Shear Springs are built on the diagonals of quad faces and provide some resistance to shearing forces in the cloth.
剪变弹簧，四边形面的对角线重合。提供抵抗布料剪切变形的力。
The evaluation showed that PRCD-1 was better than HPAM in resistance to heat, resistance to salt and resistance to shear.
性能评价实验表明 ，PRCD -1在抗温性、抗盐性及抗剪切稳定性方面均优于HPAM。
Prestressing also increases the resistance to shear forces, and in some cases reduces the amount of reinforcement required to resist shear.
预应力也可以提高抗剪能力。在某些情况可以减少为了抗剪而需要的预加应力值。(没有听过为了提高抗剪加预应力的。能举个例子？，学习中)。
By adjusting the starch milk concentration, temperature and drum speed to adjust the product capability of resistance to shear stress, the drying process of aging and viscosity.
通过调节淀乳浓度、滚筒温度及转速来调整产品承受剪切力的能力、干燥过程中的老化及粘度等性能。
With widely applying of profiled sheet, it is not only reflect the working of structure but also obtain benefit that considering the ability resistance to shear of profiled sheet in the plane itself.
随着压型钢板的广泛应用，充分考虑这些面层在其平面内的抗剪能力——受力蒙皮作用，不仅能真实反映结构的实际工作，而且还可获得相当的经济效益。
Should have the high resistance to emulsion and the good shear stability, favors with the extension working life.
应具有较高的抗乳化性和良好的剪切稳定性，以利于与延长工作寿命。
Furthermore, the contribution of flanges to the shear resistance of the wall was analysed.
同时还分析了翼缘对墙片的抗剪承载力的贡献。
The usually called viscosity that is the resistance of a fluid to shear forces, and hence to flow.
通常所谓的粘度。它是流体对剪切力的阻力，因而也是对流动的阻力。
The parameters characterizing the capability of materials resistance to erosion, impact damage erosion energy and shear damage erosion energy were introduced in this model.
在模型中引入了表征材料抵抗侵蚀破坏能力的参数：冲击破坏侵蚀能和剪切破坏侵蚀能。
The test results show that the reinforced porous brick wall similar tO normal reinforced brick wall on aseismic design, shear resistance of the bar cannot be used very much when using lap joint...
试验结果表明，配筋多孔砖墙与配筋普通砖墙具有相近的抗震性能，水平筋采用搭接接头时不能发挥钢筋的抗剪作用以及端部锚固钢筋具有提高承载力和约束砌体作用等。
The result shows that the shear-wave velocity of saturated sand could be strongly related to the liquefaction resistance under a certain liquefaction criterion.
结果表明，在给定的应变破坏标准下，饱和砂土剪切波速与抗液化强度具有良好的相关性。
There is not composite enhancing effect to shear resistance of reinforced concrete beams between steel fiber and stirrups.
钢纤维与箍筋之间在提高钢筋混凝土梁斜截面承载力方面不存在“藕合增强效应”。
The discriminant condition avoiding the baroclinic destruction and the method to calculate the shearing resistance are given from the mechanics of shearing resistance and the type of shear failure.
讨论 外节点的抗剪机理及节点的受剪破坏形式，提出了节点 斜压破坏 的抗剪承载力计算方法。
The ratio of the magnitude of an applied shear stress to the velocity gradient that it produces; that is, a measure of a noncrystalline material's resistance to permanent deformation.
剪切应力数值与其产生应变速率的比值叫粘性，用来衡量非晶材料抵抗永久变形的能力。
The shear resistance of bolted joint can be obviously improved by higher ratio of bolt section to bolted joint area and inclined bolt.
倾斜锚杆加固的节理抗剪强度比垂直锚杆大，提高锚固面积比能显著提高节理抗剪强度。
Due to difficulties with quantitative analysis in theory on shear resistance of reinforced concrete composite beam, numerical simulation becomes a direct and efficient approach.
钢筋混凝土叠合梁的斜截面承载力，从理论上定量分析存在着较多困难，但数值模拟分析是一种直接有效的途径。
According to the test, the Steel-Fibre Reinforced concrete has good properties, such as stretching, shear resistance, cracking resistance, earthquake resistance and so on.
试验表明，钢纤维混凝土具有优良的抗拉、抗剪、抗裂、抗震等性能。
Their characteristics include an extremely low coefficient of friction, high resistance to pressure, very high shear stability and excellent protection against corrosion.
它们的特点包括一个非常低的摩擦系数，高的耐压力，非常高的剪切稳定性和优良的防腐蚀保护。
Furthermore, the second-order effect and shear deformation of the structures were magnified due to semi-rigid connections, the ultimate load resistance of the structures was reduced simultaneity.
半刚性连接还对结构的二阶效应及剪切变形的影响起放大作用，降低结构的极限承载力。
The results indicate that the change of membrane resistance is not active when the shear velocity amounts to a certain degree, and membrane resistance will increase…
结果表明，剪切速度达到一定值时膜阻力变化不明显，而随着压力提高膜阻力迅速提高。
Generally, it's no need to design fixture for concrete filled steel tubular columns in shear resistance expressly.
一般情况下，不需要专门为钢管混凝土柱进行抗剪配筋设计。
Axial compressive ratio is advantageous to seismic behavior of staggered joints. It can improve joints first crashing loads, shear resistance capacity and reduce the sliding displacement of beam bars.
轴压比对节点的抗震性能有利，它可以提高节点的初裂荷载、抗剪承载力、减小节点中梁筋的粘结滑移量。
Axial compressive ratio is advantageous to seismic behavior of staggered joints. It can improve joints first crashing loads, shear resistance capacity and reduce the sliding displacement of beam bars.
轴压比对节点的抗震性能有利，它可以提高节点的初裂荷载、抗剪承载力、减小节点中梁筋的粘结滑移量。
应用推荐