This means that wear is evenly distributed over the gears since each tooth on one gear touches on the other gear the same number of times.
这就意味着，由于一支齿轮上的每一个齿面将与另一个齿轮的齿面接触相同的次数，因此磨损面均匀的分布于齿轮的每一个齿上。
Gear tooth thickness at the site are unilateral wear, so gear can be rotated 180 degrees to use.
齿轮在齿厚部位都是单侧磨损，所以可将齿轮翻转180度使用。
Gear tooth face serious wear new gear should be changed, if only gear at both ends of the plane wear, can be in surface grinding machine on grinding repair light.
齿轮齿面严重磨损时应更换新齿轮，如果只是齿轮的两端平面磨损，可在平面磨床上磨削修光。
The parabolic gear is characterized by a new-type tooth profile, which may ensure very great load rating and fairly good unyielding, anti-sticking and wear - resisting properties.
抛物线齿轮是我们新近研究出来的一种新齿廊，它具有很高的抗接触、抗弯曲、抗胶合与抗磨损的能力。
This paper introduces the methods of diagnosing the tooth-wear through the spectrum analysis of gear noise.
本文探讨了用齿轮噪声频谱分析来诊断齿轮磨损程度的方法。
Further study on the correlation was provided that the changes of vibration signal were more sensitive than the changes of wear when the tooth surfaces of the gear broke down.
进一步关系研究发现，齿面发生故障时，相比磨损故障变化，振动信号反映故障的变化更敏感。
Fuel pump (unloading pump, high viscosity pump, asphalt pump) gear wear and tear parts mainly is the tooth meshing, involute face and gear ends plane.
燃油泵(卸油泵，高粘度泵，沥青泵)齿轮的磨损部位主要是齿的啮合、渐开线工作面和齿轮两端平面。
Fuel pump (unloading pump, high viscosity pump, asphalt pump) gear wear and tear parts mainly is the tooth meshing, involute face and gear ends plane.
燃油泵(卸油泵，高粘度泵，沥青泵)齿轮的磨损部位主要是齿的啮合、渐开线工作面和齿轮两端平面。
应用推荐