率关系密切。
The test pressure coefficient and safety factor are searched for thin-wall vessels with minimum virgin reliability of burst strength in different working conditions.
基于随机-模糊概率模型，定量分析了钢制薄壁圆筒临界失稳强度的模糊可靠度、稳定系数与外压试验压力系数之间的关系。
The test results show that the relative breakage is correlative to the particle strength and confining pressure.
结果表明，试验中相对破碎率同颗粒强度和围压力的相对大小直接相关。
By using this method, it is quantitative analyzed that reliability range of virgin static strength of spherical vessel at pressure test of all severe condit…
在最苛刻的气压与液压试验条件下，对球形容器初始静强度的可靠度范围进行定量分析。
The determination methods of media and pressure for strength test of high-pressure gas pipeline in class 3 and class 4 locations of city are put forward.
对燃气管道强度试验的介质与压力进行了多角度的分析和探讨，提出了城镇三、四级地区高压燃气管道强度试验试验介质与压力的确定方法。
The statistical results show that the clays have high water contents, and the ratio of their vane test strength vs. the effective overburden pressure ranges from 0.2 to 0.4.
统计表明该浅层软土含水量高、原位十字板剪切强度和有效上覆应力的比值约为0．2-0．4。
The statistical results show that the clays have high water contents, and the ratio of their vane test strength vs. the effective overburden pressure ranges from 0.2 to 0.4.
统计表明该浅层软土含水量高、原位十字板剪切强度和有效上覆应力的比值约为0．2-0．4。
应用推荐