• Instantaneous compressive load weakened durability of LWAC, which related with magnitude of instantaneous compressive load.

    瞬时载荷使轻骨料混凝土耐久性降低,降低幅度瞬时载荷水平有关

    youdao

  • A new method is proposed, based on the instantaneous reactive power theory, to detect high frequency harmonic current and instantaneous reactive current applying high pass filter simultaneously.

    基于瞬时功率理论提出了一种应用高通滤波器同时检测谐波电流无功电流的方法

    youdao

  • Instantaneous center of rotation-velocity vector method is the integration of instantaneous center of rotation analysis and velocity vector method.

    分析速度矢量法相结合心—速度矢量较转化机构法更为清晰、明了、直观。

    youdao

  • Based on instantaneous power analysis, an instantaneous power control method of permanent magnet synchronous machine (PMSM) is proposed in this paper.

    基于电机输入瞬时有功无功功率分析提出一种新的永磁同步电机瞬时功率控制方案

    youdao

  • The statistical characteristics of the instantaneous polarization projections (IPP) of partially polarized waves are studied on the basis of the theory of instantaneous polarization.

    电磁波极化理论基础研究了部分极化波的瞬态极化投影统计特性

    youdao

  • The appearances of BSRs oon near-offset profile, stacked profile, migration profile, migration profile, instantaneous amplitude profile and instantaneous phase profile are compared and described.

    比较近炮检距剖面叠加剖面、偏移剖面、瞬时振幅剖面瞬时相位剖面上BSR显示特征。

    youdao

  • Simulations of the two algorithms corresponding to instantaneous optimal control are carried out, and comparison between the two algorithms and instantaneous optimal control algorithm is done.

    对基于瞬时控制两个算法进行仿真分析且与瞬时最优控制进行了比较

    youdao

  • Some numerical results have been obtained for the instantaneous sheath thickness, the instantaneous voltage and the ion flux density on the substrate, etc.

    采用数值方法模拟出鞘瞬时厚度及极板的瞬时电位变化、鞘层内离子密度电场强度等物理量的时空变化。

    youdao

  • The relation between instantaneous acceleration power spectrum and instantaneous displacement power spectrum is presented.

    建立非平稳随机响应瞬时加速度功率瞬时位移功率谱之间的关系;

    youdao

  • The creep behavior of LVL was similar to that of wood. However, the instantaneous recovery of LVL specimens, measured after load removal, was less than the instantaneous deflection.

    LVL蠕变特性曲线同木材相似瞬时挠度一般大于瞬时弹性恢复值;

    youdao

  • In addition, results of the linear regression for stress and instantaneous strain show that the instantaneous axial strain and axial load approximated to grow proportionally.

    另外应力瞬时应变线性结果表明,瞬时向应变与轴向荷载近似成比例增长。

    youdao

  • There are two ways to emerge instantaneous over voltage in the side of low voltage which are thunderstruck and instantaneous process of electronic network.

    低压态过电压形成雷击电子暂态过程两种途径

    youdao

  • The time constant and instantaneous efficiency of the feed-tube solar air heater were tested on the solar irradiance. The equation for instantaneous efficiency was obtained at the different flow rate.

    自然辐照条件下测试了内插管式空气集热器时间常数效率得到了不同流量瞬态效率方程

    youdao

  • According to the proper hypothesis, a three-dimensional radiation and convection-coupled instantaneous heat transfer problem was simplified into one-dimensional instantaneous heat transfer problem.

    根据合理的假设,将复杂的三辐射对流耦合导热问题简化态导热问题。

    youdao

  • The PLL system could obtain basic component of the input, track the instantaneous phase of basic component, and output instantaneous Angle frequency.

    方法通过一个改进相环系统实时跟踪输入信号基波瞬时相位输出基波瞬时角频率,进而得到输入信号基本频率估计

    youdao

  • Three features parameters derived from the instantaneous amplitude, instantaneous phase, instantaneous frequency and power spectrum of analogue modulated signals are presented in this article.

    首先介绍信号幅度相位频率功率等特性中提取特征参数,应用这三种参数采用人工神经网络模拟调制信号进行了识别。

    youdao

  • This paper sets up an instantaneous cutting force model for a spiral cylinder cutter by analyzing the linear relationship between micro-unit milling force and instantaneous uncut chip thickness.

    应用微分几何理论,给出圆锥螺旋铣刀几何特性,据此导出了三维非线性铣削模型,继而采用非线性规划识别切削力系数。

    youdao

  • This paper sets up an instantaneous cutting force model for a spiral cylinder cutter by analyzing the linear relationship between micro-unit milling force and instantaneous uncut chip thickness.

    应用微分几何理论,给出圆锥螺旋铣刀几何特性,据此导出了三维非线性铣削模型,继而采用非线性规划识别切削力系数。

    youdao

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定