The control device (30) controls the voltage-up converter (12) using a feedback voltage control value.
控制设备(30)使用反馈电压控制值来控制升压转换器(12)。
It has the welding current feedback circuit and the welding voltage feedback circuit.
具有焊接电流反馈控制电路及焊接电压反馈控制电路。
Repetitive control is used to reduce voltage distortion under nonlinear loads and instantaneous feedback control is designed to quicken the dynamic response process under abrupt load variation.
系统利用重复控制抑制非线性负载下的电压畸变，利用瞬时值反馈控制加快负载突变时的动态响应过程。
The control system utilizes a sliding mode observer for the generation of all controller feedback information by means of non-speed information, such as voltage, current and parameters of motor.
利用非速度信息，如：电机的电压、电流及电机本身参数，通过滑模观测器产生控制器所需的速度反馈信息。
Cut off power supply check signal the feedback loop is switched on, the voltage is normal or not.
切断电源检查信号反馈回路是否接通，电压是否正常。
Adopt IGBT frequency conversion of German Siemens and voltage feedback series resonance circuit. The conversion efficiency is reaching up to above 97.5%.
采用德国西门子IGBT变频，电压反馈串联谐振电路。变换效率高达97.5%以上。
The effects and problems of using active voltage feedback method to suppress the RAM are researched.
研究了利用主动电压反馈抑制剩余幅度调制的实际效果和存在问题。
In this paper, quantitative analyses on the effects of driving signal with different bias voltage polarity are made for double-sided driving with voltage feedback.
文章中定量分析了带有电压反馈的双边驱动信号对器件特性的影响。
This feedback being connected downstream Q1 transistor, the general behavior of this voltage supply is very sensitive to sensor impedance variation.
这个反馈被连接到下游的三极管Q1，此电源电压的特性，对阻抗的变化很敏感。
The low-voltage power line channel properties are analyzed in this paper and a decision feedback channel estimation method is proposed on condition of slow time-variant of channel.
该文分析了低压电力线信道特性，利用信道慢时变的特点提出一种适合于电力线信道的判决反馈信道估计方法。
Then based on the above analysis, we present the method of using output voltage pulse differential feedback to control chaos in the buck converter.
在此基础上提出了利用输出电压的脉冲微分反馈对这类电路系统中的混沌进行控制的方法。
The feedback configuration of this circuit should be voltage parallel negative feedback.
该电路的反馈组态应是电压并联负反馈。
It contains two pairs of wideband, high voltage, current-mode feedback amplifiers optimized for low power consumption in DSL systems.
它包含两对宽频带，高电压，电流模式反馈放大器优化的低功耗，在DSL系统。
Another kind of the voltage control mode, through the high and low voltage on motor speed control, motor feedback signal through the drive to the numerical control system feedback position control.
另一种采用电压控制方式，通过电压的高低进行电机的转速控制，电机的反馈信号通过驱动器反馈到数控系统进行位置控制。
It sets the voltage feedback parameter directly according to the regulation precision for steady state while realizes the multi-variable coordinated optimization control.
既根据稳态调节精度的要求设定电压反馈系数，又实现了多变量协调优化控制。
Using voltage feedback control, the constant power output is achieved during the flywheel discharging period.
在飞轮能量释放过程中，利用电压反馈控制，负载能获得恒定的电功率。
In the voltage correction the voltage variation of tie-line nodes is considered and is added into the traditional secondary voltage control as the feedback.
在电压校正中，考虑了区域联络线节点的电压变化，并以此作为反馈添加到传统的二级电压控制中。
A deep negative feedback operation amplifier used in band gap reference is a common source and gate folded cascade operation amplifier with a lower offset voltage and a higher gain.
该带隙电压基准源电路中的深度负反馈运算放大器为低失调、高增益的折叠型共源共栅运算放大器。
Decoupled control structure consisting of current feedback and voltage feed-forward is adopted in the inner current control loop which can track the reference current quickly.
内环电流控制器采用电流反馈和电压前馈的解耦控制策略，实现电流的快速跟踪控制；
The converter with both voltage and current feedback in this thesis not only has a lower EMI lever, but can keep the output voltage steady.
本文给出的电压、电流闭环反馈型变换器，既具有较低的电磁干扰水平，又能够保持输出电压稳定。
When in the external feedback mode, the electrometer will display the voltage across the feedback element. The unknown charge can be calculated from the following formula.
在外部反馈模式下，静电计显示反馈元件上的电压。未知电荷可以由下式计算。
The paper takes advantage of a single close-loop control method based on voltage feedback, and enables the inverter to produce steady sine waves by the digital PID adjuster designed.
本文采用电压反馈的闭环控制方式，设计完成了数字PID调节器，使逆变器输出稳定的正弦波。
The charging technique with L-C constant-current converter is adopted, and the repeated charging and discharging process of the device is controlled by voltage feedback.
研制了一种检测氧化锌避雷器阀片的重复频率充放电装置，采用L C恒流充电技术，通过电压反馈法控制充放电运行过程。
Based on forenamed knowledge, the paper designs a double-loop NPID excitation controller, which has parallel feedback of voltage and error of rotate-speed.
在上述基础上，本文设计了一个具有机端电压反馈和转速偏差反馈的双环非线性PID控制器。
Using both feedforward and feedback control techniques, the scheme realizes well control for output current of voltage-source inverter.
通过前馈与反馈控制技术，该方案实现了对系统输出电流的良好跟踪和简单控制。
Using the concept of virtual short circuit and virtual open circuit, the voltage gain of depth negative feedback circuit can be estimated.
利用“虚短”和“虚断”的概念来估算深度负反馈电路的电压增益。
The determinant method of feedback, such as positive feedback and negative feedback, voltage feedback and current feedback, series feedback and parallel feedback, etc.
本文对模拟电子技术课程中有关“反馈”的判别方法，诸如正、负反馈，电压、电流反馈以及串联、并联反馈等做了详细的分析比较。
The determinant method of feedback, such as positive feedback and negative feedback, voltage feedback and current feedback, series feedback and parallel feedback, etc.
本文对模拟电子技术课程中有关“反馈”的判别方法，诸如正、负反馈，电压、电流反馈以及串联、并联反馈等做了详细的分析比较。
应用推荐