Imported high temperature pump with high pressure, low noise and outstanding stability.
采用进口高温型泵浦，压力高，噪音低，稳定性好。
The result can give us a useful guidance for the design and use of high temperature pump use tandem arrangement mechanical seal.
计算结果能够为高温泵用串联式机械密封的设计和使用提供有益指导。 …
So choose stainless steel high viscosity pump is must indicate the specific temperature, and medium lubricity.
所以选择不锈钢材质的高粘度泵是一定要注明具体的使用温度，及介质的润滑性。
For high and low alarms, overfill protection, pump control, including wide pressure and temperature requirements, and hygienic applications.
对于高，低报警，溢流保护，泵控制，包括宽的压力和温度的要求，和卫生应用。
PEEK housings and pump heads contribute high stiffness and temperature and chemical resistance.
PEEK外壳和泵压头有助于高刚度，温度和耐化学性。
Water-ring vacuum pump usually gets steam-erosion in summer due to high temperature of working-water, which affects its safe and steady operation.
水环式真空泵在夏季往往因工作水温度高发生汽蚀，影响设备安全稳定运行。
High temperature oil pump with self heat radiating system, do not require water for cooling pump body, simple structure, smaller size, cost, performance is very reliable.
高温油泵采用自热散热系统，不需要用水来冷却泵体，结构简化，体积变小，运行成本降低，性能却非常可靠。
The turbine will operate at high temperature and high rotational speed, its pump will work under the conditions of lower or normal temperature, high pressure and high rotational speed.
涡轮在高温、高转速下工作，泵在低温或常温、高压、高转速下工作。
But there are some shortage of ordinary single-stage heat pump in low-temperature environment, such as high compression ratio, devoid heating power and low efficiency.
但普通单级空气源热泵热水器在低温环境下运行中存在压缩比过大、制热量不足和制热效率太低等问题。
These units use a high flow pump to circulate high temperature oil through the process. A heater elevates the temperature of the oil.
这些装置使用的高流量泵使整个过程中高温的油循环。
Based on the performance experiment on the new refrigerant HTR01 and the data analysis, a large-scale machine of medium-high temperature heat pump could be designed.
通过对新工质HTR01的大量热工性能试验，以及对试验结果的误差和性能分析，为中高温水源热泵大型样机的设计提供了基础。
Therefore, the research and experiment of high temperature resistance rubber screw pump have been conducted.
针对这一问题，开展了耐高温橡胶螺杆泵的研究与试验。
Die from the back of high temperature water through the pipe back to mold temperature machine, the pump pressure delivered to the heater, the heating tube is sent to die, so the cycle.
从模具囬来的高温水经过管路囬到模温机，经泵浦加压后输送到加热器，通过电热管加热送至模具，如此循环。
The advantages and shortages of high pressure and normal temperature, magnetic driving centrifugal pump and canned-motor pump were elaborated.
阐述了高压常温法、磁力驱动离心泵和屏蔽泵的优缺点。
At the same time, because of structural limitations, steering pump on a typical installation in the vehicle next to the engine, the ambient temperature very high, thus turning more serious heat pump.
同时，由于受结构的限制，转向液压泵在整车上一般安装于发动机旁，环境温度很高，因而转向液压泵发热更为严重。
Water source heat pump (WSHP) replaces cooling towers with underground constant temperature water, and has the characteristics of high efficiency energy-saving.
水源热泵用地下恒温水源代替冷却塔，具有高效节能的特性。
In the course of running of high-power magnetic driven boosting water injection pump, the magnetism of the permanent magnet may vanish at high temperature.
针对大功率磁传动增压注水泵在使用过程中存在的永磁体高温失磁等问题，分析了磁力传动器损坏的主要故障原因。
The concept of Associated Coefficient of Performance was presented, and the feasibility of air-conditioning system assisted by medium-high temperature heat pump was analyzed.
提出了联合性能系数的概念，分析了利用中高温热泵辅助太阳能空调系统的可行性。
The oil pump is high temperature resistant high temperature oil pump.
进口高温油泵就是耐高温的油泵。
If the pump noise at work, this is often due to low oil temperature, oil viscosity is too high, the oil into the air, or pump coupling loss causes such as excessive wear and tear.
假如泵在工作时产生噪音，这往往是因油温太低，油液粘度太高，油液中进入空气，联轴节失中或泵过度磨损等原因引起。
Two-stage heat pump system is an important research direction which can acquire high temperature working fluid.
双级热泵系统是获得高温工质的一个重要研究方向。
ATC, temperature sensor failure cutoff and alarm, high-temperature cutoff and low temperature alarm, blocked pump motor, auto-restart after power failure and run-dry protection.
数显温度校正，传感器异常保护和报警，高温保护和低温报警，泵马达堵转，停电恢复，防干烧。
The experimental study for moderate and high temperature heat pump working fluids had been done in the improved test system.
在改进后的实验台上，进行了中高温热泵工质循环性能实验研究。
Failure cause of mechanical sealing of high temperature screwed pipe for GA123A pump is analyzed. It is showed that the causes of the sealing failure are scale deposit and carbon laydown in pipe.
对GA123A泵的高温波纹管式机械密封的失效原因进行了分析，证实热油泵的密封故障是由于波纹管内侧水垢和积碳引起。
With the change of environmental temperature, the air sourced heat pump water heater will frost in winter and the low pressure will be too high in summer.
随着环境的变化，热泵热水机将出现冬季结霜，夏季出现低压压力过高的现象。
Wine pump, self suction pump, axial flow pump, starch pump, high temperature concentrated slurry pump, detachable piping pump, valve fittings etc.
酒泵，自吸泵，轴流泵，淀粉泵，高温浓浆泵，便拆式管道泵，泵阀配件等。
The pump are widely used into transport clean and grain liquid, the liquid of low or high temperature, medium or correction liquid.
该泵广泛适用于输送清洁或含有颗粒的液体、低温或高温的液体、中性或有腐蚀性的液体。
Both the primary helium circulator for high-temperature gas-cooled reactor (HTR) and the primary pump for the pressurized-water reactor are the key components in the reactor primary loop.
高温气冷堆主氦风机与压水堆主泵一样，均为反应堆一回路的关键设备。
Both the primary helium circulator for high-temperature gas-cooled reactor (HTR) and the primary pump for the pressurized-water reactor are the key components in the reactor primary loop.
高温气冷堆主氦风机与压水堆主泵一样，均为反应堆一回路的关键设备。
应用推荐