The current in the post-flame zone appears at the temperature about 2000K for different electrodes location.
不同位置测量的离子电流焰后区信号开始出现时所对应温度值均在2000K左右;
The enhancement in vaporization rate evidently depends on the radial location of the vapour decomposition flame zone.
汽化率的增加显然取决于蒸汽分解火焰区的径向位置。
The enhancement in vaporization rate evidently depends on the radial location of the vapour decomposition flame zone .
汽化率的增加显然取决于蒸汽分解火焰区的径向位置。
Based on the conception of zonal method, the total radiant exchange area for flame zone to surface zone of the diesel in-cylinder was derived.
从段法基本概念出发,推得了柴油机缸内火焰段对整个缸壁段的辐射全交换面积计算式,并以此为基础给出了缸内辐射传热的单区段法模型。
The fire zones are generally divided into five zones: flame zone, high temperature thermal plumes zone, fresh air supplement zone, transitional zone and "inert zone".
一般可分为燃烧区、新鲜空气补充区、烟气流区、过渡区和火焰后面的“惰化区”五区。
The first, after ignited, the flame spreaded along the flammable zone before igniting.
首先,着火后火焰是沿着点火前的可燃区域迅速蔓延的。
This kind of flame always has at blood zone some places in the plain sell.
这种火焰在血域平原一些地方都有得卖。
The blade-type swirlers have been used in many air engine combustors to control the primary airflow of flame tube and establish a strong recirculation zone.
航空喷气发动机燃烧室中广泛采用叶片涡流器来控制火焰筒的一次空气流量,并建立强回流区。
In this paper, a notion that there is steady recirculating zone in the flow field of asymmetry bluff-body is presented, based on the foregone mechanism of flame stab.
本文在钝体燃烧器稳燃机理研究方面已具有较好基础的前提下,提出一种设想:在非对称钝体的流场中具有稳定的回流结构。
The high temperature zone is at inner side of OH zone for the diffusion flame, but both zones are approximately at the same position for the premixed flame.
对于扩散火焰,高温区在OH带内侧;而对于预混火焰,二者基本一致。
For the three-zone model, a set of coupled correlations has been derived to describe the effect of pressure and temperature on the laminar burning velocity and the laminar flame thickness.
对于三区模型,加上相关的衍生了一套描述的压力和温度的层流燃烧速度和火焰层厚度的影响。
The test results show that the flame cutting heat affected zone is wider than machining and lower in hardness.
结果表明,火焰切割试样焊接接头的焊接热影响区比机械加工试样焊接接头的焊接热影响区宽,硬度低;
The test results show that the flame cutting heat affected zone is wider than machining and lower in hardness.
结果表明,火焰切割试样焊接接头的焊接热影响区比机械加工试样焊接接头的焊接热影响区宽,硬度低;
应用推荐