Experimental and numerical study on a small swirl atomizer with complex structure was conducted.
对一种小尺寸复杂结构的旋流式喷嘴进行了实验和数值研究。
Experimental and numerical studies on smoke movement and control in subway stations are presented.
介绍了地铁站内烟气流动和控制的试验和数值研究。
Our results were compared with experimental and numerical results, and it shows that our results are reasonable.
并将上述成果与国内外的实验、数值计算的成果进行了对比。
The experimental and numerical results are compared and analyzed, and prove the validity of numerical simulation.
对实验与理论结果作了比较分析，证明了数值模拟的正确性。
This paper briefly describes a kind of hybrid method combining the experimental and numerical techniques for structural analysis.
本文简要地介绍一种结构分析的实验和数值相结合的混合解法。
The structures of unsteady cavitating flows around a blunt axisymmetric body were investigated by the experimental and numerical methods.
本文采用实验与数值模拟相结合的方法对绕平头回转体的空化流场进行了研究。
In this paper, the experimental and numerical investigations on electro-magnetic control of cylinder wake have been performed in this paper.
本文对均匀来流和剪切来流条件下，圆柱绕流及其电磁控制进行了实验和数值研究。
The contact stress distribution in the rabbet of the aircraft engine blade was determined by combining the experimental and numerical methods.
文中将实验检测技术与数值计算方法相结合，求解飞机发动机叶片榫头上的接触应力分布。
The experimental and numerical results indicate that the structure of the tower crane meets the demands of design in both strength and stability.
试验与计算的结果均表明该抱杆结构满足强度与稳定性设计要求，吊装过程中抱杆不会发生破坏。
Theoretical analysis on the Taylor impact of five practical materials shows that the analytic results are in agreement with the experimental and numerical.
利用该理论对五种具体材料进行分析，结果表明，解析结果与试验结果及数值分析结果吻合较好。
In large aluminum alloy forgings, the change of inside metallurgical defects and the strain fields have been studied by experimental and numerical simulation.
针对大型铝合金件的锻造过程，采用实验与计算机模拟相结合的办法，分别对锻件内部冶金缺陷的变化及其应变场进行了分析。
Non linear surface heat transfer coefficient is obtained by experimental and numerical methods and the CCT diagram is simulated by mathematical transformation.
用实验和数值计算相结合的方法，得到半圆柱壳体快速冷却过程中内外表面的非线性表面换热系数。
Experimental and numerical results show that the mechanisms of crack coalescence is controlled by the geometric setting of the flaws and the confining pressure.
结果清楚显示裂纹贯通机制主要受加载条件与预置裂纹几何分布的影响。
In order to investigate the resistance characteristics of flap gate, the experimental and numerical simulation studies of resistance loss of flap gate were performed.
采用数值模拟与模型试验相结合的方法对模型泵装置出口拍门的阻力损失进行研究。
On the basis of detecting impact load, studies are carried on regulation of stress wave propagation in one-dimensional rock mass by experimental and numerical simulation.
在测定撞击载荷形式的基础上，通过试验研究应力波在一维节理岩体中的传播规律。
With the development of computational fluid dynamics (CFD) and computer technology, the experimental and numerical researches about ship wake-waves have made some progress.
随着船舶计算流体力学（CFD）和计算机技术的飞速发展，船舶尾浪的试验与数值研究已经取得一定的进展。
Circular cylinder oscillating in water at rest is simulated to validate the model and the result compared with experimental and numerical simulation data is in good agreement.
为验证模型的可靠性，对静水中的振荡圆柱流场进行模拟，与实验及数值计算结果吻合较好。
Through experimental and numerical simulation researches on the influence of cooling wall on the ventilation characteristics and the air flow characteristics of UFAD system firstly.
首次通过实验和数值模拟方法研究了具有冷却壁面条件时的下送风通风空调系统的气流流动特性及其影响。
This paper presents the parametric equations on stress concentration factor(SCF) of completely overlapped tubular joints under axial loading using experimental and numerical analysis.
通过试验和数值研究推导了完全叠接管节点试件在轴向力作用下应力集中因子的参数方程。
Comparisons show that the experimental and numerical results are in good agreement, and the numerical model can be used to simulate the wave generation due to the submarine rock falling.
研究表明，数值结果和实验结果比对良好，这种基于势流函数理论的数值模型能够有效模拟水中岩石坠落激发表面波的生成过程。
In order to determine the proper ratio of center charge with propylene oxide fuel (RCF) and ignition delay time, corresponding experimental and numerical studies on fuel dispersal are carried out.
为了合理确定液体燃料环氧丙烷爆炸抛散比药量及点火延迟时间，进行了相关的实验与数值模拟研究。
Finally, the mechanism of crack resistance and strength reinforcement was discussed based on the experimental and numerical analysis. Also a hybrid effect factor formula was suggested in this paper.
最后，本文在试验研究与数值模拟分析的基础上，探讨混合纤维的阻裂和增强机理，提出了本文建议的混合效应系数计算公式。
The static stress wall resulting from the inner pressure was simulated by applying a stress boundary along the inner wall. A better correlation between experimental and numerical results was obtained.
在建模过程中通过对容器壁内侧施加压力边界条件来模拟由于内充气体的作用在容器壁内产生的应力场，并通过与试验结果的比较验证了数值模拟方法的有效性。
While very practical, this research is also quite technical in that the experimental data will be compared to numerical simulations, small-scale experiments and published theoretical models.
同时非常实际的，这一研究也很具有科技性，实验数据将被和数字仿真，小比例实验和出版的理论模型相对比。
The computation results using the models in this thesis are compared with experimental data and other numerical results.
利用本文数值模型的计算结果与他人的数值结果和试验结果进行了比较。
In view of dispersion, the application of guided wave NDT of pipe based on magnetostrictive effect was analyzed by the combination of numerical simulation and experimental research.
利用数值模拟和实验研究两种手段，从频散的角度分析了基于磁致伸缩效应的导波无损检测技术在圆管检测中的应用。
Furthermore, the research approaches were also given by using numerical simulation method and experimental simulation method.
还提出采用数值模拟与实验模拟相结合对该模型进行求解的研究思路。
Characteristics of wave propagation in grouted rockbolt were investigated with numerical simulation, experimental measurement and theoretical analysis.
用理论分析、数值模拟和实验测试的方法研究了自由锚杆和锚固锚杆中的波传播特性。
The exact solutions are analytical physical solutions and can be served as accuracy checks for experimental, numerical and asymptotic methods.
这些精确解为实验，数值以及渐近解的检验提供了借鉴和参考。
In the thesis, we carried through numerical simulation and experimental study of the stretching process of float glass.
本文对浮法玻璃拉边过程进行了数值模拟和实验研究。
应用推荐