The model was used to analysis the effect on the drop diameter when the primary velocity of the air or the relative position between the air inlet and liquid inlet was changed.
分析气流速度、液孔与气孔的相对位置对雾化滴径的影响，模拟结果与实验结果基本一致。
Using the model, the liquid holding efficiency and pressure drop of gas lifting flow with liquid flow rate being zero was calculated.
提出了零液流量气提流动的两相流水动力学模型，应用该模型计算了零液流量气提流动的持液率和压力降。
The model is an effective method, which can be used for pressure drop of oil gas water three phase vertical upwards slug flow in which the continuous liquid phase is water phase.
本模型是计算垂直油-气-水三相弹状流中液相的连续相为水相时的压力降的有效方法。
A comparison is made for the shapes of experimental saddle point with the theoretical predictions by the liquid drop model.
实验上推出来的鞍点核形状同液滴模型的理论予示作了比较。
Qualitatively, the results are similar to that of liquid drop model.
计算结果定性地与液滴模型相似，在数值上则有一定差别。
Abstract: the fusion hindrance in heavy-ion collisions is studied in the framework of the two-center liquid drop model.
摘要：利用双中心液滴模型，我们研究了重离子反应中的熔合阻止现象。
The mass-transfer equations of the liquid-drop and liquid-film in the model are disintegrated by the method of controlled-volume. The numerical methods of solution are also presented.
采用控制容积法将模型推导出的液滴和液膜的传质方程离散化，并分别给出了其数值解法。
The mass-transfer equations of the liquid-drop and liquid-film in the model are disintegrated by the method of controlled-volume. The numerical methods of solution are also presented.
采用控制容积法将模型推导出的液滴和液膜的传质方程离散化，并分别给出了其数值解法。
应用推荐