Metering screw stem glass devices can be optional in this machine according to different materials.
该机据不同物料可选配螺杆或量杯计量装置。
Metering screw stem or glass devices can be optional in this machine according to different materials.
该机据不同物料可选配螺杆或量杯计量装置。
Towel after the temperature decreases, then soak in water and deposited in the eye after the screw stem , so that repeatedly done 3 times.
毛巾温度降低后,再泡在水中后拧干敷在眼上,这样反复做3次。
A new type screw stem welder with capacitance stored energy welding, being high efficiency and used to the production for the pipe with stems outside is introduced.
介绍了为适应钉头管生产而开发研制的新型高效电容储能螺柱焊机。
In order to improve the plastification output, we adopt double-head of cylinder screw stem and two-feed chute. The two chute of the cylinder are both fixed on the special feed shaft stand.
为提高塑化产量,采用双头机头机筒螺杆两道机筒进料口,都作了特殊设计,以便于吃料和排气,两道机筒都装在专用加料轴承座上。
Stem the screw on the rear always fill in, to prevent the movement with filler.
阀杆的螺纹尾部始终在填料之上,防止运动时带出填料。
Screw while having dry absorption capacity, but it must be to prevent the stem turn, so as not to scratch the surface of the work.
螺杆泵虽然具有干吸能力,但是必须防止干转,以免擦伤工作表面。
Objective to determine the effect of cemented intramedullary stem tip on bone torsional property at the level of femoral cortical screw holes.
目的确定在股骨假体柄尾端位于股骨螺钉孔水平时对股骨干扭转力学特性的影响。
Special attention should be given to the proximal screw fixation. In this case the use of uni-cortical screws is recommended around the stem of the implant and bi-cortical screws below this level.
应特别注意近端螺钉固定,在此案例下,使用单皮质螺钉推荐用于假体干部,而双皮质螺钉用于假体之下。
Failure is more common with the screw put on the Bellows Seal Valves threaded stem wear, so that the valve can not close.
比较常见的故障是阀杆与螺套上的丝扣磨损,陶瓷阀门使阀门无法关闭。
Stem structure 1) stem - inside screw bronze multi-turn valves for the most common and preferred structure.
阀杆结构1) 明杆-内螺纹结构对于青铜多回转阀门来说是最通用、首选的结构形式。
When screw pump works, the stem can not only influence by the force of tension stress but also the shearing stress which makes it to be failure easily if the design is not good or monitor is poor.
螺杆泵工作时,杆柱不但受到拉应力,而且受到剪应力。如果设计不当或使用中监测不力,螺杆泵很容易发生故障。
The puck itself is mounted by one screw on the actuator stem.
圆盘本身通过一个螺丝钉安装在执行器上。
This means that the 7/16" cap screw is secured down until the movement of the stem is restricted. check the clearance between the frame and the steering stem."
干这意味着,7 / 16“螺丝帽下的担保,直至运动受到限制。检查干间隙的框架和指导。
This means that the 7/16" cap screw is secured down until the movement of the stem is restricted. check the clearance between the frame and the steering stem."
干这意味着,7 / 16“螺丝帽下的担保,直至运动受到限制。检查干间隙的框架和指导。
应用推荐