And also effect of spinneret draw-ratio on fibre aggregated structure and the properties was discussed.
分析喷丝头拉伸比对纤维的聚集态结构及性能的影响。
The CruiseControl Web application can draw graphs of important build statistics, such as the ratio of successful builds to failed builds.
CruiseControlWeb应用程序可以绘制重要的构建统计图，例如成功构建与失败构建的比例。
The practical experiments showed that fiber spinnability was optimized when spinneret negative draw ratio was - 73 %.
工业化试验表明：当喷丝头负拉伸率为- 73%时，纤维可纺性达到最佳状态。
Methods to perform the statistical analysis on the data of 2000 to 2005, and to draw the line graph to view the trend of unqualified constitute ratio.
方法统计2000 ~ 2005年的检测资料，绘制折线图直观显示各项目不合格构成比变化趋势。
The diameter, flow, shear rate, draw ratio, pressure difference and degree of profile in different configuration of capillary hole were calculated.
计算不同叶长，叶宽，孔数的喷丝板毛细孔的当量直径，单孔流量，剪切速率，喷头拉伸比，三叶异形孔压力降和异形度。
Assemble model can draw components of retrieval system precisely, it can also be used to account recall ratio, and precision ratio.
集合模型能够精确地描述检索系统的构成，还可以用来计算检索的查全率和查准率。
The longitudinal yield strength and the Young′s modulus increase with the draw ratio.
纵向屈服强度和模量随拉伸比增加而提高。
Many resolution ratio model surface simplify algorithm come with one simple model approximate to say the primitive high-resolution model, reduce polygon that model show count, accelerate scene draw.
多分辨率模型表面简化算法用一简单的模型来近似表示原始的高分辨率模型，减少模型表示的多边形数，从而加速场景绘制。
In addition, high draw ratio will increase the melting point and crystallization rate of the soft segments for both types of segmented copolymers.
此外，高倍拉伸会提高上述二类多嵌段共聚物中软链段结晶的熔点和结晶速率。
The goal of Super-resolution restoration is to draw a high-resolution image from a low-resolution ratio image array.
图像超分辨率复原的目的是从一个低分辨率图像序列中提取一幅高分辨率图像。
Magnetization of the fibers reduced with increasing of draw ratio and core-sheath ratio of the fibers.
随着纤维的皮芯比的增加和拉伸倍数的提高，纤维的磁感应强度下降。
With the draw ratio of aviation kerosene as the optimization objective, off-line operating optimization has been done by the plant model of process simulation.
利用流程模拟得到的装置模型，对常压塔常一线航煤进行离线操作优化，达到航煤产量最大化的目标。
While polyester fiber is subject to different draw ratio and heating temperature during high speed spinning, its original molecular orientation and crystallinity of polyester fiber are changed.
聚酯在高速纺丝过程中，施以不同的拉伸倍数与温度，会造成纤维结晶度与取向度的变化，从而影响纤维的物理性能。
Using NaSCN as solvent, acrylic fiber was produced by one-step wet spinning process. The effect of spinneret negative draw ratio on fiber formation was discussed.
采用硫氰酸钠为溶剂，湿纺一步法工艺生产腈纶，探讨了喷丝头负拉伸率对纤维成形的影响。
The effects of draw-down ratio, air-layer length, drawing conditions on the structure and properties of the fiber were discussed.
探讨了喷丝头拉伸比，空气层长度，拉伸条件对纤维结构性能的影响。
The water flux ofPAN/PU hollow fiber membranes increased with the increase of draw ratio and concentration of PAN.
PU中空纤维膜的的水通量随着拉伸倍数的增大而增大，随着PAN含量的增大而增大。
The number of melting peaks was increased from 1 to 2 with the increase of draw ratio after heat treatment under relaxation and from 1 to 3 after heat treatment under partial tension or full tension.
随着拉伸倍数提高，纤维经松弛状态下热处理后，其熔融峰数目由1个变为2个；而经部分张力和张力状态下热处理后，其熔融峰数目均由1个变为3个。
The influences of formation condition and draw ratio in melt spinning on the hollowness of Circular cross section hollow polyester fiber are studied.
本文就熔融纺丝成形条件及后拉伸倍数对圆中空聚酯纤维中空度的影响进行了探讨。
The article investigated the influence of draw ratio on the physical properties of nylon-66 industrial yarn.
研究了拉伸倍数对尼龙66工业丝物理性能指标的影响。
It is found that the draw performance of IPP monofilaments is greatly promoted in the multi-stage drawing under the same spinning condition. The draw ratio approaches 25 x.
试验发现，在相同的纺丝条件下，多级拉伸大大提高了IPP单丝的拉伸性能，拉伸倍数可达25倍。
NH groups Orient too when draw ratio is beyond 80%, which indicates that it is easy for soft segments but difficult for hard segments to Orient under the effect of outside force.
当拉伸倍率大于80 %时，NH基团也发生取向，即在外力作用下，软链段较易取向，而硬链段的取向较难。
Through crossed experiment, the effects of spinning speed, draw ratio, tow temperature at DF3 exit on strength and elongation of 1.
通过正交实验分析了纺速、拉伸倍率、DF3出口处丝束温度对1。
The results showed the influence on fiber strength and elongation at break was in draw ratio, spinning speed, DF3 exit temperature order.
对断裂伸长率的影响依次为拉伸倍率、纺速、DF3出口温度。
The primary factors affecting the structure and properties of the resulted fibers during pre-oxidation included pre-oxidation temperature and time and draw ratio.
指出预氧化过程中影响纤维结构与性能变化的主要因素有预氧化温度、预氧化时间和对纤维的拉伸倍数等。
It was found that the spinnability of POM fibers was improved and the maximum draw ratio of the as-spun fibers was increased with laser heating.
结果发现，聚甲醛纤维的可纺性得到改善，作为纺纤维最大拉伸比增加激光加热。
Model BS368 Lap Draw Frame is a high efficient preparation machine for Comber, easy operation, high automation and reasonable doubling of slivers and drafting ratio.
BS368型条并卷机是高效的精梳准备设备，操作简单，自动化程度高，棉条合并数、牵伸倍数分配合理。
The drawing experimental results show that the draw ability of cast-rolled strip under composite energy field was obviously better than the general one, and the earing ratio was only 1.7%.
冲杯实验结果表明：复合能场铸轧板的深冲性能明显优于普通铝板，其制耳率仅为1.7%。
High shrinkage PET staple fiber is mainly made by the adoption of low temperature drawing, suitable reduction of draw ratio and non-setting process.
涤纶高收缩短纤维的制取，主要采用低温拉伸、适当降低拉伸倍率以及不定型工艺。
High shrinkage PET staple fiber is mainly made by the adoption of low temperature drawing, suitable reduction of draw ratio and non-setting process.
涤纶高收缩短纤维的制取，主要采用低温拉伸、适当降低拉伸倍率以及不定型工艺。
应用推荐