High no-load voltage and good ability of trust compensation.
高的空载电压及良好的推力补偿功能。
Its working principle and load voltage variation are all presented.
概述了其工作原理及负载电压变化。
The Max on-load voltage could be 45v and the Max current reached 2.69a.
试样所能承受的交流电压最高可达45v，最大电流2.69A。
No-load voltage and higher energy Thrust better compensation, a wide range of USES.
较高的空载电压和较好的能量推力补偿，用途广泛。
The square of the r. m. s . load voltage represents the power dissipated in a purely.
负载电压的平方值表明了功率消耗为阻性负载的持续温度。
The reference signal in this control approach is obtained by detecting both source current and load voltage.
该控制方式的指令信号通过同时检测电源电流和负载电压得到。
Using the proposed switch control strategy to track the references, load voltage and current are compensated.
利用上述的开关策略进行跟踪，达到对负载电压和电流补偿的目的。
The quality of transfer switch has crucial effect on the safe operation of on-load voltage regulation switch.
切换开关质量的好坏对能否保证有载调压开关的安全运行起着决定性的作用。
The setting range of no load voltage step response index for self excited shunt excitation system is put forward.
对自并励静止励磁系统发电机空载阶跃指标提出整定范围。
With short circuit protection, over current protection, the load voltage protection protection and multiple protection.
具有短路保护、过电流保护、过负载保护以及电压保护多重保护。
The paper analyzes briefly the basic operation principle of a series APF and proposes a control approach of detecting its load voltage.
简要分析了串联型电力有源滤波器（APF）的工作原理，提出了一种负载电压检测控制方式，给出了其主电路的参数设计方法。
The cause of over standard acetylene content in a SZZ-3150/40 on-load voltage regulator is found out by chromatogram analysis and no-load test.
对一台SZZ-3150/40型有载调压装置进行色谱分析及空载试验，找出该装置乙炔含量超标的原因。
The principle, main design point and no load voltage ratio calculation method of resin insulation dry-type grounding transformer are introduced.
介绍了树脂绝缘干式接地变压器的工作原理、设计要点及空载电压比的计算方法。
The improvement of no-load voltage waveform is an important problem for design optimization of generators and ensuring the quality of electric power.
改善空载电压波形是发电机优化设计、保证电能质量的重要问题。
Analyzed failing cause of mode-frequency to load voltage drop for generating set, provided regulated method of cable voltage-drop compensation device.
分析了发电机组中频加载掉电压故障发生的原因，提出了电缆压降补偿装置调整方法。
A new method for islanding detection is presented, and the status of the islanding can be detected by the change of the frequency of the load voltage.
提出一种利用无功补偿技术进行并网发电系统孤岛检测的方法，通过对负载电压频率的判断即可有效检测是否进入孤岛状态。
The same time capacitor C3 is disconnected from the ground so that the load voltage ripple on capacitor C4 does not influence the gate voltage of IGBT Q2.
同时断开电容器C3与地的连接，由此电容器C4上的负载电压波动不会影响IGBTQ2的栅极电压。
In some cases, the need to use a variety of load voltage, but also used for DC-DC inverter, 24vdc power if converted to 5vdc power (note, not a simple step-down).
在某些场合，需要使用多种电压的负载时，也要用到DC - DC逆变器，如将24vdc的电能转换成5vdc的电能(注意，不是简单的降压)。
The theory and method of analyzing the no-load magnetic field of military portable generator and simulating its no-load voltage based on ANSYS program were explained in detail.
详细说明了利用ANSYS有限元分析软件分析军用移动电源的空载磁场，仿真其空载电压的理论基础和实现方法。
Load voltage and short circuit current can be used to determine the batterys instantaneous ohm internal resistance and to judge whether the course of assembling batteries was normal.
根据负荷电压和短路电流可知电池瞬间欧姆电阻，从而判断电池装配过程是否正常；三参数与电池容量均无明确关系。
To single phase SCR bridge rectification circuit of constant potential instrument, the expression of load voltage is derived and harmonic component of load voltage is analyzed in detail.
文中针对船用恒电位仪单相可控桥式整流电路，推导了负载电压表达式，分析了负载电压的谐波组成；
A new conception of power per unit impedance is defined and the basic equation to express the variation of load voltage magnitude with the variation of its dynamic equivalent impedance a.
定义了单位阻抗功率的新概念，推导了电压幅值随其等值阻抗和单位阻抗功率变化而变化的基本方程序。
Based on guaranteeing reactive power equilibrium of the system, only the voltage regulation assisted by on - load voltage regulation can make the deviation of voltage keep in allowable scope.
在保证系统中无功功率平衡的基础上，辅以有载调压等措施调整电压，才可使电压的偏移保持在允许范围内。
For quickly and accurately calculating no-load voltage waveform of harmonic excitation synchronous generators and common synchronous generators, a new method, named as tooth flux method, is proposed.
为了快速准确计算谐波励磁同步发电机和普通同步发电机的空载谐波电压，提出一种齿磁通法计算谐波电压。
To monitor the output voltage, a voltmeter is connected in parallel with the load resistance.
为了监测输出电压，将一个伏特计与负载电阻并联在一起。
It has excellent output stability by following up the variation of input voltage and connected load, they almost can't be damaged in normal use.
它遵循了输入电压和负载变化连接良好的输出稳定，他们在正常使用下几乎不会有损坏。
It has excellent output stability by following up the variation of input voltage and connected load, they almost can't be damaged in normal use.
它遵循了输入电压和负载变化连接良好的输出稳定，他们在正常使用下几乎不会有损坏。
应用推荐