The maximum tensile strength of composite by dynamic injection molding is increased by 11.
与稳态注射成型的复合材料相比，动态注射成型复合材料的拉伸强度最大可提高11。
The maximum tensile strength and yield strength were gained at peak-ageing, in addition, the elongation decreased with the extension of ageing time.
峰时效时合金的抗拉强度和屈服强度达到最大值，断后延伸率随时效时间的延长有下降的趋势。
With the increasing of mass fraction of PEG, membrane porosity and pure water flux become larger, and the maximum tensile strength and elongation at break of the membrane criterion decrease gradually.
随着PEG质量分数的增加，膜孔隙率与水通量变大，最大拉伸强度、断裂伸长率等力学性能逐渐减小。
Stress concentration occurs in surrounding rocks, while the maximum tension stress is less than the tensile strength of rock mass, so tensile crack does not take place.
动荷载作用下地下硐室群围岩出现较大的应力集中，但最大拉应力小于岩体的抗拉强度，地下硐室群围岩不会出现拉裂破坏。
Tensile strength corresponds to the maximum tensile stress that may be sustained by a specimen.
抗拉强度是指样品可能承受的最大拉伸应力。
Through the assumed moving direction of the plow chain, the maximum pull point is determined, the tensile strength of the plow chain is checked, the safe coefficient of the plow chain is obtained.
通过假定刨链的运行方向，确定刨链的最大拉力点，以校核刨链的抗拉强度，得出刨链的安全系数。
It was observed that samples bleached in neutral region showed maximum copper number, mini-mum tensile strength, minimum degree of polymerization, and greatest potential damage.
可以看出经过近中性范围内漂白的样品铜值最大，强度最低，聚合度最低，并具有最大的潜在损伤。
It increased the Youngs modulus and the maximum tensile stress but it became brittle and decreased the impact strength.
老化初期， 结晶为主导因素，它增加杨氏模量、最大拉伸应力，但使材料变脆，降低冲击强度；
The maximum value of tensile strength increased by 30%, and the impact strength by 60%.
其拉伸强度最大提高为30 % ，而冲击强度则可提高6 0 %。
Tightsen structural adhesives have excellent tensile, shear and peel strength combined with maximum impact, stress and vibration resistance.
泰盛结构胶具有较强的拉伸、剪切与剥离强度，耐冲击、耐压、抗振动。
There was no significant difference int test in EMG wave amplitude, maximum tetanized systole tensile strength and duration of isometric contraction.
两侧肌电图波幅、等长收缩时最大强直收缩张力及持续时间进行自身t检验比较均无显著差异。
When the molar percentage of crosslinking agent is about 3 %, the tensile strength is maximum, the water absorption a...
当交联剂的摩尔分数约为3%时，拉伸强度最大，吸水率和浸水失重率最小。
When the molar percentage of crosslinking agent is about 3 %, the tensile strength is maximum, the water absorption a...
当交联剂的摩尔分数约为3%时，拉伸强度最大，吸水率和浸水失重率最小。
应用推荐