The variation of slope angle has a significant impact on failure surface.
锚板埋深比越大，斜坡倾角的影响也越显著。
The strength failure surface would be expanded as the increasing of structure parameter.
随着结构性的增大，强度破坏面逐渐向外扩展。
An elliptic paraboloid is proposed as the failure surface for concrete under multiaxial Stresses.
本文用椭圆抛物面作为混凝土三向应力时的强度破坏面。
Failure surface shape of pile tip and ultimate tip resistance was obtained according to Mohr-Column failure criteria.
根据莫尔-库仑破坏准则得出了桩端的破坏面形状以及极限端阻力。
For the rock slope with planar failure surface, the structural plane plays a controlling role in the stability of slope.
对于平面滑动型的岩质边坡，结构面对边坡的稳定性起着控制作用。
We get the form and position of failure surface, and then calculate factor of safety with general limit equilibrium method.
确定了滑动面的位置和形式，然后用刚体极限平衡法计算安全系数。
For locating the critical failure surface, the particle swarm or the harmony method is used, which is an upper bound approach.
而搜索临界滑裂面的过程，采用粒子群法或和声法搜索最危险滑动面。
The two calculating methods are compared and impact factors on the critical Angle of second failure surface are analyzed by case studies.
通过算例对两种算法进行对比并分析第二破裂面临界角影响因素。
This paper researches the failure surface modes of displaced soil mass in front of anchor plate by tests, meanwhile analyses the earth resistance.
利用试验观测锚碇板前置换土体破裂面形态，并对其抗力进行分析。
For Laxiwa granite failure surface under various stress states, the microtest has been carried out to study the microfailure character and its mechanism.
对拉西瓦花岗岩在各种受力情况下岩石破坏断口，进行了微观扫描电镜试验研究，分析了岩石微观破坏形貌特征和微观破坏力学机制。
The ground pressure distribution and the shape of failure surface by conducting model tests for the cylindrical retaining wall of a shaft in cohesionless soils are discussed.
讨论了无黏性土中圆柱型挡土墙的模型试验，给出土压力的分布和破坏面形状。
A simple formula for calculating pure shear strength of concrete is derived on the basis of the verified mathematical model of concrete failure surface, the elliptic paraboloid.
本文根据已论证过的混凝土破坏面，即椭圆抛物面的数学模型，报导出一个用以计算混凝土纯剪强度的简单公式。
Because the objective function of the safety of factor is nonconvex, multi-variable, and existing many minimums, searching the most dangerous failure surface usually is difficult.
由于安全系数的目标函数是非凸的、多变量的并且存在多个极小值，所以一般边坡最危险滑弧的搜索是困难的。
The position of the geotechnical failure surface is relative to the failure criteria, and different positions and relevant shear strengths can be got by using different failure criteria.
岩土空间破坏面位置的确定与计算所选用的破坏准则有关，运用不同的破坏准则得到的土体的破坏面位置及相应抗剪强度也不同。
There are lots of discontinuities whose geometry exhibits a random behavior in rock excavated slopes, and the failure surface of the slope is normally consisted of the joints and rock-bridges.
岩石边坡开挖中存在大量的随机结构面，结构面与岩桥的组合破坏是边坡破坏的一种重要形式。
Sequential images of the deformation field under a model footing were digitally recorded. The DPDM technique was used to achieve the incremental displacement field and the slip failure surface.
基础荷载作用下的地基变形场用连续的数码相片记录，然后用数字照相变形量测技术分析得到地基的增量变形场和地基的破坏面。
Through hardness test, impacting test, SEM of failure surface and microstructure observation, the relationship between the toughness and its microstructure of welding joint of T92 steel was studied.
通过硬度试验、冲击试验、断口扫描和金相组织观察，研究了T92钢焊接接头的韧性与组织的关系。
For cantilevered anti-slide pile, displacement of pile increase continuously with time, the topper displacement is max. The failure envelope is nearby design failure surface when load achieve extreme.
对悬臂式抗滑桩，桩身位移随时间的延长不断增大，桩顶位移最大，加载至桩破坏时，其破坏面在拟滑面附近；
On the surface, you can call it the fear of failure!
在表面上看，你可以称之为害怕失败！
Nevertheless, if the Chilean fault surface were close to failure, those small waves could push it even closer.
虽然如此，如果智利的断层面接近崩溃，那些微波可能会促使它更快崩溃。
First of all, the surface from the beginning of failure, and then go.
首先从故障的表面现象开始，然后再深入下去。
The reason of the failure of epoxy bonded joint in water was that the epoxy adhesive on the metal surface was substituted for water.
环氧胶接接头在水中破坏失效的原因主要是渗入到胶接层的水分子取代了胶粘剂分子在金属表面的粘附。
The temperature rise of electrical insulation, other than that of windings, is determined on the surface of the insulation at places where failure could cause.
除绕组绝缘温升外，其他电气绝缘的温升是在其绝缘体的表面上来确定，其位置是可能引起下列故障的位置。
So there is a lot of wind is not hot, such as too much dust on the surface of the heater, PTC ceramic chip failure, voltage failure and so on can cause the wind is not hot.
出风不热的情况有很多，例如加热器表面灰尘过多、PT C陶瓷片故障、电压故障等等原因都能造成出风不热的情况。
This will lead to roll failure such as fire crack, surface crack, and fatigue failure.
这将会导致轧辊疲劳产生热裂、轧辊表面破裂或是疲劳层的产生。
Failure: Pitting, cratering, or erosion of the surface. Obvious and significant deterioration.
失败：表面出现斑痕、凹或侵蚀，明显且重要的材料损毁。
This paper analyzes gear failure resulted by damage of teeth surface and puts forward some methods improving touch strength of gear.
对齿轮齿面损坏造成的齿轮失效进行了分析，并提出了一些提高齿轮接触强度的方法。
The main reason for tyre peeling consists in fatigue failure during surface contacting, and the remedial measure to tyre peeling consists mainly in welding on site.
轮带发生剥落掉块的原因主要是表面接触疲劳破坏，处理剥落掉块的方法主要是现场焊接。
The main reason for tyre peeling consists in fatigue failure during surface contacting, and the remedial measure to tyre peeling consists mainly in welding on site.
轮带发生剥落掉块的原因主要是表面接触疲劳破坏，处理剥落掉块的方法主要是现场焊接。
应用推荐