The slag column method and the melting ratio method were used to show the relationship between the carbon materials added and the melting rate of fluxes.
采用渣柱法和熔化率法两种不同的测试方式进行了碳质材料与保护渣熔化速度的关系研究。
Weld penetration and wire melting speed of AC PMIG welding not only have relationship with welding current but also with electrode negative ratio.
交流脉冲MIG焊其焊缝熔深及焊丝熔化速度不仅与焊接电流有关，而且与负极性比率有关。
In the paper the influence of block ratio, molecular weight and structure of SIS on the mechanical properties, solution viscosity and melting flowing index of SIS were discussed.
讨论了SIS结构变量如嵌段比、分子量、分子构型的变化对SIS的机械力学性能、溶液粘度与熔融流动性能变化的影响规律。
The results showed that solidification ratio could well represent the solidification efficiency of heavy metals in different temperature phases during melting process.
研究结果表明，固定率能够较好地表征重金属在熔融过程不同温度阶段的固定情况；
No matter how the mass ratio of the raw materials changed, the melting point of the copolymers was always lower than that of the homopolyamide.
在原料的质量比互相接近时，共聚物的熔点最低，但是无论各组质量比如何变化，其熔点总是要低于本体聚酰胺的熔点。
With the increase of arm numbers of PEG, the temperature of the melting peak of dried gels and the swelling ratio of hydrogels decrease;
随着PEG臂数的增加，干胶的熔融峰顶温度下降，凝胶的溶胀比减小；
When electrode negative ratio is zero, which is using MIG welding with DC ami welding wire being positive polarity, weld penetration is maximum , wire melting speed and deposition rate are minimum;
当负极性比率等于零即直流且焊丝为正极性的MIG焊时，其焊缝熔深最大，焊丝熔化系数最小，熔敷速度最小；
In addition, high draw ratio will increase the melting point and crystallization rate of the soft segments for both types of segmented copolymers.
此外，高倍拉伸会提高上述二类多嵌段共聚物中软链段结晶的熔点和结晶速率。
The number of melting peaks was increased from 1 to 2 with the increase of draw ratio after heat treatment under relaxation and from 1 to 3 after heat treatment under partial tension or full tension.
随着拉伸倍数提高，纤维经松弛状态下热处理后，其熔融峰数目由1个变为2个；而经部分张力和张力状态下热处理后，其熔融峰数目均由1个变为3个。
Te-free memory material with adjustable crystallization temperature, melting point and crystallization activation energy can be obtained by changing the ratio of the two compositions.
通过调整这种材料中两种元素的组份，可以得到具有不同结晶温度、熔点和结晶激活能的存储材料。
Floorplans are designed following the complicated plot′s geometry to get a better ratio of profit in relationships between inner and outer space, melting the threshold between them.
楼层平面图是根据地块复杂的几何形状设计的，以获得更好的室内外关系，消除室内外之间的界线。
Floorplans are designed following the complicated plot′s geometry to get a better ratio of profit in relationships between inner and outer space, melting the threshold between them.
楼层平面图是根据地块复杂的几何形状设计的，以获得更好的室内外关系，消除室内外之间的界线。
应用推荐