The cleaning result has proved to be successful for regularly spun or high speed melt spun PET PA6 and fiber.
清洗效果表明，该方法简单、方便、见效快、效果好，可用于锦纶、 涤纶等常规或高速纺熔体管道的清洗。
The antibacterial PETPOY fiber was spun by high-speed melt-spinning method.
采用高速熔融纺丝法制备了抗菌PETPOY纤维。
Plasticized melt - spun HMWPE fiber is hard to draw to high strength because of high HMWPE content and more molecular tangle in as-spun fibers.
高相对分子质量聚乙烯的增塑熔纺，由于聚合物浓度较高，大分子缠结多，纤维超拉伸比较困难，难以达到高强度。
The research advances about texture in melt-spun ribbons was introduced in detail, focusing on the microstructures, treatment techniques and the effects of various additives.
本文介绍了熔体快淬带织构的形成机理和研究进展，着重于微观结构、添加元素以及处理工艺的影响。
Those polyamides used commercially are sufficiently stable to be spun from a melt.
这些商业用的聚酰胺在熔融纺丝过程中十分稳定。
The factors affecting full-package rate of direct-spun PET FDY were analyzed and discussed from the aspects of melt transfer and process conditions.
从熔体输送和纺丝工艺条件分析、探讨影响PET直纺FDY满卷率的因素。
The electrochemical tests indicated that the melt-spun alloys showed a good activation property and much better cycling stability, but lower discharge capacity and high-rate dischargeability.
电化学测试表明，快速凝固处理后合金的活化性能不变，循环稳定性得到显著改善，但其放电容量和高倍率放电性能有所降低。
The paper makes a manner that use of melt blown nonwoven fabric rim leftover, namely uses as internal material for gauze mask that surface material is spun bonder nonwoven.
提出熔喷非织造布边料变废为宝的方法，即将其用作面层为薄型纺粘法非织造布的口罩的内层材料。
The results showed that melt-spun structure has little effects on the final magnetic properties.
结果表明，淬态结构对退火后纳米晶合金的磁性能影响较小。
There exist obvious textures with (400) crystal plane preferential oriented crystal structure in the melt-spun alloys with different quenching rates.
在不同淬速的快淬合金中有以(400)晶面为择优取向的织构存在。
There exist obvious textures with (400) crystal plane preferential oriented crystal structure in the melt-spun alloys with different quenching rates.
在不同淬速的快淬合金中有以(400)晶面为择优取向的织构存在。
应用推荐