Anti rust oil is used on strip surface as protection from rust.
反对的锈油当做来自锈的保护在分带表面上被用。
Sampler keep clean, do not be coated in the blade part of the anti-rust oil.
经常保持取样器清洁，不用时应在刀刃部分涂防锈油。
It is more than a year that the antirust period of thin-film antirust oil SY-100 developed with resin, rust inhibitor and other additives.
用树脂、缓蚀剂和其它添加剂研制的SY- 100薄膜防锈油在室内的防锈期可达1年。
Antirust oil has an important role in the whole rust preventive work, and it is an important mean for the surface protecting of metal products.
防锈油在整个防锈工作中占有重要地位，是金属产品表面保护的重要手段。
Oil it regularly to prevent rust.
定期给它上油以免生锈。
SLUSHING OIL : Oil or grease-like material used on metals to form a protective coating against rust, corrosion, etc.
防锈油：涂在金属表面，形成保护层，防止金属生锈或腐蚀的油或者油脂类材料。
Spraying must be washed clean appearance, there is oily wax with a agent oil, new welding or metal appearance except rust after use of epoxy resin antirust primer to prevent rust.
施喷外表必定要用水洗洁净，有油质，蜡质要用出有剂出油，新焊接或除铁锈后的金属外表要用——环氧树脂防锈底漆处理以防生锈。
After pump should be cleaned of oil at the metal surface rust, and dry on the custody vertical. Flooding should also put a net electric motor with water.
电泵用后，应清洗干净，在金属表面涂油防锈，并竖直放在干燥处保管。水浸电机还应放净电机内的清水。
If a longer time out, it should be made to pump from the Wells to carry out maintenance, rust, coating for oil and parts, after assembly storage preservation.
如果停用的时间较长，就应把水泵从井中提出来，进行维修、除锈、涂油及换件，组装后入库保存。
If the water is serious, should be taken immediately to a watch shop to clean oil, clear water movement, to avoid the parts rust.
如果进水严重，应立即送往表店擦油，清楚机芯里的水分，以避免部分零件生锈。
The shuttle plate and parts in this area at the front of the machine should be well dried and a little oil applied to prevent any rust.
机器前面的梭形板及位于该处的各个零件应仔细擦干并加少量的油，以防生锈。
Oil stain and rust stain on welding wire shall be removed.
焊丝在使用前应清除其表面的油污，锈蚀等。
Steel surface should be no visible oil, dirt, scale, rust and paint coating and other debris should as far as possible eliminate, any attachments should be strong.
钢材表面应无可见油脂、污垢、氧化皮、铁锈和油漆涂层及其它杂物应尽可能除去，任何附着物均应是牢靠的。
Steel surface should be no visible oil, dirt, scale, rust and paint coating attachments, any markings should be only slight discoloration of dot or stripes.
钢材表面应无可见的油脂、污垢、氧化皮、铁锈和油漆涂层附着物，任何残留痕迹应仅具点状或条纹状的轻微色斑。
Steel surface should be no visible oil, dirt, scale, rust and paint coating and other attached objects, the surface should be showed homogeneous metal color.
钢材表面应无可见的油脂、污垢、氧化皮、铁锈和油漆涂层等附着物，该表面应显示均匀的金属色泽。
Paint coating, should take the rust coating parts, weld coating, welding spatter materials, oil, dust and other debris cleared.
油漆涂刷前，应将需涂装部位的铁锈、焊缝药皮、焊接飞溅物、油污、尘土等杂物清理干净。
Using cooperating effect of different rust-proof agents, a solvent-diluting soft film rust-proof oil was developed for sea equipments.
利用防锈剂之间的协同增效作用，研制出了海洋设备溶剂稀释型软膜防锈油。
After pump should be cleaned of oil at the metal surface rust, and dry on the custody vertical.
电泵用后，应清洗干净，在金属表面涂油防锈，并竖直放在干燥处保管。
A new technology of getting rid of oil and rust of steel is introduced before phosphorylated in ordinary temperature.
介绍了钢铁常温磷化前处理——除油、除锈新工艺。
Oil air compressor and all the appearance of dust and other pollution caused by the appearance of the machine. Both rust-proof function.
适用于发动机外表、空压机外表及一切污垢积尘等造成的机器外表污染，兼有防锈功能。
The oil tank will rust unless you slap on a couple of coats of red lead .
如果不涂上两三道铅丹，那油罐就会生锈的。
A burst accident of a sand tank, which was used for removing rust by means of spraying on an oil tank, was analyzed, and the prevention countermeasure was provided.
对油罐喷砂除锈过程中发生的一起砂罐爆炸事故进行了剖析，并提出了预防对策。
Shelf stability, salt spray resistance and atmospheric resistance of rust preventive oil could be changed with the oil used.
不同的蜡对溶剂型防锈油的油基稳定性、抗盐雾性能和耐大气性能影响较大。
Remove scale, in the process of assembly parts surface oil, in case of rust.
去掉氧化皮，装配过程中零件表面涂上油，以防锈蚀。
Before welding, the surface of pipe should be removed the rust and oil.
焊接前，管路表面要除锈、除油。
Taking the formula modification of naval vessel—use rust—inhibitive turbine oil as an example , the application of balancing design method in formula study is introduced.
以舰用防锈汽轮机油配方调整工作为例，介绍了均匀设计在配方研究中的应用。
Potential variation of rust preventing oil film after its degradation was studied by using wire beam electrode.
采用丝束电极研究防锈油膜失效之前的电位变化。
Clean water, oil, rust, dust and other filths before spraying the paint on the surface.
喷涂前应先把被涂物表面之 水份、油脂、铁锈、灰尘及附着污物清除干净。
Clean water, oil, rust, dust and other filths before spraying the paint on the surface.
喷涂前应先把被涂物表面之 水份、油脂、铁锈、灰尘及附着污物清除干净。
应用推荐