A sign of each line for the car is mounted to reset error of the coder.
每台机车移动线上设置一固定标志位，用于对位移编码器累计误差的清零。
This is not the same as a broken connection which would cause a connection reset error.
这与导致连接复位的错误所致的断开的连接不同。
In addition, when it is used, the error index must be reset to -1 before each parse operation; otherwise the result can be misleading.
另外，使用它时，在每次解析操作前必须将错误索引重置为- 1；否则结果将可能产生误导。
Caching failure: Forgetting to reset an error flag when an error has been corrected.
缓存失败(Caching failure)：错误被修正后忘记把错误标志复位。
And you get an error I9990301 disk failure or disk reset failed then you have to switch boot sequence and make hd1 the first boot device.
可能会产生一个错误I9990301diskfailureordiskresetfailed，这时必须切换引导次序，让hd 1成为第一个引导设备。
Prior to the processing, the local error-variables are being reset, which is inexpensive, but still costs some CPU.
在处理这条语句之前，要重新设置本地错误变量，其代价虽然不高，但仍要花费一些CPU时间。
You can resolve such problems by running the /usr/sbin/rsct/install/bin/recfgct command on the node which is named in the error message in order to reset the node ID.
为了解决这样的问题，可以在错误消息中指出的节点上，运行 /usr/sbin/rsct/install/bin/recfgct命令来重新设置节点 ID。
Press the "reset" key and deletes the zero position error caused by the shift of the zero point in the sensor.
“清零”键，清除传感器因零点飘移而产生的零位误差。
Fatal error caused a system reset: Please check the system event log for details.
致命错误导致系统重设：有关详情，请检查系统事件记录。
The trueimage interpreter was unable to reset page-level information suchas paper size or number of copies . the job printing may not be correct. the error code returned from the system was% 1.
trueimage解释器无法复位页面信息，如纸张大小或副本数。打印作业可能不正确。系统返回的错误码为%1。
Warning: a fatal error has caused system reset!
警告：致命错误导致系统重启动！
Error window can be cleared with Reset.
可以复位清除不对窗口。
For information on the link destination, refer to "4-5 Unit, ProgramNumber, and Error Reset" (page 4-62).
请参考“设备、程序号和错误复位”(4- 62页)以获得关于连接目标地的资讯。
For information on the link destination, refer to "4-5 Unit, ProgramNumber, and Error Reset" (page 4-62).
请参考“设备、程序号和错误复位”(4- 62页)以获得关于连接目标地的资讯。
应用推荐