Numerical solutions of discharge voltage and current pulses on each capacitors and laser tube in the circuit are in good agreement with the experimental ones.
数值求解了电路中各电容器和激光管的放电电压和电流脉冲波形，得到了与实测波形一致的模拟结果。
Output characteristics were tested under two diluent injecting methods on a single tube discharge excited infrared multi-band chemical laser by taking DF as a typical case.
以DF为例，在一台单放电管电激励红外多波段激光器上测试了两种稀释剂注入方式下激光器的输出特性。
A novel heater with a metal pipe was designed which is used encircling the discharge tube of a CuBr laser, resulting in homogeneous distribution of axial temperature.
设计了一种新颖的金属筒式加热器，使气体激光放电管轴向温度分布均匀。
Experiment has showed that the uniformity of discharge of fast axial flow CO_2 laser can be improved by a multiple electrode system and a fluid introducing tude in front of the discharge tube.
实验表明，采用多电极和在放电管的入气端加一整流管能有效改善快速轴流CO_2激光器的放电均匀性。
In this laser the discharge tube with an inside diameter of 8mm and discharge length of 300mm is made of water-cooled segmented aluminium disks.
该激光器以水冷分段铝片组成放电管，内径8毫米，有效放电长度300毫米。
The discharge current pulse of the laser tube obtained by simulation is consistent with that of experimental measurement on the same condition of circuit parameters.
在相同电路参数时，经模拟得到的放电管电流脉冲波形和实测的波形相一致。
The optimum input power density is presented by analyzing and calculating the discharge tube gas temperature of a 100 W copper vapor laser to avoid the "black center of beam".
本文讨论了大口径铜蒸汽激光放电的纵向阻抗，给出了阻抗的解析表达式，具体计算了大口径铜蒸汽激光的放电感和电容。
The optimum input power density is presented by analyzing and calculating the discharge tube gas temperature of a 100 W copper vapor laser to avoid the "black center of beam".
本文讨论了大口径铜蒸汽激光放电的纵向阻抗，给出了阻抗的解析表达式，具体计算了大口径铜蒸汽激光的放电感和电容。
应用推荐