The film thickness distribution outside a horizontal test tube was measured with a film-thickness meter, to obtain the average thickness.
采用智能化薄膜厚度测试仪对水平管外液膜流动状态进行了研究，得到液膜厚度的几率分布和平均厚度。
The axes are comprised of a generalized homologous temperature, the normalized kinetic energy flux, and the net film thickness.
坐标轴包括广义同系温度，标量化动能以及净膜厚度。
Fluorescent film thickness tester deviation, or test method error.
荧光膜厚测试仪偏离，或测试方法错误。
As the film thickness increases with temperature and time, cracks appear and further oxidation of aluminium alloys is possible.
作为膜厚度随温度和时间、裂缝的出现和进一步氧化铝合金是可能的。
The controlled speed determines film thickness and overall coating efficiency, and its surface finish determines the texture of the coating.
速度的控制决定薄膜的厚度和整体涂布的效率，并且表面的光滑决定涂层的手感。
Current density: unit under the plating area under current, usually the higher current density film thickness is thicker, but is high coating will scorched thick dry.
电流密度：单位电镀面积下所承受的电流，通常电流密度越高膜厚越厚，但是过高时镀层会烧焦粗燥。
Wet film thickness gauges may be used during coating to ensure correct coating thickness.
在涂敷时应采用湿膜测厚仪以确定准确的涂层厚度。
It achieves corrosion resistance at low film thickness.
较低的膜厚具有良好的防腐蚀性。
A value related to the hiding power of a coating. The ratio of reflectance of the coating over black and white backgrounds at equal film thickness.
同涂层遮盖力相关的一个数值，以相同的涂层的厚度在黑色和白色背景下涂层反射系数的比值。
A theoretical formula for computing the film thickness in line contact EHL problems is derived.
给出了一种线接触弹流问题中油膜厚度的理论计算公式。
The mass transfer equation was introduced into heat transfer model of falling film evaporation. The radial velocity, mass diffusion coefficient and variation of film thickness were taken into account.
将传质方程引入到垂直管降膜蒸发传热模型中，求解时考虑了径向速度、质量扩散系数和膜厚变化对传热的影响。
The results indicated that the sealing parameters changed remarkably near the opening critical film thickness in the start up process.
研究表明，启动过程中，密封的特性参数在开启临界气膜厚度附近快速变化；
The results show that there are obvious changes at film pressure distribution, maximum film pressure, film thickness distribution and minimum film thickness when there is misalignment.
计算结果表明，轴颈倾斜时，轴承油膜压力分布、最大油膜压力、油膜厚度分布和最小油膜厚度等都有明显的变化。
With the hypothesis of critical gas film thickness, a criterion for expressing the opening behavior of DGS, namely the critical opening rotational speed (CORS), was proposed.
根据开启临界气膜厚度的假设，提出了用于分析干式气体密封开启性能的判据——开启临界转速。
In this paper, a probe of vacuum microbalance to monitor and measure for high accuracy of film thickness is introduced, thermostatic probe of the semiconductor refrigeration device.
本文研制了一种用于高精度膜厚监测的真空微量天平探头：半导体致冷器件恒温探头。
The quantity conditions of film thickness and refractive index control were acquired. The basic facture technics of branched PMPS waveguide circuit was established.
实验归纳了支化聚甲基苯基硅烷薄膜的光折变规律，获得了控制薄膜厚度和折射率的定量条件。
It can measure the oil film thickness, oil temperature, crank Angle, speed, journal center locus and minimum oil film thickness of main bearing in diesel engine.
该系统可测量内燃机主轴承的油膜厚度、油膜温度、曲轴转角、转速、轴心轨迹和最小油膜厚度。
It also represents the influences of aluminum film thickness on blazed efficiencies of the ruling diffraction gratings and provides proper ranges of the thickness factors.
实验研究了铝膜厚度对衍射光栅闪耀效率的影响，给出了铝膜厚度系数的最佳范围。
Electroplating uneven thickness: refers to the actual plating out when the film thickness in high and low, or uneven distribution.
电镀厚度不均：指实际镀出膜厚时高时低，或分布不均。
Electroplating position: in a location in the plating liquid, and the relative position of the anode, can affect the film thickness distribution.
电镀位置：镀件在药水中位置，与阳极相对位置，会影响膜厚分布。
Care should be taken that uniform film thickness is obtained.
注意得到正确均匀的膜厚。
The film thickness is directly proportional to the resistance of the deposited coating.
涂膜的厚度直接与沉积涂层的电阻成正比关系。
One millionth of a meter. Used to express applied film thickness.
一个百万分之一米。用于表述涂层的厚度。
By this model, the effects of adsorption time, concentration of chloroform in drinking water and film thickness on the adsorption efficiency were discussed.
应用此模型研究了萃取时间、水样中氯仿的本底质量浓度和高效有机吸附膜厚度等对萃取效率的影响。
When the anodization time extended, the pore diameters decreased, while the film thickness increased, but the increase tendency was more and more slower.
随着氧化时间的延长，多孔氧化铝薄膜的孔径逐渐减小，膜厚逐渐增加，但是增加的速度越来越慢。
Finally, the key design parameters of coating system was obtained, this system can meet ITRS requirements on uniformity of film thickness.
最后给出了镀膜系统的关键设计参数，此镀膜系统能够满足ITRS关于膜厚均匀性的要求。
It has shown that the film thickness can be controlled by adjustment of voltage and time.
试验结果表明：通过调节电泳电压和电泳时间，可以控制膜厚。
With decreasing the film thickness, the maximum absorptance appears.
随着薄膜厚度减小，吸收率具有极大值。
Conservation of mass, momentum, and energy are used to solve for the liquid film thickness, velocity, and temperature.
通过求解质量守恒、动量守恒、能量守恒方程，获得液膜厚度、速度与温度等参数。
Conservation of mass, momentum, and energy are used to solve for the liquid film thickness, velocity, and temperature.
通过求解质量守恒、动量守恒、能量守恒方程，获得液膜厚度、速度与温度等参数。
应用推荐