• Working state of a screw pump rod-line is analyzed using Finite element analysis method during broken working station, and three kinds of possible mechanical models are set up.

    如何降低螺杆泵油杆应力水平,提高工作寿命石油开采设备研究个急需解决的力学问题。

    youdao

  • Due to the special structure of controlled direction well, it can lead to severe abrasion even jamming if not adopting any measure when using progressing cavity pump rod to pump oil.

    由于定向井结构特殊利用螺杆泵进行采取任何措施势必造成严重磨损甚至卡死。

    youdao

  • Other possible reasons include problems with the oil pump, rod and main bearing clearances, camshaft stopping playing, or cam bearings and lifters.

    其他可能的原因包括油泵问题轴承空隙凸轮轴停止工作或者凸轮方位和升降。

    youdao

  • Other possible reasons include problems with the oil pump, rod and main bearing clearances, camshaft end play, or CAM bearings and lifters.

    其他可能的原因包括油泵问题轴承之间空隙,凸轮轴停止工作或者凸轮方位和升降等。

    youdao

  • Inside the pump, a flexible diaphragm connects to the rocker arm though a diaphragm spring, pull rod and link.

    油泵中可变形膜片的泵膜通过膜片回位弹簧膜片拉杆摇臂相连

    youdao

  • Two pump rotor spinning rod through the implementation drive.

    两个转子通过旋转抽油杆实现驱动

    youdao

  • The corrosion and wear of rod pump well cause the damage of downhole equipment and seriously affect the normal production of oil well.

    有杆中的腐蚀磨损造成油井井下设备损坏严重影响油井正常生产

    youdao

  • The corrosion on suck rod, tubing and pump are serious, resulting pump leakage and rod broke, during exploration.

    开发过程中,出现严重的油泵抽油腐蚀和偏磨现象,造成、杆等问题。

    youdao

  • In the stage of thermal production, rod pump is used.

    热采阶段采用有生产

    youdao

  • The optimal design model of downhole pump depth and rod string assemblage is set up.

    建立深度抽油杆组合优化设计模型

    youdao

  • This paper introduces the operating principle of the combinatorial layering oil production of the rod jet pump, and the parameter optimization as well as field application.

    介绍了有射流组合分工作原理参数优选现场应用情况。

    youdao

  • The pump valve has a structure of semi-spheric plunger with guide rod, and its seat and ball are aligned by means of a spring, and it is opened and closed in time.

    泵阀件采用带导向半球形柱塞结构弹簧制动,精确控制阀阀座对中,启闭动作及时

    youdao

  • The rod pumping pump is the most important key parts of the rod pumping system.

    油泵有杆抽油装置关键部分

    youdao

  • During oil recovery by rod pump, owing to the elastic stretching and shrinking of the tubing string, the stroke loss of the subsurface pump reaches 10%.

    过程中,油管弹性伸缩油泵冲程损失10%以上。

    youdao

  • It can simulate a human expert to make analysis and design scheme mainly for four kinds of typical engineering components-pressure vessels, huge rotation constructions, pump-rod and welded structures.

    可以模仿人类专家典型工程构件-压力容器大型旋转构件,螺杆泵焊接结构进行分析设计

    youdao

  • For screw pump well, the following accidents, such as rod breaking, wax locking and pump burning, always happened.

    螺杆泵运行过程中经常出现杆柱断脱卡、现象。

    youdao

  • After calculating, the be st combination of pumping parameter and pumping rod and interval of stabilizer a nd pump efficiency are shown, which...

    通过软件计算确定出参数、抽油扶正器间距和最佳组合

    youdao

  • Reasonable rod pump string design is very important in the working course of rod pump system.

    抽油系统工作过程中,抽油杆柱合理设计非常重要的。

    youdao

  • Our company mainly product oil pump, valve guide, valve Tappet, push rod and so on.

    我们公司主要生产油泵气门导管、气门挺杆推杆

    youdao

  • According to the lifting system design theory, SAGD rod pump lifting system optimization design software was programmed and tested to design a new lifting system.

    根据举升系统设计理论编制了SAGD有杆举升系统优化设计软件利用软件优化设计了一口稠油sagd井的举升系统。

    youdao

  • The pump power distribution in the single diode directly pumped laser rod with different pumped parameters is simulated using the method of ray trace.

    采用光线追模拟计算出单个二极管不同参数直接抽运激光时,激光棒所吸收抽运光功率分布

    youdao

  • Analysis screw pump system, get the mechanical model of rod string, deduct and calculate undertaking load of rod string.

    通过对螺杆泵采油系统进行分析得到力学模型所承受载荷进行推导计算

    youdao

  • The impacts of gas compressive effects in Chambers of rod pumps on pump efficiency are exemplified through real calculation.

    通过举例计算,说明腔内气体压缩效应损失影响很大。

    youdao

  • Active water or light oil is sent downhole through hollow rod to reduce oil flow resistance, thus producing heavy oil from deep formation through screw pump.

    利用空心井筒内掺入活性降低油流阻力实现应用螺杆泵开采深层稠油

    youdao

  • In the light of the frequent breaking of the rod string in a surface driven screw pump well, the force condition of the string in the well is analyzed by means of the elastoplasticity theory.

    针对井口驱动螺杆泵油杆柱频繁问题,应用弹塑性理论分析了抽油杆中的受力状况

    youdao

  • The pump efficiency of 32% rod pumped Wells in Erlian Oilfield is lower than 30%, and increasing production centralizer is introduced to solve this problem.

    二连油田32%抽油机低于30%,为此有针对性地引进了扶正器配套工艺。

    youdao

  • The fracture of piston rod of new hydrogen compression pump is studied by metallography and electron probe in this paper.

    用金相显微镜电子探针压缩机活塞杆断口进行了分析

    youdao

  • The velocity law of polished rod acceleration is one of the most important performance of pump unit, so it is very important that how to measure it's velocity law.

    抽油机悬点运动规律抽油机工作的重要工作特性指标取其运动规律显得十分重要。

    youdao

  • The velocity law of polished rod acceleration is one of the most important performance of pump unit, so it is very important that how to measure it's velocity law.

    抽油机悬点运动规律抽油机工作的重要工作特性指标取其运动规律显得十分重要。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定