Any errors detected by the memcheck program when scanning the Notes/Domino memory pools.
在扫描Notes/Domino内存池时，memcheck 探测到的任何错误。
A laser scanning non contact measuring method and a measuring system for the roundness errors of large sized rotating parts are presented.
利用激光狭缝扫描原理和光电传感技术，提出了一种用于测量大型回转体类零件圆度误差的激光扫描非接触测量方法和测量系统。
Giving the same limit for the acquisition time, a larger acquisition probability is obtained with the raster scanning during the link foundation when the coarse pointing errors asymmetry is high.
在卫星光通信的链路建立过程中，粗瞄误差不对称度较高时，同样的扫描时间限制内分行扫描可以获得更高的捕获概率。
Map scanning digitization is one of the ways to capture spatial data in GIS. After digitization, the geometrical figure and area of a figure may change because of errors.
地图扫描数字化是GIS数据采集的重要手段，地图上的图形经扫描数字化后，其几何形状和面积因误差的存在而发生改变。
Attitude measurement errors of the double cone scanning infrared earth sensor caused by brushless DC motor speed asymmetry was researched.
针对双圆锥扫描式红外地平仪因无刷直流扫描电机转速不均匀造成的姿态角测量误差进行了研究。
Tube scanner′s structure errors have great effect on the measurement accuracy of Scanning Probe Microscope(SPM).
单管式扫描器的结构误差是影响扫描探针显微镜测量精度的主要误差因素之一。
This paper describes the structure and principle of high-speed mechanical scanning system, and analyses the errors in the system.
本文介绍了高速机械扫描系统的结构和原理，分析了它的精度。
For polynomial fitting measuring model of a linear structured light scanning probe, the extraction and compensation methods for systematic errors of the probe are presented.
针对线结构光扫描测头多项式拟合测量模型的系统误差问题，提出了一套用于该测头系统误差提取与补偿的方法。
Using the dose film analyzing system and the 3d water tank scanning system to measure some parameter of LINAC in this research, the both obtained results have good coherence in the scope of errors.
用三维水箱系统和剂量胶片分析系统分别对医用直线加速器的一些性能参数进行了检测，两者所得结果在3%误差范围内有较好的一致性。
The relative errors in the channel 4 are higher than those in channel 5, and they decreases with the increase of scanning angle. The maximum relative error is less than 8%;
其中，通道4的相对误差比通道5大，同一通道中模式5的相对误差最大，但最大可能相对误差不到8%，且随扫描角的增大而减小；
The relative errors in the channel 4 are higher than those in channel 5, and they decreases with the increase of scanning angle. The maximum relative error is less than 8%;
其中，通道4的相对误差比通道5大，同一通道中模式5的相对误差最大，但最大可能相对误差不到8%，且随扫描角的增大而减小；
应用推荐