The input bias current flows at the instrument input due to internal instrument circuitry and the internal bias voltage.
仪器内部电路和内部的偏移电压会在仪器的输入端引起输入偏置电流。
The upper and lower limits of the rated power input or rated current shall be marked on the appliance so that the relation between input and voltage is clear.
额定输入功率或额定电流的上限值和下限值应标在器具上，以使得输入功率与电压之间的关系是明确的。
Because you need both a voltage source and a ground in order to create a complete circuit, you need to have a sourcing input or output connected to a sinking output or input.
因为在一个完整的电路中必须有一对电源和地。
Again, consider using AMPLIFIERs that exhibit a smooth input bias current transition throughout the applied input common-mode voltage.
再者，所用的放大器也要考虑在加到输入端的整个共模电压(范围内)输入偏置电流转换保持平滑。
With voltage measurements, the input current is ideally zero; thus, any input current represents an error.
对电压测量来说，理想的输入电流应为零，所以，一切输入电流都代表误差。
It is a voltage-controlled device with high input impedance, which makes it possible to control higher output power with a lower input voltage.
它具有输入阻抗高、电压控制和用低压控制大功率输出的特点。
To reduce the inductor and the phase displacement between the input current and the input voltage simultaneously, Multi-level (ML) converters are adopted as the PFC topologies in this thesis.
为了同时减小电感和输入电流与输入电压间的相位差，本文提出采用多电平变换器作为PFC变换器的拓扑。
The result is quiet perfect, the input current follows the input voltage very well.
控制效果好，输入电流波形很好地跟踪输入电压波形；
The input and output voltage ratings, VI and vo, may be exceeded if the input and output maximum clamp-current ratings, IIK and IOK, are observed.
如果观察输入和输出最大箝压电流额定值IIK和IOK，会发现输入和输出电压额定值VI和VO已经可能超过。
However if the active clamp flyback converter is designed to operate in CCM, and the duty cycle is controlled to make the input current track input voltage, the input power factor can be improved.
但如果设计反激有源箝位电路工作在电流连续模式，控制占空比，使输入电流跟随输入电压，可以提高输入功率因数。
One disadvantage of this method of stabilization is the additional output noise and offset voltage caused by increased amplification of input-referred voltage noise and input offset voltage.
这种稳定方法的一个不足是：输入端的有关电压噪声和失调电压增大会额外地增加输出噪声和失调电压。
This thesis analyzes the zero-crossing distortion, and points out that the major causes are the inductor and the phase displacement between the input current and the input voltage.
本文对产生输入电流过零畸变的各种原因进行了定量分析，指出电感和输入电流与输入电压间的相位差是影响高频输入下输入电流过零畸变严重的根本原因。
The first stage circuit receiving the first reference voltage input, while the second input to receive input signals.
第一级电路的第一输入端接收参考电压，而第二输入端接收输入信号。
For any normal input, the circuit's output voltage, VOUT, equals its input voltage, VIN.
对于任何正常输入，电路的输出电压VOUT等于其输入电压VIN。
This integrated circuit control the frequency and pulse width of the high voltage IC output signal conveniently by adjusting the input date of IC digital input port.
该集成电路通过对数字输入端口的输入数据的调节，灵活的控制了高压开关集成电路输出信号的频率和脉宽。
In essence, the aim of PFC is to make the input terminal of electrical equipment appear resistive to the AC line, and insure that the input current be proportional to the instantaneous line voltage.
从本质上来讲，功率因数校正的目的是使用电设备的输入端口对交流电网呈“纯阻性”，保证输入电流和电网电压随时成正比。
If the Load is less than half of the Rated Power, then the input voltage can be the universal input voltage.
如果实际负载是额定输出功率的一半，则输入电压可以是通用输入电压。
The first one is based on keeping the input current vector in phase with the input voltage vector.
第一种控制策略使输入电流矢量与输入电压矢量保持固定偏置角。
The effects of actuating frequency, proportional valve input voltage and MR damper input current on the vibration characteristics of seat were experimentally studied.
试验研究了激励频率、比例阀输入电压及磁流变减振器输入电流对座椅振动特性的影响规律。
As the charge exerted from input voltage source is dependent on quantization error and input noise voltage to a large extent, the circuit has high signal input impedance.
由于提取自输入电压源的电荷很大程度上仅取决于量化误差与输入噪声电压，所以电路具有高信号输入阻抗。
The parts have a standard voltage input, which together with the differential reference input allows easy interface to an external temperature sensor, such as an RTD, thermistor, or diode.
两款器件都有一个标准电压输入，当与差分基准电压输入结合使用时，可方便地与一个外部温度传感器(如rtd、热敏电阻或二极管等)接口。
Harmonic content of the input currents depends on the rectifier voltage gain m defined as ratio of the output voltage and the input line voltage as well as the employed control.
输入电流的谐波量有赖于整流器的电压获取值m，即输出电压和输入电压的比值，也有赖于操作人员的控制。
The standby input power should no more than0.5Wunder the rated input voltage condition.
在额定电压输入情况下，待机功耗不大于0.5 W。
The voltage comparator circuit using neural circuit as basic unit includes an either-or circuit with two input ends and one control end for selecting one of two input signals of comparator;
本发明公开了一种以神经元电路为基本单元的电压比较器电路，它包括：一具有两个输入端和一个控制端的二选一电路，用于选择比较器的两输入信号之一；
For a high input voltage converter, a topology of input-series-output-parallel (ISOP) can be adopted.
高输入电压的变换器可以采用一种输入串联输出并联的拓扑。
The standby input power should no more than 3W under the rated input voltage condition.
在额定电压输入情况下，待机功耗不大于3W。
The main switches will connect supply input with output in 1x mode until the output voltage has decayed to less than or equal to the voltage at the supply input.
当输出电压衰减到等于或小于电源电压时，输出电压端将连接到电源电压上；
This paper analyzes input voltage sharing control theory of input-series output-parallel(ISOP) inverter.
高输入电压的变换器可以采用一种输入串联输出并联的拓扑。
This paper analyzes input voltage sharing control theory of input-series output-parallel(ISOP) inverter.
高输入电压的变换器可以采用一种输入串联输出并联的拓扑。
应用推荐