The results show that RE-Al alloying can improve the hardness, the strength and the oxide film density of the piercing plug.
研究结果表明,稀土铝合金化可提高材料的硬度、强度及氧化膜的致密度。
To revise the effects from fatigue extent of automatic developing solution on the film density by way of measuring density change of the brain ct films.
通过观测CT照片密度变化,缩小自动冲洗套药疲劳度对CT照片密度的影响。
This article discusses the test methods of dry film density, solvent content, and weight loss during baking of the cathodic electrophoresis paints, as well as the influencing factors.
对阴极电泳漆的干膜密度、溶剂含量、烘干减量的测试方法、影响因素进行了探讨。
Current density: unit under the plating area under current, usually the higher current density film thickness is thicker, but is high coating will scorched thick dry.
电流密度:单位电镀面积下所承受的电流,通常电流密度越高膜厚越厚,但是过高时镀层会烧焦粗燥。
However, the pixel density of the film can be straightforwardly reduced by fabricating smaller array spacing and a smaller antenna size, as well as using a more tightly focusing lens for recording.
但是,薄膜的像素密度会由于通造更小的阵列间距和更小的晶须尺寸以及使用更精密的聚焦透镜等直接降低。
Density is a logarithmic unit that describes the ratio between light hitting the film and light being transmitted through the film.
密度是一个对数单位,介绍了光线击中通过电影传播电影和光线之间的比例。
A survey to make high density multilayer thick film surface mount assembly and measures adopted for mount design and manufacturing technology for them are introduced.
介绍了研制大面积高密度多层厚膜表面组装件的概况及组装设计与制造工艺上所采取的措施。
Objective: To test and analyze density of medical dry film varying with temperature.
目的:测试与分析医用干式胶片密度随温度的变化。
For fabrication, a thin film process of high density routing and multi-chip assembly is adopted to meet the performance and structure requirements.
在制作上,根据性能和结构要求,采用了高密度布线、多芯片组装的薄膜工艺。
The effect of ion bombardment on film packing density and moisture adsorption is examined.
研究了离子轰击对薄膜聚集密度和潮气吸附的影响。
According to the comparison of several impervious films, the dependability and application of high density polyethylene (HDPE) film at city waste sanitary landfill were expounded in this paper.
通过对几种防渗膜的性质比较,阐述了高密度聚乙烯(HDPE)膜用于城市生活垃圾填埋场的可靠性及应用情况。
The Numatics Actuator Group hole punch Cylinder is perfect for punching holes in LLDPE (Linear Density Polyethylene) film.
纽曼帝克集团的执行机构气缸孔打孔机非常适合在LLDPE冲压洞(线性低密度聚乙烯)薄膜。
The principle of gold imitated coloring, effects of electric current density and properties of coloring film were discussed.
探讨了该工艺的着色原理、电流密度的影响及所得着色膜层的性能。
When the conditions of the roll forming process well controlled, the film of batter plasticity, homogeneity, density and smoothness can be acquired.
通过调整影响轧膜成型的条件,可以制得具有良好可塑性、均匀度、致密度、光洁度的薄膜。
The result also shows that the relative density decreases with either the increasing deposition or the increasing average thickness of the film.
同时发现,随入射率的增大或薄膜厚度的增加,相对密度均逐渐减小。
The quality of film is affected by many factors among which current density is the most important one.
其镀层质量受诸多因素的影响,其中电流密度是影响镀层质量重要因素之一。
The film thickness dependence of island density shows that a maximum of island density appears at the critical film thickness for both substrates.
岛面密度与膜厚的依赖关系表明,在临界厚度时硅衬底和玻璃衬底上的岛面密度均出现了极大值。
The effect of ion beam flux density and the temperature of Si substrate on the properties of the film was investigated.
考察了离子束流密度和基底温度对薄膜性能的影响。
As power is the critical equipment of micro oxidation technology, its parameters, such as voltage, current density, pulse frequency, have a very important impact on the quality of the film.
作为实现微弧氧化技术关键的电源设备,其电参数,如电压、电流密度、脉冲频率、脉冲占空比等参数对膜层的质量有着极其重要的影响。
Results image contrast and film image density is quickly adjusted by mechanism of automatic exposure control to optimize imaging.
结果自动曝光控制机构迅速调整对比度和胶片影像密度,使成像结果最佳。
Making explosive network by vacuum film plating is a new technology, from which explosive network with uniform density and easily controlled thickness can be made.
应用真空镀膜技术制作出的爆炸网络其密度比较均匀,膜层的厚度比较容易控制;
Oxide film in the expected tone of such color can be obtained by controlling current density, square—wave cycle period and number of the repetition cycles.
通过调节电流密度,方波周期和通电次数等可获得预期色调的着色膜。
Designed for punching holes in LLDPE (Linear Low Density Polyethylene) film.
冲压设计在LLDPE洞(线性低密度聚乙烯)薄膜。
Methods: to employ an electrothermal drier as a heat source and measure density of grey scale in film with a densitometer.
方法:使用电热干燥箱作热源,用密度计测量胶片上各级灰阶的密度。
The results showed that plasma treatment would etch film surface, which would affect the roughness of film surface and the density of grafted ammonia group.
结果表明,氨等离子处理会对膜表面产生一定的刻蚀作用,从而影响膜表面的粗糙度及氨基接枝密度;
The growth and property of oxidized film are restricted by various factors such as tank liquor temperature, sustained oxidation time, alloy composition, current density and sulphuric acid density.
而氧化膜的生长和性能要受到槽液温度、持续氧化时间、合金成分、电流密度、硫酸浓度等多种因素的制约。
Method: Three different exposure conditions were used and the density of CT radiographs obtained was measured and compared with traditional screen film image.
方法:选择三组不同曝光条件照射、制定标准测试点通过仪器对影像密度测试,并与普通屏—片进行对照、综合评价。
In this paper, we analyses the relation between the density of black-white film and the color of a pseudocolor image as the results of our experiments.
本文分析了在黑白图象假彩色编码中的密度与彩色的对应关系。
In the present paper, the relation between diamond nucleation density and synthesis conditions is studied for the diamond thin film synthesized by hot filament chemical vapour deposition method.
本文研究了用热灯丝化学气相沉积方法在单晶硅衬底上制备金刚石薄膜时其成核密度与制备条件的关系。
In the present paper, the relation between diamond nucleation density and synthesis conditions is studied for the diamond thin film synthesized by hot filament chemical vapour deposition method.
本文研究了用热灯丝化学气相沉积方法在单晶硅衬底上制备金刚石薄膜时其成核密度与制备条件的关系。
应用推荐