A dielectric Withstand tester (also called hipot tester, dielectric strength tester, flash tester, high voltage tester) is then used to measure this current.
电气强度测试仪(也称为耐压测试仪，电介质强度测试仪，闪点测试器，高压测试仪)是用来测量此类电流值的测试仪。
High voltage cables are typically insulated with special water-resistant polymers that have high-dielectric strength.
通常高压电缆使用的是特殊的防水高分子聚合材料，具有很高的绝缘强度。
The dielectric strength test can be made to be destructive or non-destructive.
电气强度测试可分为破坏性和非破坏性。
Dielectric strength tester shall conform to UL 745-1 specifications.
电介质强度测试者应该按照UL 745-1规范。
This paper briefly introduces the requirements about the insulation system of electronic product, and describes the importance of functional check and Dielectric strength in safety test.
本文简述电子电气产品对绝缘系统的要求，以及在产品的安全测试中抗电强度试验和对测试仪器作运行检查的重要性。
Dielectric barrier discharge (DBD) can be applied to modify polymer surface to improve its wettability and adhesive strength.
介质阻挡放电(DBD)处理聚合物表面可有效提高其亲水性和结合强度。
The Dielectric Strength Test is to be performed between each pair of conductors (including ground if applicable) and between each conductor and the foil wrapped cord guard.
电介质强度试验是在每对导体（包括地）之间和每个导体与包装了金属薄片的尾档之间测量。
The addition of PS can reduce the dielectric constant of glass-ceramic substrate materials effectively, but reduce the flexural strength at the same time.
在玻璃陶瓷基板材料中加入PS有机球能有效地降低基板的介电常数，但同时影响基板的抗折强度。
A large polarization magnitude is responsible for the strength of interaction while proper polarization rate and dielectric loss are necessary for the stability of interactions among particles.
大的极化强度确保相互作用强度，合适的极化速率和介电损耗以保证颗粒相互作用的相对稳定性。
The cord set completed required cycles of flexing with no occurrence of end results and also successfully completed the Dielectric Strength Test without breakdown.
插头完成了要求的弯曲周期，没有出现上文所提到的最后结果，并且通过了电绝缘强度测试，没有损坏。
Test result of dielectric strength, partial discharge and endurance property are analyzed and contrasted between solid dielectric is two film and tree film in model capacitor elements.
本文比对分析了极间介质为两层膜和三层膜的模型电容器元件的介电强度、局部放电性能以及耐久性能的试验结果。
On the basis of the trap theory of polymer breakdown by authors, the dielectric strength is the function of the trap density, which has been demonstrated in electrical ageing of polymer.
在聚合物电老化击穿的陷阱理论中，介电强度与陷阱密度呈函数关系，这已在电老化试样上得到证实。
Standard Test Method for dielectric breakdown voltage and dielectric strength of D149 ASTM solid electrical insulating materials at industrial power frequencies.
ASTM D149固体电绝缘材料在工业电源频率下的介电击穿电压和介电强度的试验方法。
Test method for ASTM D149 solid electrical insulating materials at commercial power frequencies the dielectric breakdown voltage and dielectric strength.
ASTM D149固体电绝缘材料在工业电源频率下的介电击穿电压和介电强度的试验方法。
"Pollution degree" describes the degree to which a soild liquid or gas which deteriorates dielectric strength or surf ace resistivity is adhering.
“污染等级”是指固体、液体或气体恶化绝缘强度或表面电阻率的程度。
Breakdown property is the basis requirement to dielectric and the improvement of the electrical strength is one of the most important works in dielectric research field.
击穿性能是电介质材料最基本的要求，提高材料的电气强度是电介质研究最为重要的任务之一。
With this equipment, the dielectric recovery strength characteristics of ceramic chambers and deion plate chambers are studied.
应用此装置测量了不同分断条件下陶土灭弧室和栅片灭弧室内的介质强度恢复特性。
The optimal composition was chosen with the linking strength between the stainless-steel and the dielectric and the metamorphosis of the sintered substrate.
根据介质层与基板的结合强度以及基板的变形量大小，筛选最佳介质浆料配方。
Check whether the insulation resistance and the dielectric strength of the electric devices attached to the panel and equipment body are sufficient.
检查一下控电板和设备体上的那些电器设备，看看他们的绝缘电阻和绝缘强度是否合格。
Such optical resonators distribute randomly in the random medium and their amount and distributing characteristics depend on the strength of the dielectric constant fluctuation.
这样的光腔在介质中是随机分布的，其数量与分布特征与介电常量涨落的强弱有关。
A new stirring method for testing dielectric strength of insulating oil is described.
本文介绍了一种新的搅拌法，应用于绝缘油介电强度的测定。
By analyzing the case of the dielectric strength test on household top-heating automatic soymilk machine, this paper briefly discuss two questions which should be pay attention to during safety test.
从结构设计和元器件选用两方面分析了上加热式家用全自动豆浆机在抗电强度试验时遇到的问题，并就安规测试中需要注意的问题进行了论述。
Insulating properties, dielectric strength, volume resistance, pressure, shock resistance, and temperature characteristic of ELANTAS conformal coatings all achieve excellent level.
ELANTAS三防漆绝缘特性、介电强度、体积电阻、耐压冲击、温度特性均达优良等级。
This paper introduces a new type of test circuit for measuring the ar (?) gap dielectric recovery strength of low voltage electrical apparatus.
本文介绍一种测量低压电器弧隙介质恢复强度的试验线路。
The results showed that about 11% (weight fabrication) chopped fiber or 37% glass cloth reinforcing PTFE had the highest tensile strength and acceptable dielectric properties.
结果表明：11%短玻纤和37%玻纤布(重量百分含量)增强PTFE具有最高的拉伸强度和良好的介电性能。
The effect of the sintering temperature and the mullite content on the dielectric properties and the bending strength has been studied.
研究了烧结温度和莫来石含量对复合材料的介电性能和抗弯强度的影响。
In chapter 5, the essence of the commutation's dielectric strength detecting is one of screening test of reliability.
第五章基于可靠性相关理论，揭示了换向器片间介电强度检测的实质，即其本身是一项可靠性筛选试验。
The contact has many advantages in breaking capacity, anti-welding behaviour and dielectric recovery strength, compared w…
在开断能力、抗熔焊性、介质恢复强度等电气性能方面均明显优于传统粉末冶金法铜铬触头材料。
The contact has many advantages in breaking capacity, anti-welding behaviour and dielectric recovery strength, compared w…
在开断能力、抗熔焊性、介质恢复强度等电气性能方面均明显优于传统粉末冶金法铜铬触头材料。
应用推荐