The temperature behavior of the forward voltage VF of the P-N junction is discussed.
本文讨论了低温下P -N结的正向电压降v _ F随温度t变化的特性。
The two tests susceptible to junction heating are the forward voltage and leakage current tests.
对结发热最敏感的两种测试是正向电压测试和漏电流测试。
The crosstalk is overcome by using forward voltage on inactive rows and inverse voltage on inactive columns.
通过在未选中行上施加正向偏压、未选中列上施加反向偏压的方法，有效地抑制了交叉效应。
The Source-Measure Unit can also test other diode parameters, including forward voltage drop and breakdown voltage.
源-测量单元还可以测量其它的二极管参数，包括正向电压降和击穿电压。
So, how to improve the tradeoff relationship between turn-off time and forward voltage is a key problem in power devices.
因此，提高开关速度并改善正向导通电压和关断时间的折衷关系是这类器件的关键问题之一。
R5 and R8 set a small bias level to reduce the otherwise quite wide neutral deadband caused by the forward voltage drops of the 1n4148's.
R5的和r8设置一个小的偏见水平，以减少，否则相当广泛中立的死所带来的正向电压下降的1n4148的。
The SourceMeter instrument first performs the necessary DC tests, such as forward voltage, reverse breakdown voltage, and leakage current.
源表首先进行必要的直流测试，例如正向偏压、反向击穿电压和漏流。
It can be used to measure the luminous intensity, forward voltage, reverse current of each luminous dot in all kinds of LED luminous dot matrix.
能测试各种LED发光矩阵每个发光元的发光强度，正向压降和反向电流。
This paper analyses the blocking voltage, forward voltage drop, photoresist mask design and gate-triggering and dynamic characteristics of high-power thyristors.
本文对大功率可控硅的阻断电压问题、正向压降问题、光刻掩模板的设计问题、控制极特性问题以及动特性问题进行了分析。
If a forward voltage is applied to the thruster before this interval has passed, the device may prematurely turn on and damage to the device and circuit could result.
如果在这间隔时间结束之前加一正向电压到半导体闸流管，设备可能过早地启动，并可能导致设备和电路损坏。
During t1 a reverse voltage must be maintained across the thruster and only after this time is the device capable of blocking a forward voltage without going into its on-state.
在t1期间，通过半导体闸流管维持一反向电压，并且正是在这之后，设备易于保持一正向电压，而无需开启电源。
In this paper, the mechanism of harmonic increments caused by device characteristics are analyzed in detail, and the compensation algorithm of a forward voltage drop is proposed.
该文详细分析了由器件特性引起的谐波增大的机理，提出了管压降补偿的方法。
In this paper, integral diode solar cell array for space use are presented. The forward voltage drop of the diode is related to its area and the rule of thumb equations are - given.
本文报道了空间太阳电池方阵中使用的整体二极管太阳电池，其二极管的正向压降与面积有关，并可由半经验公式表示。
The mechanism of harmonic increments caused by power device forward voltage drop and DC-link capacity voltage variety are analyzed in detail, and the compensation algorithm are proposed.
对由励磁电源管压降所产生的谐波和变频器直流电容电压波动的问题进行了详细的分析并提出了改进方法。
Introduces the constitutes of low voltage protection system of distributing transformer, analyzes the failure reason, puts forward concrete measures of improving low voltage protective reliability.
介绍了配电变压器低压保护的组成，对故障原因进行了分析，提出了提高低压保护可靠性的具体措施。
The setting range of no load voltage step response index for self excited shunt excitation system is put forward.
对自并励静止励磁系统发电机空载阶跃指标提出整定范围。
The paper puts forward a new method to measure series battery voltage, mechanical relay is replaced by photoelectric relay to select each battery voltage.
提出一种串联电池组电压测量新方法：光电继电器取代机械继电器选通各节电池电压；
An experiment circuit to simulate primary voltage of HF switching transformer is put forward.
还提出了模拟高频开关变压器初级电压的实验电路。
A method of keeping neutral point potential balanced based on three-level SPWM had been brought forward, which can improve output waveform and decrease the possibility of IGCT's over-voltage.
提出了一种基于三电平spwm调制的中点电压抑制方法，在改善输出波形质量的同时，有效的降低了IGCT过电压的危险。
By analyzing the basic influence of the "dead-time effect" acting on the output voltage of SVPWM inverter, the concept of the dead-time voltage vector is put forward in this paper.
在分析死区效应对SVPWM输出电压影响的基础上，提出死区电压矢量的概念，给出死区电压矢量的求取方法。
This paper puts forward a voltage and current double closed-loop controlling method based on three-phase voltage source PWM inverter.
提出了一种基于三相电压型PWM逆变器的电压电流双闭环控制方法。
This circuit has the character of the flyback converter as well as the forward converter, single voltage output can be achieved by one transformer.
这种变换器综合了正激和反激变换器的特点，并且只用一个变压器实现了单路电压输出。
The article analyzes the principle and influencing factors of flicker, and the compensation devices are put forward to suppress voltage fluctuation and flicker effectively.
分析了风电场闪变产生的原理和影响因素，指出依靠补偿装置可以有效抑制电压波动和闪变。
Silicon power rectifier diode. Cathode to case. Repetitive peak reverse voltage 800v. Average rectified forward current 25a.
硅功率整流二极管。阴极情况。重复峰值反向电压800v。平均整流电流25a。
A formula for short current calculation in low voltage power grid distribution was put forward.
提供了一般低压配电网主电源侧短路电流计算的公式。
Plastic silicon rectifier. Max recurrent peak reverse voltage 1600 V. Max average forward rectified current 1.0 a.
塑料硅整流。经常性最大峰值反向电压1600五，最大平均整流电流1.0A。
Single phase bridge rectifier. Maximum recurrent peak reverse voltage 200 V. Maximum average forward rectified current 1.0 a.
单相整流桥。经常性最大峰值反向电压200五，最大平均整流电流1.0 A。
With a typical fault analysis about the produce mechanism of resonance over-voltage, some practical restrain measures are put forward.
以一起典型事故分析谐振过电压的产生机理，并提出一些具体实际的抑制措施。
With a typical fault analysis about the produce mechanism of resonance over-voltage, some practical restrain measures are put forward.
以一起典型事故分析谐振过电压的产生机理，并提出一些具体实际的抑制措施。
应用推荐