An elastic rotorbearing system with coupling faults of crack and rubimpact was studied on the basis of nonlinear dynamics and rotor dynamics.
研究了带有裂纹和碰摩耦合故障的弹性转子系统的复杂运动。
The effects of rotor speed, draft ratio and twist factor on the properties of elastic rotor-spun yarns were investigated, and the technology optimizing was done through the orthogonal test.
分析了转杯速度、牵伸倍数、捻系数对弹性转杯纱性能的影响，并通过正交试验对工艺参数进行了优化。
The rotating system of CT machine is simplified into a rigid rotor system. There exist clearances between the stator and the elastic support.
将全身CT机的机械回转系统简化成一个刚性转子系统，该系统的静子与支承之间存在间隙。
External elastic damping support, if designed reasonably, may obviously improve the natural or forced vibration response characteristics of bearing rotor systems.
设计参数合理的外弹性阻尼支承可以明显改善轴承-转子系统的固有特性及强迫振动响应。
First, the calculation boundary was determined according to the linkage mode of the rotor, then its elastic, thermoelastic and thermal stress analyses were made.
首先根据转子系统的连接方式确定了涡轮盘应力计算边界条件，然后对该涡轮盘进行了热弹性、弹性应力和热应力分析。
Non-linear dynamics characters of a rotor system for an elastic shaft-disk with a crack are examined by introducing the geometric non-linearity and equivalent line-spring model.
本文引入了几何非线性关系和等效线弹簧模型对含裂纹的弹性轴弹性盘转子系统进行非线性动力学分析。
With reference to a symmetrical unbalanced rotor treated as a continuous elastic shaft suPPorted at its end by lubricated journal bearings, the short bearing model is adoPted.
研究了非线性弹性转子-轴承系统的轴心轨迹，认为对称不平衡转子是连续弹性轴，它两端支撑在滑动轴承上，油膜反力采用非线性短轴承模型。
A contrast experiment for the spiral bevel gears was carried out on a rotor test facility with elastic supports.
在转子系统模拟试验台上，对发动机主传动锥齿轮接触性能进行了实验研究。
A contrast experiment for the spiral bevel gears was carried out on a rotor test facility with elastic supports.
在转子系统模拟试验台上，对发动机主传动锥齿轮接触性能进行了实验研究。
应用推荐