A Filter node is used to select only those exception conditions that we want to reprocess after a delay (the others are just sent to a Trace node).
Filter节点用于仅选择希望在延迟后重新进行处理的异常条件(其他条件将直接送到Trace节点)。
This means there may be a delay between data being committed on one node and it appearing on another node.
这意味着数据从一个节点提交之后会延迟一段时间才呈现在另一个节点。
Having analysed the delay characteristics of m type t shape node lines, its design method and technical requirements are detailedly introduced.
在分析了M型T形节延时线的延时特性基础上,对其设计方法、工艺要求等做了较详细介绍。
We also analyzed the average queue delay of MAC layer by modeling the interface queue of each node with M/D/1 model.
然后用M/D/1排队模型对每个节点的MAC层队列建模,分析了MAC层队列的平均排队延迟。
To reduce network delay, server announces the latest competitive price to active network node by active network packets.
服务器以主动信包的形式向主动节点发布最新竞价,减少网络延迟。
On this basis of that, further study for the delay performance of the edge node has been also carried out.
在此基础上,进一步研究了在不同组装算法下边缘结点的时延性能。
Traditional protocol of MANET, which has longer delay and interferes realtime transmission of information, builds a route from source node after link failure.
传统的MANET路由协议都在路由破裂后由源节点重新建路,存在较大建路延时,极大阻碍了信息的实时传送。
Absrtact: This algorithm depends on the local state of each node in the networks, searches routes that meet bandwidth and delay requirements through the selective probe method.
摘要:算法利用网络中每个节点的状态信息,通过选择探测的方法搜索满足业务带宽和时延约束要求的路由。
Balanced Application layer multicast Protocol overcomes the unbalance in node degree, distribution of flows, network delay, effect of node failure etc.
基于均衡的应用层组播协议克服了现有的应用层组播协议在节点负载、网络时延、流量分布、受失效节点影响等方面的不均衡。
Each new node can use different metrics such as number of hops, end-to-end delay, available bandwidth in selecting parent nodes.
每个节点在进行父节点的选择时,可以使用不同的标准,如路径跳数、端到端延时、端到端可用带宽。
This algorithm was based on MPH algorithm. It added the destination node to the tree step by step based on satisfying the delay constraint and increasing the multicast tree cost least.
该算法基于MPH算法的基本思想进行扩展,在满足时延限制条件和多播树代价增加最小的基础上,逐步将目的节点添加到多播树上。
The simulation results show that the designed structure reduces join and exit number of messages that each node sends and the search delay of information. It achieves good customer satisfaction.
仿真实验表明,设计的系统结构降低每个结点加入和退出时发送的消息数量,减少了信息检索延迟,取得了较好的用户满意度。
The second is that different node has different time-delay vector, and elements of each node also have different time delays.
第二种是不同的结点有不同的时延向量且每个结点的分量也有不同的时延。
Band pass filter is adopted to remove the high -frequency switching disturbance in node voltage measurements and avoid the time delay of common low pass filter.
针对开关动态对节点电压采样值的干扰,引入带通滤波,滤除高频动态的同时避免了常规低频滤波的延时。
The analysis indicated that SVC control could delay saddle-node bifurcation point and enhance voltage stability greatly.
研究表明SVC控制可以延迟系统鞍结分岔点,大大提高系统电压稳定性。
Based on the three-node multiple hops network model, it gets the largest throughput which satisfy the delay requirement through the joint distribution algorithm of power and bandwidth.
通过对三节点的多跳网络进行建模,在功率与带宽联合分配算法下,得到满足时延要求的最大吞吐量。
Based on the three-node multiple hops network model, it gets the largest throughput which satisfy the delay requirement through the joint distribution algorithm of power and bandwidth.
通过对三节点的多跳网络进行建模,在功率与带宽联合分配算法下,得到满足时延要求的最大吞吐量。
应用推荐