The PG6J80 series 6 finger gripper design utilizes a dual acting piston to open and close gripper jaws.
该PG6J80系列6手指手爪的设计采用了双动活塞来打开和关闭爪下巴。
The cycle of operation of the four-stoke engine begins with the piston at TDC and the intake valve open.
四冲程发动机的工作循环是以活塞在上止点、进气门打开为开始的。
Normal production conditions, often open the two Taiwan screw compressor and a piston compressor, mainly for converter, rolling and tropical in three production unit of gas supply.
正常生产情况下,通常开两台螺杆压缩机和一台活塞压缩机,主要给转炉、中轧和热带三家生产单位供气。
Ignition timing devices. The contact points must be timed to close and open in proper relation to the piston positions in the cylinders.
点火正时装置:触点必须能够在活塞处于气缸中相关位置时,按时关闭和开启。
Medium horsepower, open loop, axial piston pump for high performance applications.
中等马力,开环,高性能轴向活塞泵。
High horsepower, open loop, axial piston pump for high performance applications.
高马力,开环,高性能轴向活塞泵。
Also the valve heads will be liable to be burnt by the passing hot gases, and there is the likelihood of the piston crown touching an open valve, which can seriously damage the engine.
此外气门头易于被通过的热气体燃烧,这有可能使活塞频繁冲击打开的气门,使发动机严重损坏。
Normally Open: When the coil is energized, the pilot hole closed, the valve chamber and pressurized by the piston return spring throttle thrust, the electromagnetic valve is closed.
常开:当线圈通电时,先导孔关闭,阀上腔由活塞节流孔增压和复位弹簧的推力,电磁阀关闭。
Also the valve heads will be liable to be burnt by the passing hot gases, and there is the likelihood of the piston crown touching an open valve, which can seriously damage the engine.
而且气门头部容易被经过的高温气体烧蚀,活塞顶部也可能会碰到气门使发动机严重损坏。
During the intake or admission stroke, the piston moves downward as a charge of combustible fuel and air is admitted into the cylinder through the open intake valve.
在摄入或中风入院,活塞动作,作为燃料和空气中可燃负责向下是进入气缸通过公开承认,进气阀。
Adopt film cylinder in place of piston cylinder, which remove the abuse that piston ring is easily damaged and lead to not open or close valve.
采用薄膜式气缸替代活塞式气缸,排除了活塞环易损漏而导致无法启闭阀门的弊端。
When the coil power, the pilot valve by the spring return, pilot hole open, pressure relief valve on the chamber, medium pressure piston push the lower chamber, the electromagnetic valve is opened.
当线圈断电时,先导阀芯靠弹簧复位,先导孔打开,阀上腔卸压,活塞靠下腔介质压力推动,电磁阀打开。
As the piston travels upward, it pushes the spent gases out through the open exhaust valve.
活塞的上行通过排气门将废气排出汽缸外。
As the piston moves down, the vaporized mixture of fuel and air enters the cylinder through open intake valve.
当活塞下移时,汽化的燃料和空气的混合物通过进气门进入气缸。
The piston rod self-locking type gas spring end there is a needle valve open the needle valve is self-locking type gas spring can run as the free type gas spring;
自锁型气弹簧是一种可以在行程任一位置锁定的气弹簧。 在自锁型气弹簧的活塞杆端部有一个针阀打开这个针阀,则自锁型气弹簧可以象自由型气弹簧那样运行;
The piston has a single center pivot that drives each gripper jaw open and closed.
活塞有一个单一的中心枢纽,驱动每夹钳颚开启和关闭。
When the coil power, the pilot valve by the spring return, pilot hole open, pressure relief valve on the chamber, the piston on the lower chamber medium pressure to promote the solenoid valve open.
当线圈断电时,先导阀芯靠弹簧复位,先导孔打开,阀上腔卸压,活塞靠下腔介质压力推动,电磁阀打开。
When the coil power, the pilot valve by the spring return, pilot hole open, pressure relief valve on the chamber, the piston on the lower chamber medium pressure to promote the solenoid valve open.
当线圈断电时,先导阀芯靠弹簧复位,先导孔打开,阀上腔卸压,活塞靠下腔介质压力推动,电磁阀打开。
应用推荐