Through simulating measured values, the measured distance of zero fault resistance can be estimated.
通过对测量值的线性拟合，能估计出过渡电阻为零时的测量距离。
The algorithm does not need fault type identification, and is not affected by the fault resistance and pre-fault load.
算法不受故障类型、故障电阻、系统阻抗、负荷电流的影响。
One of the critical problems that need to be solved by a ground distance relay is to improve the capacity of the earth-fault resistance endurance of the relay.
接地距离继电器要解决的关键问题之一是提高其耐受过渡电阻的能力。
The location result is not influenced by fault resistance and inception Angle when wavelet transform coefficient of aerial mode current is used in fault location.
利用线模电流的小波变换系数进行测距，不仅不受故障电阻的影响，也不受故障起始角的影响。
Using one-terminal data, the algorithm analyzes fault network by sequence networks method and get the formula of fault location, eliminating the effect of fault resistance.
该算法利用序网络分解法对故障网络进行分析，得到基于单端电气量故障距离一般表达式，该算法消除了故障电阻的影响。
The algorithm does not need fault type identification, and its accuracy is not affected by fault resistance, system impedance, pre-fault load current and shunt capacitance.
算法无需故障类型判别，不受系统阻抗、故障电阻、负荷电流以及分布电容的影响。
The traveling wave fault location has high reliability accuracy and anti-disturbance capability , and it also immunes from the fault resistance and the neutral grounding modes.
行波测距法具有较高的可靠性和精度，抗干扰能力强，且不受故障电阻及系统运行方式的影响。
Augmenting the architecture of Enterprise Web 2.0 with manageability attributes adds configurability, fault resistance, the ability to measure performance, security enforcement, and more.
为EnterpriseWeb 2.0体系结构增加可管理性属性，这样做可以添加可配置性、抗故障能力、性能度量能力、安全强制，以及其他更多功能。
Commonly, by opening one switch and closing the other, two group equations are set up to measure rotor earth-fault resistance in the rotor earth-fault protection with switch sampling principle.
切换采样转子一点接地保护，通过两个静态开关一开一合建立两组方程来求解接地电阻与位置。
The influences of several factors such as harmonics, intermittent arc grounding, ct, load and fault resistance have been thoroughly analyzed, therefore, it is fundamental work for its application.
深入细致地分析了谐波、间歇电弧、电流互感器、负荷、过渡电阻等多个因素对故障选线结果的影响，为方案的实用化奠定了基础。
Because the impedance fault location method is easily influenced by the factor such as fault resistance, transformer error and asymmetrical line configuration, the fault location accuracy is lower.
由于阻抗法易受过渡电阻、互感器误差、线路结构不对称等因素的影响，所以测距精度不高。
The location results are always affected by fault resistance in almost all conventional impedance methods in fault location, but the application of power balance theory can overcome the shortcoming.
利用功率平衡理论进行故障测距能够在原理上克服传统阻抗法普遍存在的受故障电阻影响的缺陷。
The necessity of low resistance ground system and its fault characteristic were analyzed.
分析了采用小电阻接地系统的必要性及该系统的故障特性。
The sensation of resistance coincide with a particular fault in the distribution of contraction in the musculature.
阻力感与肌肉收缩的分布上的一个特别的错误同时发生。
In addition to pointing out some experienced formulas abroad for taking count of the resistance of the fault itself and its typical data.
对故障点的过渡电阻还列出一些国外的经验计算式及其典型数据，这对校验保护装置灵敏度是十分必要的。
The traditional fault location method based on impedance can not overcome the effects of transition resistance, etc.
传统的阻抗法进行故障定位，难以克服过渡电阻等因素的影响。
The program realized displaying real time curve and history curve of cell signals, querying history report, spectrum analysis of cell resistance and fault diagnosis for the cell state.
实现了槽信号的实时曲线和历史显示，历史报表查询，槽电阻频谱分析和神经网络故障诊断功能。
It is immune from the unbalanced status of network and the values of earthed resistance. To the complicated intermittent arc-earth fault, the proposed method also works well.
该方法不受电网平衡情况和接地电阻大小的影响，对复杂的间歇性电弧接地故障同样有效。
The sensitivity of the proposed protection scheme is not impacted by the factors such as transition resistance, lightning stroke, fault type, load current and operating mode of power system.
该保护方案的灵敏度不受过渡电阻、雷击、故障类型、负荷电流、系统运行方式等因素的影响。
But under fault condition, the system current is greater than the current of equivalent AC current source and the limiting resistance take effect immediately.
故障后，系统电流值远大于等效交流电流源值，限流电阻立刻自动投入限流。
The heat fault of electrical contact, which results in the increase of contact resistance , can be caused by various origins.
引起电接点热故障原因多种多样，最终都导致接触电阻增加。
The dynamic characteristic of the relay increases its tolerance to fault arcing resistance and it can be used on transmission lines with capacitance compensation.
该继电器具有保护弧光电阻及适用于带串联补偿电容线路的正、反向动态特性曲线。
The limiting resistance in SFCL and the fault detection time impact on peak value of fault current, line voltage of feeders without fault and voltage across SFCL are analysed.
给出了超导限流器的数学模型，着重分析了超导限流器限流电阻和故障检测时间对短路电流峰值、非故障线电压、超导限流器上的电压的影响。
They provide system security and immediate reliable low level ground fault detection on three-phase AC resistance grounded or grounded electrical distribution systems.
此类继电器能够增加系统安全性，并对三相交流接地电阻或接地配电系统进行可靠的低级接地故障检测。
Some application examples in practice showed that this system is adaptive and effective to can-body resistance welding machine, thus useful for fault diagnosis of can-body resistance wel…
运行实践表明，该系统知识模型适应性好，推理结果基本符合实际情况，有助于罐身电阻焊机的远程快速故障诊断。
Then it introduces the rotor earth fault monitoring based on the method of resistance bridge with source, and the interturn short circuit fault monitoring in generator rotor based on stator coil.
随后介绍采用基于有源电阻电桥进行转子接地短路故障监测与采用微分探测法进行转子匝间短路故障信号。
Research on intelligent measurement of small electric resistance belong to the field of condition monitoring and fault diagnosis on electric power equipment.
微小电阻智能测试研究属于电力设备状态监测及故障诊断技术研究领域。
Arcing fault often happens on HV transmission line. Its transient resistance is usually assumed as a linear constant resistance in most of the locating algorithms.
电弧故障是高压输电线路的多发故障，目前众多故障定位算法大多数把故障过渡电阻视为线性定常电阻。
Arcing fault often happens on HV transmission line. Its transient resistance is usually assumed as a linear constant resistance in most of the locating algorithms.
电弧故障是高压输电线路的多发故障，目前众多故障定位算法大多数把故障过渡电阻视为线性定常电阻。
应用推荐