The influence of sludge type, sludge moisture content, drying method and thermal drying temperature on sludge adhering quantity during thermal drying was investigated through experiment.
通过试验考察了污泥种类、含水率、干燥方式及热干燥温度等因素对污泥热干燥过程中粘壁量的影响。
Other fuels such as wood, biomass, shredded tires and sludge are also candidates, depending on their percentage of heat input, moisture content and emission requirements.
其它燃料如木头，生物燃料，碎轮胎以及煤泥，也可作为燃料，这取决于其对热量输入百分比，水分含量和排放的要求。
In general, increased solids recovery in centrifuges is associated with increased moisture content in the dewatered sludge.
通常，离心机内固体恢复的增加与脱水淤泥的湿度的增加是有关联的。
The external condition of drying sludge has little effect on final moisture content, but it has greater effect on drying time.
污泥干燥的外部条件对最终干燥效果影响不大，但对干燥时间影响较大。
However, the positive forced aeration could accelerate the moisture content reduction and the organic matter degradation of mixtures of sewage sludge and amendment.
但正压强制通风能加快堆料含水率的降低和有机质的降解。
In this article, the printing and dyeing sludge need to be dryed to moisture content of 30%. Then the drying technology of printing and dyeing sludge was explored and researched.
本文在确定印染污泥的干燥目标为含水率30%后，对印染污泥的干燥工艺进行了探索和研究。
The higher the drying temperature and the smaller the particles of sludge, the shorter time be needed to dry to a certain moisture content and the higher drying rate in constant rate drying stage.
干燥温度越高、污泥颗粒越小，干燥至一定的含水率所需的干燥时间越短，恒速干燥阶段的干燥速率越高。
It could be concluded that LSDC can obviously speed up the sedimentation rate of sludge, decrease moisture content and specific filtration resistance of sludge, which was superior to CPAM.
对生物活性污泥的絮凝脱水性能的研究结果表明，LSDC在提高沉降速度、降低污泥含水率和污泥过滤比阻方面有明显效果，优于对比样CPAM。
It could be concluded that LSDC can obviously speed up the sedimentation rate of sludge, decrease moisture content and specific filtration resistance of sludge, which was superior to CPAM.
对生物活性污泥的絮凝脱水性能的研究结果表明，LSDC在提高沉降速度、降低污泥含水率和污泥过滤比阻方面有明显效果，优于对比样CPAM。
应用推荐