Their approach was to use a rubber film that changes thickness due to pressure, and employs capacitors, integrated into the material, to measure the difference.
他们的方法是将一块会随着压力变薄的橡胶薄膜和电容整合起来，以此测量变化。
The results show that there are obvious changes at film pressure distribution, maximum film pressure, film thickness distribution and minimum film thickness when there is misalignment.
计算结果表明，轴颈倾斜时，轴承油膜压力分布、最大油膜压力、油膜厚度分布和最小油膜厚度等都有明显的变化。
If the film surface is provided with a press cable or notochord, then make the best cut and sew with pressure cable or notochord coincide, the cable without interrupting the weld picture placement.
假如膜外表设置有压索或脊索，那么最佳使裁剪缝与压索或脊索重合，使索不至于打乱焊缝的图画安置。
There is no pressure gradient through the thickness of the film.
贯穿流体膜厚度无压力梯度。
Pressure at work, people need to stimulate you to enjoy that sense of shock time, so terrible in the film to vent the pressure has become a common way!
在工作压力大时，人们需要刺激一下，享受那一次次感官的震撼，所以以恐怖片来宣泄压力成为了一种常见的方法！
The results of calculation indicates that the static axial stiffness of fluid film in double spiral groove face seal is improved due to the pressure loss through feeding holes.
计算结果表明， 供液小孔所产生的压力损失提高了双列螺旋槽机械密封的静态轴向刚度。
In argon (ar) gas, nanocrystalline silicon films are prepared by pulsed laser ablation. The influence of ambient pressure on surface morphology of nanocrystalline silicon film is studied.
采用脉冲激光烧蚀技术在氩气环境下制备了纳米硅薄膜，研究了环境气体压强对纳米硅薄膜表面形貌的影响。
The fracture strength of circular diamond film was measured by a burst pressure technique.
利用压力爆破技术测量了圆形金刚石膜的断裂强度。
Criterion for gas flow pressure loss is presented for rotating liquid film heat and mass transfer device.
提出了旋转液膜气液传热传质设备的气体压力损失的准则关系式。
Effect of parameters on lubrication film shape and pressure distribution was analyzed for the typical working conditions of automotive wheel bearings.
针对轿车轮毂轴承的典型应用工况条件，分析工况参数对油膜压力分布和油膜形状的影响。
Reseal film, an advanced peelable technology that exposes a pressure sensitive layer when the consumer opens the package.
重新封装薄膜，先进的剥离技术，暴露了压力感应层当消费者打开包。
Meanwhile the influences of temperature and pressure upon the film growth rate of methane hydrate were also discussed.
同时考察了温度和压力对甲烷水合物膜生长速率的影响。
The three-dimentional laminar Navier-Stokes equations were solved for getting the gas film pressure and velocity distributions in the steady state, and the flow styles in the clearance were analyzed.
通过求解三维层流N-S方程，得到了端面气膜稳态压力场及速度场分布，分析了气体在端面间隙内的流动形式。
The squeeze film effects are related to pressure distribution a little.
齿面挤压膜效应对压力分布有一定影响。
Tests of pressure distribution in Squeeze film damper are performed.
对挤压油膜压力分布进行了测试。
Sapphire dome machining technology is introduced by exploring grinding tool and milling and polishing film and supplement material and machine speed and pressure etc.
分别从精磨模、精磨磨料、抛光膜层、抛光辅料、机床速度和压力等方面介绍了一种加工蓝宝石整流罩的工艺方法。
As a result, lower working pressure and higher RF power is helpful to prepare good a-C film, meanwhile, laser repetition has evident influence on films growth.
结果表明：在较低气压和较高的射频功率下制备的a - C膜质量较好，同时，激光重复频率对膜生长也有显著影响。
This paper presents a formula of the pressure of liguid film in the critical state of the unbroken liguid on the principle of hydromechanics, and discusses a design method of spring force.
该文利用流体力学的原理，建立流体膜临界连续状态的液膜压力公式，在此基础上，探讨了弹簧力的设计方法。
Various performance compensation methods have been designed according to the characteristic of the thin film pressure sensor.
针对薄膜压力传感器的特性，设计各种性能补偿方法。
The effect of a cyclone atomizing water fog film on the low pressure cyclone atomizing water nozzle is researched.
应用低压旋流雾化水喷嘴(不同运行压力和组合方式)实验研究了旋流雾化水雾膜对除尘效率的影响。
Stiffness and damping coefficients of force for film on mirror plate and moment of force for film on tilting pads are derived by making use of Taylor series expression of film pressure.
采用对油膜压力进行泰勒级数展开的方法，导出了油膜对镜板的作用力和油膜对可倾瓦的力矩的刚度阻尼系数。
The parameters such as oil film pressure, oil flux and so on are obtained from joint solution of Reynolds and energy equations of SFD.
文中根据雷诺边界条件，通过联立求解SFD的雷诺方程、能量方程得到了SFD的压力分布、滑油流量等参数。
The relationship between vapor pressure difference and rate of nutrient release from film coated controlled release fertilizer was discussed.
研究了水蒸气压差与包膜型控释肥料养分释放速率的关系。
Experimental results show that the deposition rate of silicon film strongly depends on silane pressure and substrate temperature.
实验结果表明，非晶硅的沉积速率与气室气压和基片温度密切相关。
The analysis and calculation on some structure parameters of the sensor have been done, such as the dimension of pressure sensitive film, the space length between anode and cathode and so on.
对传感器的压力敏感膜尺寸、阴阳极间距等结构参数进行了分析计算；
The paper puts forward a sort of pressure sensor made of stretch film piece and slightly bend concoct construct, which USES OTDR distributing optical fiber pressure sensor.
文章提出了一种用弹膜片和微弯调制机构进行压力传感，用光时域反射探测(OTDR)技术进行测量的分布式光纤压力传感方法。
The air bearing structure is formed by applying pressure to the film surface by negative pressure.
通过负压对膜面施加张力来形成气承结构。
In this article, author derives oil film perturbed pressure equation through expanding pressure using a Taylor Series. With exponential film assumption, analytical expression of OFSD is also derived.
本文通过对油膜压力进行二阶泰勒级数展开得到油膜摄动压力方程组，采用指数膜假定求解油膜摄动压力方程组，得到推力轴承油膜刚度和阻尼的解析表达式。
This device can make the pressure inside the oil film changed at ultrasonic frequency, which enable the specimen surface to be damaged by cavitation erosion in a comparatively short time.
该装置能使油腊中的压力以超声频率变化，从而使试样表面在较短的时间内发生气蚀磨损。
This device can make the pressure inside the oil film changed at ultrasonic frequency, which enable the specimen surface to be damaged by cavitation erosion in a comparatively short time.
该装置能使油腊中的压力以超声频率变化，从而使试样表面在较短的时间内发生气蚀磨损。
应用推荐